Answered: In an RLC circuit, L=0.1 H, R=0.6;…

In an RLC circuit, L=0.1 H, R=0.6; C=0.4F; and E(t)=60 V. Find the charge at time t. Assume the initial charge on the capaciter is 0C and the initial current is 7.5.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 80AP: In an oscillating RLC circuit, R = 7.0 L. = 10 mH. And C = 3.0 F. Initially, the capacitor has a...

See similar textbooks

Related questions

Q: Determine the current (1) in an RLC-circuit with resistance R = 80£ %3! luctance L = 10 H¸…

Q: Your RL circuit has a characteristic time constant of 20.0 ns, and an inductance of 0.150 H. • What…

Q: An AC voltage of the form v(t) = 100 sin 1000t, where v(t) is in volts and t is in seconds, is…

Q: An electrical engineer designed an RL circuit similar to the one shown in the figure, with Ɛ = 6.00…

Q: In an RLC circuit assume that R =5.00 , L =60.0 mH, fd = 60.0 Hz, and m = 30.0 V. For what valuesof…

Q: Does the time required for the current in an RL circuit to reach any fraction of its steady-state…

A: In a DC-RL-circuit, as shown in the circuit diagram below, the battery voltage is V, the resistor…

Q: If the instantaneous current of an AC is given as I(t) = 13A Sin(120Tt), then the value of the RMS…

Q: An RL circuit has an emf given (in volts) by 4 cos t, a resistance of 100 ohms, an inductance of 4…

Q: What is the maximum length in km for a 1-phase transmission line having copper conductor of 0-775…

Q: Find the steady-state current q (t) on the capacitor and the current i (t) in the given LRC-series…

A: The equation for the given LRC circuit is,…

Q: An alternating current in a circuit is given by, I = 20 sin (100 al + 0.05x)A. What is the rms value…

Q: Find the charge on the capacitor and the current in an LC-series circuit when L = 0.1 h, C = 0.1 f,…

A: GivenL = 0.1 hC = 0.1 fE(t) = 100 sinγt Vinitial conditionsq(0) = 0 Ci(0) = 0 A

Q: If the instantaneous current of an AC is given as l(t) = 13A Sin(120nt), then the value of frequency…

Q: For a physics lab assignment, a student needs to create a solenoid using copper wire with diameter d…

A: The length we get will be in meter =0.0664m We convert it into cm for our final answer.

Q: For a technical application, an electrical engineer needs to create a solenoid using copper wire…

Q: A battery is connected to a series RL circuit at time t= 0. At what multiple of tL will the current…

Q: A constant inductance of one henry and a variable resistance R are connected in series with a…

Q: How much time does it take for the current in an RL circuit withR = 130 Ω and L = 68 mH to reach…

A: Given Data: The resistance of a resistor is, R=130 Ω The inductance of an inductor is, L=68 mH The…

Q: Copper conductors can withstand one ampere (rms current) for ____ seconds for every 42.25 circular…

Q: 24. An inductance of L Henrys and a resistance of 20 ohms are connected in series with EMF of 120…

Q: In a series oscillating RLC circuit, R-20 2, C=5 mF, L-20 mH, and e-esin wr with e 45.0 V and w- 300…

A: Given Resistance R = 20 Ω Capacitance C = 5 mF = 5×10-3 F Inductance L = 20 mH = 2×10-2 H Voltage εm…

Q: In an oscillating RLC circuit, R = 5.0ohm, L = 5.0 mH, and C = 500 uF. What is the angular frequency…

Q: If the instantaneous current of an AC is given as I(t) = 13A Sin(120rt), then the value of the RMS…

A: r.m.s value of current = (1/ 2 ) maximum current Maximum current can be determined from the given…

Q: How long would it take, following the removal of the battery, for the potential difference across…

Q: Find the current at any time t > 0 for an RLC circuit with inductance 0.02 H, resistance 40 N, and…

Q: An alternating voltage given byuiAI V = 70 sin 100 nt is connected across a pure resistor of 25 Q.…

Q: If an AC source has instantaneous voltage given as V(t) = 13v Sin(120Ttt) is connected to 6.5 Q…

Q: Find the charge on the capacitor and the current in an LC-series circuit when L = 0.1 h, C = 0.1 f,…

A: Given,L=0.1 hC=0.1 FE(t)=100 sinytherew=yZ=xL-xcwherexL=wLxc=1wc

Q: How many turns of wire are there in a solenoid if a 500mA current through it produces a total flux…

Q: If the instantaneous current of an AC is given as I(t) = 13A Sin(120tt), then the value of frequency…

A: The current across a circuit is defined as the rate of flow of charge Q per unit time period t ,…

Q: Find the induced emf in the wire at time t=0? A. Zero V B. 0.5 V C. 5 V D. 0.05 V

A: Magnetic flux φ=B.A.cosθ Where B is the magnetic field,A is the area of the loop and θ is the angle…

Q: The output EMF of a generator is given by V (t) = a sin(wt), where a = 231 V. Find the rms current…

A: Given : Peak voltage (a) = 231 V and resistor (R) = 118 ohm

Q: An electromotive force S200, osts 40 E(t) lo, t> 40 is applied to an LR-series circuit in which the…

A: Applying the KVL in the circuit and solving for current.

Q: A battery is connected to a series RL circuit at time t= 0. At what multiple of t will the current…

Q: Consider an initially passive LC circuit (no resistance) with a battery supplying eo volts. (b) If L…

A: Write the circuit equation, and solve for LC circuit. The potential of the battery is e0. The switch…

Q: How many time constants T does it take for the potential difference across the resistor in an LR…

A: As given in figure when switch is moved to the upper position removing VO from the circuit then when…

Q: Consider the RL circuit shown in the figure, where R = 19.8 Q. The switch S is closed at t = 0. At t…

A: Given, R = 19.8 Ωswitch is closed at t = 0 sec, at t = 3.00 ms I = 96.3% of Io

Q: find the current in the RLC-series circuit at 1.5 sec. with L = 5/3 H, R =10 ohms, C = 1/30 F, E(t)…

A: We have a series LCR circuit with inductance L=5/3 H, resistance R=10 ohms and capacitance C=1/30 F…

Q: Find the differential equation corresponding to the following RLC circuit in fig. when L = 0.5 H, R=…

A: Given that L = 0.5 H R = 3 Ω C = 112 F E(t) = 10 sin(2t) V

Q: At what frequency will the current in a series RLC circuit reach its maximum value for an applied…

Q: For a technical application, an electrical engineer needs to create a solenoid using copper wire…

Q: A sinusoidally oscillating current I(t) with an amplitude of 4.55 A and a frequency of 879 cycles…

Q: The current in a series RL circuit increases to 20% of its final value in 3.1 ms. If L = 1.8 mH,…

A: Time t =3.1 ms=3.1×10-3 s L = 1.8 mH=1.8×10-3 H It is given that the current increases to 20% of its…

Q: What direct current will produce the same amount of thermal energy, in a particular resistor, as an…

A: The expression for the power dissipated in a resistor connected to an AC source is,

Q: suppose a conducting rod with length of 25cm is pulled along the a rotated U-shaped conductor…

Q: Find the charge on the capacitor and the current in an LC-series circuit when L = 0.1 h, C = 0.1 f,…

A: We have an AC supply of E(t)=100sin(γt) V, where γ is the frequency. The inductor of L=0.1 h and…

Concept explainers

Electromagnets

The word "electromagnet" is composed of two words, ‘electro’ and ‘magnet’. It is a type of magnet in which an electric current helps in the generation of a magnetic field. Electromagnets usually consist of two major parts, wire and a coil around which the wire is wound. This is called a solenoid. When an electric current is allowed to pass through the coiled wire, the electric current produces a magnetic field. This magnetic field is present only when current is passing through the wire.

Question

In an RLC circuit, L=0.1 H, R=0.6; C=0.4F; and E(t)=60 V. Find the charge at time t. Assume the initial charge on the capaciter is 0C and the initial current is 7.5.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Does the time required for the current in an RL circuit to reach any fraction of its steady-state value depend on the emf of the battery?
In an oscillating RLC circuit with L = 10 mH, C = 1.5 F , and R = 2.0 , how much time elapses before the amplitude of the oscillations drops to half its initial value?
For the circuit shown below, =20V , L = 4.0 mH, and R = 5.0 . After steady state is reached with S1 closed and S2 open, S2 is closed and immediately thereafter (at t = 0) S1 is opened. Determine (a) the current through L at t = 0, (b) the current through L at r = 4.0 x 10-4 s, and (c) the voltages across L and R at t = 4.0 x 10-4 s.
How long would it take, following the removal of the battery, for the potential difference across the resistor in an RL circuit (with L = 2.00 H, R = 3.00 ohm) to decay to 10.0% of its initial value?
Calculate the resistance in an RL circuit in which L = 2.50 H and the current increases to 90.0% of its final value in 3.00 s.
A series RLC circuit consist of L = 1H, C = 0.05 F and an unknown resistance R. If the applied voltage lags the current by an angle of 63.43º, find the value of R. Assume w = 4 rad/s.
In a standard RLC circuit that we are looking at R = 0.075 Ω , L = 1.2 H and C = 1.6 F. The initial charge carries by the capacitor is Q0 = 0.045 C. The switch is closed at time t = 0. Calculate the value of Q, in coulombs, at time t = 1s.
In an oscillating RLC circuit, R = 7.0 Ω, L = 10 mH, and C = 3.0 µF. Initially, the capacitor has a charge of 8.0 µC and the current is zero. Calculate the charge on the capacitor (a) five cycles later and (b) 50 cycles later.
Consider the RLC circuit shown below, where the initial current flowing through the circuit at time t=0 is I_0 = 5, and the initial charge on the capacitor at time t=0 is Q_0 = 2. The components have values of R = 100 ohms, L = 5H, and C = 1/450,500 F. Write a differential equation for Q(t), the charge across the capacitor, assuming the voltage source V(t)=0.
Calculate the resistance in an RL circuit in which L= 0.04 H and the current increases to 90% of its final value in 3.00 ms.
What direct current will produce the same amount of thermal energy, in a particular resistor, as an alternating current that has a maximum value of 2.60 A?
Consider the RL circuit in the figure with R=10.00 Ω, L1=1.80 H, L2=3.90 H, and V=5.0 V. At time t=0, the switch is closed to connect the circuit to a constant emf. How long (in seconds) does it take for the current to reach a value of Imax/2.71828 of its maximum value, where Imax is the maximum current through the circuit?