in ethyl acetate (organic) treat with aqueous HCI Aqueous layer Organic layer treat with treat with aqueous NaOH; aqueous NaOH collect precipitate by filtration aqueous organic Final product #1 treat with "dry" with MgSO4, filter, evaporate ethyl acetate aqueous HCI; Be sure to label all glass containers of colorless solutions... collect precipitate by filtration It's easy to lose track! Final product #2 Final product #3

in ethyl acetate (organic) treat with aqueous HCI Aqueous layer Organic layer treat with treat with aqueous NaOH; aqueous NaOH collect precipitate by filtration aqueous organic Final product #1 treat with "dry" with MgSO4, filter, evaporate ethyl acetate aqueous HCI; Be sure to label all glass containers of colorless solutions... collect precipitate by filtration It's easy to lose track! Final product #2 Final product #3

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter31: Introduction To Analytical Separations

Section: Chapter Questions

Problem 31.19QAP

See similar textbooks

Similar questions

In a solution containing 25ml (NH4)2S2O8 with a total volume = 100 ml =0.1 liters , the solution composition are shown below.Note; the solution require 25ml of 0.2M S2O8^-2.SOLUTION Kl KNO3 EDTA Na2S2O3 STARCH50ml 23ml 1 drop 1 ml 10 dropsExperiment; initial (S2O8-2) =0.05M ; INITIAL (l-)=0.10 Mml of S2O3^-2 added Time in minutes and seconds for color change Cumulative time in seconds Total moles of S2O8^-2 consumed1 1:43 2.0 x 10^-42 1:20 4.0 x 10^-43 1:13 6.0 x 10 ^-44 1.17 8.0 x 10 ^-45 1.24 10 x 10 ^-41a) Find the cumulative time in secondsb) for the runs ,plot mole of S2O8^2- REACTION vs. time in seconds2) Draw a straight line through ( origin ) the points and calculate the slope3) divide the value of the slope by the total volume of ( 0.1 L) to get the rate in units of M/s4) find the rate5 )calculate x and y and k
Prepare 1500mL of 0.5N H2SO4 solution with specific gravity of 1.84g/mL and assay of 97%
Suppose you have a soil that is made up of 10% organic matter with CEC = 200 cmol/kg, 40% kaolinitewith CEC = 10 cmol/kg, and 50% vermiculite with CEC = 100 cmol/kg.1- Calculate the overall CEC of the soil by taking a weighted average of the three soil components.2- What percentage of the overall CEC is contributed by the organic matter? How does that numbercompare to the 10% of the soil itself that is organic?
dont provide handwritiing soution ...
A 100 g soil containing 20% smectitie mineral matter was mixed with 150 mL solution containing 0.10 M Pb. CEC of pure smectitie is 110 emol(+)/kg. CEC of the soil (cmol(+)/kg) is:
Carboxylic acids, including fatty acids and benzoic acids, are often present inboth municipal and industrial effluents. Describe a sample preparationcombined with GC method for identification and determination of carboxylicacids in raw wastewater at ppb (µg L-1) level. Point out a suitable samplepreparation technique and GC conditions in details and give justifications foryour choice
1) How many milliliters of 70% ethanol and 20% ethanol must be mixed to prepare 500ml of 30% ethanol? 2) A gaseous blend of nitric oxide and nitrogen (NOmax) contains 0.09% v/v nitric oxide (NO) and 99.92% v/v nitrogen. Express the strength of nitric oxide in PPM (round to whole number) 3) The ratio strength of a 10mL vial of neostigmine methylsulfate injection USP is 1:1500.Calculate the amount of neostigmine methylsulfate in milligrams contained in the 10mL vial. (Round to the whole number).
Procedure: analytically transfer between 0.4053g of iron(III) chloride hexahydrate, FeCl 3•6 H2O (M = 270.2957g•mol-1), and dissolve in 5.5 mL distilled, deionized water. Support the tube on a stir plate and over a 15-minute period add, using the 10mL burette, 5mL of a nominal 600mM solution of 2,4 pentandione in methanol under constant stirring. To the resulting solution, add via a 10mL burette 3mL of a nominal 450mM sodium acetate solution stirring constantly. At this point, a red crystalline solid should begin to precipitate. Transfer and support the reaction vessel in the hot water bath and once the reaction mixture has reached a stable temperature in the desired range, maintain the reaction mixture at this temperature, under constant stirring, for a 15-minute period Initial weight of iron(III) chloride hexahydrate: 0.4053g The final weight of the reaction tris(acetylacetonate)iron(III): 19.6 mg 3. What is the charge on the metal in the starting material for your synthesized…
What is the weight percent of toluene in a mixture of toluene and n-heaxne that has a spevific gravity of 0.832
Q5 Provide solution asap
from this pfd of nitrobenzene production show material balance at mixing -the conversion is 99% and production 1000 ton/day
Hot mix asphalt (HMA) is commonly used in the construction of roadways in the United States at a rateestimated to be 500,000,000 tons/year. A typical upper layer (there may be as many as 5 layers ofdifferent thicknesses and compositions) of a high-volume highway is composed of crushed stone (alsoknown as crushed aggregate) and asphalt binder and is approximately 1.25 inches thick. The stone,which has a specific gravity of about 2.7, is mixed with asphalt binder (SG = 1.03) to form the HMAwith a composition of approximately 95 wt% aggregate and 5% asphalt. What is the volume ft3 of asphalt binder and weight (tons) of HMA required for the top layer of a 15-mile segment of interstatehighway with 5 lanes, each of which has a width of 12 ft?