) In figure below, the pressure p2 = 30,4 KN/m², whereas the velocity of the water is v₂ = 2 m/s. The diameter of the pipe at location 1 is 100 mm and it is 500 cm above the ground. If the diameter of the pipe at location 2 is 4 cm, and the pipe is 2 m above the ground, find the velocity of the water v₁ at position 1, and the pressure p₁ of the water at position 1.

) In figure below, the pressure p2 = 30,4 KN/m², whereas the velocity of the water is v₂ = 2 m/s. The diameter of the pipe at location 1 is 100 mm and it is 500 cm above the ground. If the diameter of the pipe at location 2 is 4 cm, and the pipe is 2 m above the ground, find the velocity of the water v₁ at position 1, and the pressure p₁ of the water at position 1.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

1. In the figure below, the speed of the water entering from pipe 1 is 30 dm/s, from pipe number 3The speed of passing water is 200 cm/s. Calculate the flow rates in pipes 1, 2, 3. 2What will be the output velocity in pipe numbered pipe?
A pipe of diameter 11 cm conveying 200 liters/s of water has bend of angle (θ = 90⁰if last digit is zero/even and θ = 0⁰ if last digit is odd) through horizontal plane. Find theresultant force exerted on the bend if the pressure at the inlet and outlet of the bend are 15N/cm2 and 10 N/cm2respectively.
1) When an incompressible fluid flows through a restricted (narrower) portion of a pipe, mass flow is preserved, so it: sloshes back and forth. must speed up. remains at constant speed slows down. creates a shock wave. 2) When an incompressible fluid moves from a wider pipe into a narrower one, it speeds up. This means that the wider portion must do work on the fluid (to accelerate it), and therefor the pressure there... goes to zero. is lower than in the narrow portion. is higher than in the narrow portion. is the same as in the narrow portion. cannot be calculated. 3) Normally, when the temperature of a solid, liquid, or gas increases, it expands, i.e., its volume V increases (and its mass density: ρ = m /V decreases). Because of its relatively strong hydrogen bonds, water ice forms an orderly, hexagonal lattice structure that requires the molecules to be about 9% further apart than when in the liquid phase, which…
(4) A water hose connected to a nozzle is used to fill a 10 L container. The internal diameter of the hose is 2 cm and the nozzle exit has an inner diameter of 1.7 cm. It takes 30 s to fill up the container. If the inlet pressure is 2 atm and the nozzle exit is 0.8 m above the hosea. What is the velocity (m/s) of water at the outlet stream and at the inlet stream?b. What is the water pressure (atm) at the outlet stream c. What is the mass flow rate of water (kg/s)?
A pump is installed in a pipe system, where at the suction side 1.0 m below the pump, an open manometer reads a vacuum of 20 cm of mercury. The pipe is 10 cm in diameter and the flow is 35 L/s of water. Find the total energy at the location of the manometer, relative to a datum, through the pump. A. 2.56 B. 12.74 m C. -2.72 m D. -4.67 m With F.B.D
Water is stored in a pressurised container at a height HT= 8.4 m. It then moves through a horizontal pipe which has a height HP= 0.2 m off the ground. A fault occurs, and the water in the pipe is ejected vertically out of a valve, as shown in the figure. The jet reaches a maximum height Hj off the ground. The density of water is ρ=1000 kg/m^3, and the gauge pressure in the tank is pT= 45 kPa.a) Find the maximum height of the jet, Hj (in metres)b) Find the velocity at which the jet leaves the pipe (in m/s)
Include a free body diagram A pump is installed in a pipe system, where at the suction side 1.0 m below the pump, an open manometer reads a vacuum of 20 cm of mercury. The pipe is 10 cm in diameter and the flow is 35 L/s of water. Find the total energy at the location of the manometer, relative to a datum, through the pump. A. 12.74 m B. -4.67 m C. 2.56 D. -2.72 m
At point A in the pipeline conveying water, the diameter is 1 m, the pressure 100 kPa and velocity 1 m/s. At point B, 2 m higher than A, the diameter is 0.5 m, the pressure is 20 kpA. Determine the headloss in m. a. 6.2 b. 5.0 c. 5.8 d. 5.4
If a liquid enters a pipe of diameter d with a velocity, v. what will irs velocity at the exit be if the diameter reduces to 0.5d?
A pump is installed in a pipe system, where at the suction side 1.0 m below the pump, an open manometer reads a vacuum of 20 cm of mercury. The pipe is 10 cm in diameter and the flow is 35 L/s of water. Find the total energy at the location of the manometer, relative to a datum, through the pump. ( WITH FREE BODY DIAGRAM ) CHOIECES: A.2.56 B.-2.72 m C.12.74 m D.-4.67 m
The inlet and throat diameters of a horizontal venturimeter are 30 cm and 10 cm respectively. The liquid flowing through the venturimeter is water. The Pressure intensity at inlet is 13.734 N/cm² while the vacuum pressure head at the throat is 37 cm of mercury. Find the rate of flow. Assume that 4% of the differential head is lost between the inlet and throat. Find also the value of Ca for the venturimeter.
A gas with a velocity of 300 m/s is flowing through a horizontal pipe at a section where pressure is 6 x 104Nm2 (absolute) and temperature 40°C. The pipe changes in diameter and at this section the pressure is 9 x 104 N/m2. Find the velocity of the gas at this section if the flow of the gas is adiabatic. In computation take R = 287 J/kg°K and k=1.4