In leveling across a wide river on Pampanga, a reciprocal level readings were taken between points B and C as shown in the tabulation. Compute the difference in elevation between B and C with instrument set up near B. Instrument set up near BInstrument set up near CSta ObsBSFSSta ObsBSFSB2.2832.478B2.284C2.480B2.286C2.476B2.283C2.578C1.6753.143C1.674B3.140C1.677B3.1451.674B3.142C1.677B3.143C1.676В3.146

In leveling across a wide river on Pampanga, a reciprocal level readings were taken between points B and C as shown in the tabulation. Compute the difference in elevation between B and C with instrument set up near B.

In leveling across a wide river on Pampanga, a reciprocal level readings were taken between points B and C as shown in the tabulation. Compute the difference in elevation between B and C with instrument set up near B.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A transit with a stadia interval factor of 100.8 was set at C on the line between points A and B,…

Q: . In leveling across a wide river, reciprocal level readings were taken between two points A and B…

A: To find difference in elevation between two points and elevation of point B

Q: Н.W 1- An angle is observed repeatedly using the same equipment and procedures. Calculate (a) the…

Q: 5. Find the mean precipitation for the area shown by Thiessen polygon method. The area is composed…

Q: PROBLEM SET NO. 2: From the given data below, complete the set of differential leveling notes.…

A: As per guidelines, we are supposed to answer only one question. Kindly repost other question as a…

Q: An inverse method of leveling is executed between two existing concrete structures and across a…

Q: B and C were observed from point A where the instrument was set up at a height of 1.25m. Point B and…

Q: Q1: The table below represents the vertical coordinates for 12 hours of standard hydrograph, find…

A: Given the coordinates of 12 hour standard hydrograph. To get coordinates of 6 hour unit hydrograph…

Q: Two pegs A and B were fixed on opposite banks of a 50 m wide river. The level was set up at A and…

Q: 2. A reciprocal leveling is observed across a wide river and the reciprocal level readings were…

Q: To meet a third leveling accuracy, the maximum misclosure of a level run of 4000 meters should be…

Q: Q.2 Reciprocal leveling was conducted across a wide river to determine the difference in level of…

A: Given data Reduced level Staff readings at A Staff readings at B Distance between two.

Q: Point A has an elevation of 130.48 m above mean sea level while elevations at points B and C are…

Q: The following readings are taken from an Auto level from an uneven field. Find the Reduced Level of…

A: At point where instrument shifted that point it is FS. St.point BS IS FS HI RL REMARK 1 1.20…

Q: In leveling across a deep and wide river, reciprocal level readings were taken between two points X…

Q: In leveling across a wide river on Pampanga, a reciprocal level readings were taken between points B…

A: When the instrument set up near B Back sight reading at B = 2.283,2.284,2.286,2.283 Fore sight…

Q: Q2.The vertical angle reading measured from station A to station B,C,D are as shown in the Following…

Q: Data from a survey, are shown below. Use either the Rise and Fall method or the Height of Plane of…

A: Data Given: Asked: Use either the Rise and Fall method or the Height of Plane of Collimation…

Q: The backsight reading on a first point is 2.25m and the foresight reading on a second point is…

A: Elevation of points can be find by using dumpy level. Staff readings of 2 points using dumpy level…

Q: A reciprocal leveling is observed across a wide river and the reciprocal level readings were taken…

A: GIVEN, The above problem is related to 'SURVEYING' And it is from the concept of 'RECIPROCAL…

Q: A transit with a stadia constant equal to 0.30 is used to determine the horizontal distance between…

A: Given data Stadia constant=0.30 Stadia intercept=2.55m Distance BC=200.55m

Q: As a result of observing the slope with a 30m tape measure, which is 7.5mm longer than the standard…

Q: From the following differential leveling notes, compute the difference in elevation between stations…

A: Data for the Differential leveling is given in the question

Q: A reciprocal leveling is observed across a wide river and the reciprocal level readings were taken…

Q: In levelling across a river, reciprocal level readings were taken between two points A and B. From…

A: To find elevation of point B?

Q: The table shows stadia readings taken by a transit set point A between two points X and Y with…

Q: Research and discuss the basic errors or corrections under leveling datum in mean sea level. Then…

Q: Among the different methods of leveling discussed, choose three (3) that interests you, briefly…

A: First we need to know the definitions if the one which we are going to use 1. Direct leveling 2.…

Q: A backsight reading of 2.73 m is taken on point A and subsequently a foresight reading of 1.35 m is…

A: A Backsight reading of Point A = 2.73 Foresight Reading of Point B = 1.35

Q: In leveling across a river, reciprocal level readings were taken between two points A and B. From a…

Q: A reciprocal leveling is observed across a wide river and the reciprocal level readings were taken…

A: Given:- The reciprocal level readings were taken between points A and B When the instrument is at…

Q: A dumpy level with an interval focusing telescope has set-up on the left bank of a river and the rod…

A: Tachometry survey is the branch in which the we can find the vertical and horizontal distance with…

Q: The distance between two points A and B measured along a slope was 270 m. Determine the horizontal…

A: Determination of horizontal distance in different 3 conditions

Q: The difference in elevation between points A and B is 78.56m. If the horizontal distance between…

Q: In the leveling across a wide river on Pampanga, a reciprocal level readings were taken between…

A: Set up near B Average of BS = 2.283+2.284+2.286+2.2834=2.284m Average of FS…

Q: The following data were obtained by stadia instrument: RR = 1.95 alpha = 18 degrees and 23 minutes…

Q: 1. A tachometric surveying was conducted to obtain some readings for inaccessible points, where it…

A: Given case 1 instrument and Bench mark angle θ=-4.°26' and staff intercept S=2.041-1.205=0.836…

Q: When performing a leveling process for the longitudinal section of a road, the following readings…

Q: complete the following leveling nột and determine the elevation of BM14. Apply arithmetic checking.…

A: It is calculated by using height of instrument method Height of instrument = elevation + BS…

Q: The following consecutive readings were taken with a level on continuously sloping.ground at a…

A: Station Back sight (BS) Intermediate sight (IS) Fore sight (FS) Height of Instrument (HI) Reduced…

Q: A level is set up at a point 140 m from A and 110 m from B; the observed staff readings at A and B…

Q: In reciprocal leveling across a deep ravine the following sets of rod readings were taken:…

Q: A dumpy level with an internal focusing telescope was set up on the left bank of the river and the…

A: The given data is as follow: Stadia interval factor=100

Q: Set Up Near B Set Up Near C STA BS FS STA BS FS 2.283 C 2.478 2.284 C 2.480 2.286 C 2.476 В 2.283 C…

A: It is required to determine the average BS reading at B. A1=2.283+2.284+2.286+2.2834=2.284 It is…

Q: a.) Compute the difference in elevation between B and C with instrument set up near B. b.) Compute…

A: The leveling is the process of calculating the reduced level of any point on the ground surface with…

Q: In levelling across a wide river on pampanga, a reciprocal level readings were taken between point b…

A: Summation of backsight (BS) readings for instrument set up near B is, = 2.283+2.284+2.286+2.283 =…

Q: A stadia intercept of 1.02 m was recorded for a horizontal sight stadia surveying. If the stadia…

Q: From the given profile leveling notes: What is the difference in elevation between station 5 and 2?…

Q: The back staff reading on a B.M. of R.L. 1000.000 m is 1.663 m. If foresight reading on a point is…

Q: In leveling across a wide river in Pampanga, a reciprocal level readings were taken between points B…

Concept explainers

Mapping

Mapping is the process of representing the surface of the earth, objects on it, and the relative positions of the objects, to a suitable scale. In mapping, a large area of land is measured, surveyed, and plotted. The details of the objects present in the nearby surrounding area are located using conventional signs. All these processes are carried out on a flat paper known as a map.

Question

Instrument set up near B
Instrument set up near C
Sta Obs
BS
FS
Sta Obs
BS
FS
B
2.283
2.478
B
2.284
C
2.480
B
2.286
C
2.476
B
2.283
C
2.578
C
1.675
3.143
C
1.674
B
3.140
C
1.677
B
3.145
1.674
B
3.142
C
1.677
B
3.143
C
1.676
В
3.146

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1 Interpretation of data

VIEW

Step 2 Primary calculations

VIEW

Step 3 Calculations for actual difference between two station

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

x = 137y = 37a = 6b = 8c = 1
water is flowing through a 35cm diameter welded steel pipe (f=0.014) of length 2300m that drains a reservoir under a head of 50m. the pipe has a thickness of 9mm. if the valve at the end of the pipe is closed in 9s. approximately what water-hammer a. 1.667MPa b. 1.567 MPa c. 1.467 MPa d. 1.367Mpa
THe ans should be: Vmax-total = -0.0104m 0max-total=-0.00577 rad = -331 degree
1. Two identical channel Sections placed back to back with a clear distance of 50 mm. Given: Channel section C9x13.4 Wide Flange Section W10x33 Angle section L6x4x 3/4 a. Area b. Centroid c. moment of inertia (lx and ly) d. section modulus ( Sx and Sy) e. radius of gyration ( rx and ry)
I need hand written solution onlyd=6 in D=12 i z1= 6 f z2 = 12 f Q= 13 cfsttn
Given the data shown: What is distance AB? 1. What is distance BC? a. 13.21 c. 12.03b. 15.92 d. 17.52 2. Find the DMD for side AB. a. -7.85 c. -5.99b. -6.51 d. -8.55 3. Find the DMD for side BC. a. -1.86 c. -0.96b. -2.02 d. -1.75 4. Find the DMD for side CD.a. 85.65 c. 82.40b. 72.05 d. 80.66 5. Find the DMD for side DA.a. 75.65 c. 73.56b. 74.03 d. 72.76 6. Find the area using DMD Method.a. 1215.98 c. 1449.66b. 1625.31 d. 1315.22
PROBLEM 03: All data are in feet. The elevation of BM-A is 1364.58 feet. Rod readings are as follows: +S on BM-A, 2.86; IFS on 11+00, 3.7; –S on TP1, 10.56; +S on TP1, 11.02; IFS on 12+00, 8.7; on 12+50, 6.5; on 13+00, 5.7; on 14+00, 6.3; –S on TP2, 9.15; +S on TP2, 4.28; IFS on 14+73, 3.5; on 15+00, 4.2; on 16+00, 6.4; –S on TP3, 8.77; +S on TP3, 4.16; –S on BM-B, 9.08. Prepare a set of profile leveling notes for the data listed and show a customary check in your solution. What is the difference in elevation between BM A and BM-B? Which of the following stations has the highest elevation Which of the following stations has the lowest elevation?
Urgent a = 10 , b = 7
g 3wrgeag sdfg 4 56y7x4 shb45gty6 h645ty 456
Answers a) 60 L/sec b) 88.29 kPa c) 6886.62 kN/m
07: Water is flowing through apipe shown in Fig. what is the Difference in datum head (2₂-2₁), if the rate of flow through the pipe is (60 lit/sec). Jp Flookpo Ans: 2₂-2, -25.47m mm Datum line P₁ = 350kpa N 2
78 56856t57tb 8g7t8gub jntguyi8bh jngb nitg78ib nuhjtg78ib nt78igb n