Physics ch27 #14 In the circuit of the figure below, the switch S has been open for a long time. It is then suddenly closed. (Use the following asnecessary: & for E, R,, R2, t, and C.)R1CSR2(a) Determine the time constant before the switch is closed.(b) Determine the time constant after the switch is closed.(c) Let the switch be closed at t = 0. Determine the current in the switch as a function of time.I =

In this question we are given with a circuit with resistors and a capacitors and we have to answer…

In the circuit of the figure below, the switch S has been open for a long time. It is then suddenly closed. (Use the following as necessary: & for E, R,, R,, t, and C.) R1 R2 (a) Determine the time constant before the switch is closed. (b) Determine the time constant after the switch is closed. (c) Let the switch be closed at t = 0. Determine the current in the switch as a function of time. I =

In the circuit of the figure below, the switch S has been open for a long time. It is then suddenly closed. (Use the following as necessary: & for E, R,, R,, t, and C.) R1 R2 (a) Determine the time constant before the switch is closed. (b) Determine the time constant after the switch is closed. (c) Let the switch be closed at t = 0. Determine the current in the switch as a function of time. I =

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 59P: For the circuit shown below, =50V , R1= 10 , and L= 2.0 mH. Find the values of l1and l2(a)...

See similar textbooks

Similar questions

How long after switch S1 is thrown does it take the current in the circuit shown to reach half its maximum value? Express your answer in terms of the time constant of the circuit.
For the circuit shown below, =50V , R1= 10 , and L= 2.0 mH. Find the values of l1and l2(a) immediately after switch S is closed, (b) a long time after S is closed, (C) immediately after S is reopened, and (d) a long time after S is reopened.
The current in the RL circuit shown here increases to 40% of its steady-state value in 2.0 s. What is the time constant of the circuit?
Consider the circuit shown below. Find I1, I2, and I3 when (a) the switch S is first closed, (b) after the currents have reached steady-state values, and (c)at the instant the switch is reopened (after being closed for a long time).
In the displayed circuit we have left the S switch open for a long time. Then we close it. Suppose that ε = 10 V, R1 = 50 kΩ, R2 = 100 kΩ and C = 10 mF. Find the value of the time constant: a) Before closing the switch. b) After closing the switch. c) Suppose we turn off the switch at time t = 0. Find the current flowing through the switch as a function of time.
The diagram shows an ideal (zero internal resistance) DC source connected to three identical resitances and a switch. In the diagram, the switch is open. If initially, the switch is open, what happens to current I1 and I2 after the switch is closed?
Consider the circuit shown in the figure. Let the equivalent resistance of the circuit when the switch is open be Req, open, and the equivalent resistance when the switch is closed be Req, closed. a) Find the difference (in Ω) between the two equivalent resistances, Req, open − Req, closed. Req, open − Req, closed = b)When the switch S is closed, the equivalent resistance drops to 52.0% of the original value. Determine the value of R (in Ω). c) What If? What would the voltage (in V) between points a and b have to be for 200 W to be delivered to the circuit when the switch is closed? Assume that R has the value found in part (b).
The switch in the figure below is connected to position a for a long time interval. At t = 0, the switch is thrown to position b. After this time, what are the following? (Let C = 1.50 µF.) The circuit is a rectangular loop with a vertical wire in the middle that extends from the bottom side of the loop to almost reach the top side, ending at one side of a switch. This vertical wire contains a capacitor of capacitance C. The left side contains a battery of potential difference 12.0 V, with the positive terminal above the negative terminal. The top side contains, from left to right, a resistor of resistance 10.0 Ω, point a, point b, and an inductor of inductance 0.100 H. A gap separates points a and b. In the figure, the switch is in contact with point a. (a) the frequency of oscillation of the LC circuit Hz(b) the maximum charge that appears on the capacitor µC(c) the maximum current in the inductor mA(d) the total energy the circuit possesses at t = 3.00 s µJ
The switch in the figure below is connected to position a for a long time interval. At t = 0, the switch is thrown to position b. After this time, what are the following? (Let C = 1.40 µF.) The circuit is a rectangular loop with a vertical wire in the middle that extends from the bottom side of the loop to almost reach the top side, ending at one side of a switch. This vertical wire contains a capacitor of capacitance C. The left side contains a battery of potential difference 12.0 V, with the positive terminal above the negative terminal. The top side contains, from left to right, a resistor of resistance 10.0 Ω, point a, point b, and an inductor of inductance 0.100 H. A gap separates points a and b. In the figure, the switch is in contact with point a. (a) the frequency of oscillation of the LC circuit Hz(b) the maximum charge that appears on the capacitor µC(c) the maximum current in the inductor mA(d) the total energy the circuit possesses at t = 3.00 s
The capacitor in the circuit shown below is initially uncharged. The switch is closed at t = 0 s. ΔVbattery = 60 V, C = 2.0 F, and R = 3.0 Ω. What is the current in the circuit immediately after the switch is closed, in Ampere?
In the accompanying figure, the rails, connecting end piece, and rod all have a resistance per unit length of 2.0 Ω/cm. The rod moves to the left at v = 3.0 m/s. If B = 0.75 T everywhere in the region, what is the current in the circuit (a) when a = 8.0 cm? (b) when a = 5.0 cm? Specify also the sense of the current flow.
In the circuit below, the switch has been in the open position for a long time. At t=0, the switch is turned on. If the current at time t=3.3 ms reaches half of its maximum value, L=68 mH, and ℰ=17 V, find:the time constant τ= ms,the resistance R= Ω,the maximum value of the current, Imax= A.If the switch is open again, after what time, the current will reach the half of its value?t1/2= ms.