Answered: In Fig. H-2, A water tank is 8 m in…

Name: H-1In Fig. H-2, A water tank is 8 m in diameter and 12m high. If the
Uploaded: 2024-03-20T06:51:10.000Z
Channel: Bartleby
Description: H-1In Fig. H-2, A water tank is 8 m in diameter and 12m high. If the tank is to be completely filleddetermine the minimum thickness of the tank plating if the stress is limited to 40 MPa.8mpghFig. H-1

Science

Physics

In Fig. H-2, A water tank is 8 m in diameter and 12m high. If the tank is to be completely filled, determine the minimum thickness of the tank plating if the stress is limited to 40 MPa. 8m e gh 12m

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter9: Fluids And Solids

Section: Chapter Questions

Problem 90AP: Oil having a density of 930 kg/m3 floats on water. A rectangular block of wood 4.00 cm high and with...

See similar textbooks

Similar questions

Two thin-walled drinking glasses having equal base areas but different shapes, with very different cross-sectional areas above the base, are filled to the same level with water. According to the expression P = P0 + gh, the pressure is the same at the bottom of both glasses. In view of this equality, why does one weigh more than the other?
Artificial diamonds can be made using high-pressure, high-temperature presses. Suppose an artificial diamond of volume 1.00 106 m3 is formed under a pressure of 5.00 GPa. Find the change in its volume when it is released from the press and brought to atmospheric pressure. Take the diamonds bulk modulus to be B = 194 GPa.
Because atmospheric pressure is about 105 N/m2 and the area of a persons chest is about 0.13 m2, the force of the atmosphere on ones chest is around 13 000 N. In view this enormous force, why dont our bodies collapse?
A submarine is stranded on the bottom of the ocean with its hatch 25.0 m below surface. Calculate force needed to open the hatch from the inside, given it is circular and 0.450 m in diameter. Air pressure inside the submarine is 1.00 atm.
Because atmospheric pressure is about 105 N/m2 and the area of a persons chest is about 0.13 m2, the force of the atmosphere on ones chest is around 13 000 N. In view of this enormous force, why dont our bodies collapse?
Water enters a smooth, horizontal tube with a speed of 2.0 m/s and emerges out of the tube with a speed of 8.0 m/s. Each end of the tube has a different cross-sectional radius. Find the ratio of the entrance radius to the exit radius.
Using the equation of the previous problem, find the viscosity of motor oil in which a steel ball of radius 0.8 mm falls a terminal speed of 4.32 cm/s. The densities of the ball and the oil are 7.86 and 0.88 g/mL, respectively.
Fluid originally flows through a tube at a rate of 100 cm3/s. To illustrate the sensitivity of flow rate to various factors, calculate be new flow rate for following changes with all other factors remaining the same as in original conditions. (a) Pressure difference increases by a factor of 1.50. (b) A new fluid wit 3.00 times greater viscosity is substituted. (c) The tube is replaced by one having 4.00 times the length. (d) Another tube used with a 0.100 times the original. (e) Yet another tube is substituted with a radius 0.100 times the original and half length, and pressure difference is increased by factor of 1.50.
Calculate the pressure due to the ocean at the bottom of the Marianas Trench near the Philippines, given its depth is 11.0 km and assuming the density of sea water is constant all the way down. (b) Calculate the percent decrease in volume of sea water due to such a pressure, assuming its bulk modulus is the same as water and is constant. (c) What would be the percent increase in its density? Is the assumption of constant density valid? Will the actual pressure be greater or smaller than that calculated under this assumption?
The inside diameters of the larger portions of the horizontal pipe depicted in Figure P9.45 are 2.50 era. Water flows to the right at a rate of 1.80 104 m3/s. Determine the inside diameter of the constriction. Figure P9.45
The inside diameters of the larger portions of the horizontal pipe depicted in Figure P9.45 are 2.50 era. Water flows to the right at a rate of 1.80 104 m3/s. Determine the inside diameter of the constriction. Figure P9.45
When a person inhales, air moves down the bronchus (windpipe) at 15 cm/s. The average How speed of the air doubles through a constriction in the bronchus. Assuming incompressible flow, determine the pressure drop in the constriction.