In her gymnastic routine, Regina dismounts from the uneven-parallel bars and lands straight-legged on the ground, compressing her 0.250 m long femur by 2.10×10^(-5) m. If the femur has a cross-sectional area of 3.00×10^(-4) m^2 and the stress modulus of bone is 2.00×10^10 N/m^2, with how much force does Regina hit the ground?

Q: A 28 mH inductor with 2.5 Ω resistance is connected in series to a 22 μF capacitor and a 83 Hz , 71…

A:

Q: In the figure, what is the NET electric field at point P? Note: By convention, a positive net…

A: The electric field at distance from a charge is given by E = kQr2, where k = Coulomb's constant Q =…

Q: R R/2 d A single current-carrying circular loop of radius R= 4.2 cm is placed next to a long…

A: The magnetic field produced by a long current carrying wire at some perpendicular distance r from it…

Q: Determine the components of the total force on the proton. A proton moves through a region of space…

A: particle = proton magnetic field = 0.49i^ + 0.40j^ T Electric field = 2800i^ - 4500j^ Vmvelocity =…

Q: V 7. 0.0001 to 019 %3D 0:00015 7.1 V 7. 0.0002 1.4

A:

Q: In a mass spectrometer, a specific velocity can be selected from a distribution by injecting charged…

A: Magnetic field, B = 0.125 T Velocity, v = 4.2 × 106 m/s Electric field, E = ? V/m

Q: 200 grams of an ideal gas are kept in a tank at a temperature of 20°C. The gauge pressure in the…

A: Given data as  per question M = 200gm T = 293K P = 15KPa

Q: A hydrogen atom is in its fourth excited state. The atom emits a 1.28E+3nm wavelength photon.…

A:

Q: A thin sólid barriér in the xy-plane has a circular hole. An electron traveling in the 0.00m/s…

A: Givend=12.6 μm=12.6×10-6 mvx=0 m/s

Q: A metal sphere of radius 10 cm carries a charge of +2.0 µC uniformly distributed over its surface.…

A: Given data:  Radius of sphere = 10 cm = 0.10 m Charge (q) = +2.0 μC = +2.0×10-6 C Required:…

Q: Drmeity = 1500kg / Mass 5o kg Find volume

A: Given data:  Density (ρ) = 1500 kg/m3 Mass (m) = 50 kg Required: Volume (V)

Q: Two (2) point changes, q1=+25 nC and q2=-75 nC, are separated by a distance of 0.003 meters. Find…

A: q1 = 25 nC q2 = -75 nC distance between the two charges (d) = 0.003 m

Q: Nuclear Instruments & Control   Which listed radiation detector type operates by the collection of…

A: Which listed radiation detector type operates by the collection of electrons emitted when a light…

Q: Given data : Initial velocity=32 m/s Final velocity=35 m/s Time=2 s Find acceleration

A:

Q: 2. A wire has a radius of 1.90 mm. If the current in the wire is 6.14 A, the drift velocity is 4.86…

A:

Q: A power output of 18.0 h.p. is required to overcome friction and move a certain car at a constant…

A: The power required to move a body at a certain velocity is given by P = F×v, where F = the force…

Q: (5) A ball is thrown upwards off the edge of a balcony. As it comes back down it misses the balcony…

A:

Q: CAPACITORS The same three capacitors C, C2, and C3 were connected in series to a potential…

A: b1) Determine the equivalent capacitance.

Q: A block of wood floats in fresh water with 0.616 of its volume V submerged and in oil with 0.886 V…

A:

Q: In an elastic collision in which there are no external forces, which of the following is true?…

A: Momentum is sort of thing Newton explained as, the things in motion stay in motion, unless affected…

Q: What is the average translational kinetic energy of an ideal gas that is maintained at an absolute…

A: Given : Absolute pressure, P = 2.16×105 N/m2 Volume of container, V = 170 m3

Q: What is the electric potential at 50 cm distance from the center 2 meter line conductor carrying a…

A: Solution: Given: k = Coulomb's constant = 9.0 x 109 N.m2/C2  L = length of finite line charge = 2 m…

Q: A carpenter's square has the shape of an L as shown in the figure below. Locate its center of…

A: Given data as per question  d1   =   20.0 cm d2   =   2.00 cm d3   =    2.00cm d4   =    9.0 cm…

Q: Answer the problem and provide the given, formula used, complete solution and complete illustration.…

A:

Q: 2. Maria and Rory are using a spring launcher to move a 125 g block to the top of a ramp. The spring…

A:

Q: Find the component form of u + v given the lengths of u and v and the angles that u and v ma I|배 =…

A: Givenu=2 , θu=6v=1 , θv=2

Q: The first four Hermite polynomials of the quantum oscillator are H0 = 1, H1 = 2x, H2 = 4x2 − 2, H3 =…

A:

Q: Four objects with the same mass and outer radius, start at rest and roll without sliding (a) Rank…

A:

Q: Determine the buoyant force of a copper cube (Pcopper = 8.96 kg/m³) of side 0.15 cm submerged into…

A:

Q: The 8 kg Block is moving with an initial speed of 5 [m/s]. If the coefficient of kinetic friction…

A:

Q: Which of the following can increase the resistance of a conducting wire? 1. increase its length II.…

A: The resistance of the wire is given by                         R = ρlA Where ρ is the resistivity of…

Q: 200 A Moving to another question will save this response. Question 14 of 20 Question 14 1 points…

A:

Q: Two (2) point changes, q1=+25 nC and q2=-75 nC, are separated by a distance of 0.003 meters. Find…

A:

Q: A 3 kg box rests on a horizontal table. It is attached to a 2 kg box via a pulley. The 2 kg box…

A:

Q: 43. An elevator’s electric hoist is rated at 8.0 kW and has an efficiency of 90.0%. The hoist lifts…

A:

Q: What is the maximum speed of the block? Vmax = 6.00 m/s A 3.00-kg block is connected to two ideal…

A:

Q: 19. A projectile is shot at ground level at an angle of 35° with the horizontal. It has an initial…

A:

Q: What is the flow rate of water (in m³/s) hose that can fill 1.75 L bottle in 5 seconds

A: Given data:  Volume (V) = 1.75 L Time (t) = 5 s Required: The flow rate of water in m3/s

Q: What is the GPE difference of the object dropped at two different distances with mass of 0.065…

A:

Q: Potential difference between two points of a wire carrying 20 ampere current is 1 Volt. Calculate…

A: Potential difference between 2 points of a wire is 1 volt.

Q: How does the equivalent resistance of four identical resistors compare if they are all connected in…

A:

Q: What is the net heat current in radiation of an Ice cube at 0 °C if the surrounding air is at 20°C?…

A: Given Data, Temperature of the Ice cube (Ti)=00C Temperature of surrounding (Ts)=200C Length of ice…

Q: An object of mass m hangs from a spring and oscillates with period T. It moves a distance d in the…

A: mass of object = m time period = T distance moved in time T = d

Q: Assuming the precision, PP, with which this electromagnetic radiation can shape the cornea is…

A: Electromagnetic waves, which comprise a time-varying electric field and a time-varying magnetic…

Q: ept of Ampere’s Law and cite at least t

A: Ampere’s Law

Q: A series RLC circuit has a resistance of 682.3 2, an inductance of 82.8 H, and a capacitance of…

A: Given: The resistance of the circuit is 682 Ohm. The inductance of the circuit is 82.8 H. The…

Q: The coefficient of static friction between the floor of a truck and a box resting on it is 0.30. The…

A:

Q: A sample of a diatomic gas is kept at 294 K in a 17,735 cm3 cubical container. Calculate the minimum…

A:

Q: 5. Find the maximum weight of the bucket that the wire system can support so that no single wire…

A:

Q: Suppose a man stands in front of a mirror as shown in the figure below. His eyes are 1.78 m above…

A:

Mechanical Properties of Solids

There are three types of matter- solid, liquid and gas. Out of them, solids have a rigid shaped and size. The intermolecular forces of attractions in solids are greatest. Mechanical properties are the physical properties of a material which it shows, when it is provided with certain amount of force or load. These properties are to be kept in mind for various purposes. When a force is applied to an object, the object may or may not get deformed depending upon its elastic property. But every time the object develops a restoring force against the force applied. This is commonly known as stress. If the object changes its dimensions due to the force applied it develops strain ( which is the ratio of change in dimension to the original dimension).