In the circuit shown below, V R www Output voltage What is the current, I, in units of Amperes (A) if the diode has an ideal characteristic, the resistance, R, is 9 Ohms and the supply voltage, V, is 16.5 V? Assume that the diode is forward biased. (Answer should be within 1%, in units of Amperes or Amps.)

In the circuit shown below, V R www Output voltage What is the current, I, in units of Amperes (A) if the diode has an ideal characteristic, the resistance, R, is 9 Ohms and the supply voltage, V, is 16.5 V? Assume that the diode is forward biased. (Answer should be within 1%, in units of Amperes or Amps.)

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.2P: The temperature dependence of resistance is also quantified by the relation R2=R1[ 1+(T2T1) ] where...

See similar textbooks

Similar questions

What is CEMF?
How is a solid-state diode tested? Explain.
Question For the following circuit, consider that both diodes ?1 and ?2 are ideal, that is ?? = 0 V. Consider the input source ??? = 48sen (??) V, a frequency of 60 Hz. Consider that the ??? of both diodes is high enough (negative value), so that both diodes never conduct in reverse. Carefully analyze the circuit to obtain: a) Sketch the curves of ??? and ????. b) The mathematical function of ???? in terms of ???.
Derive the current equations for the circuit shown below, using the labels as shown.Note that rz here is a model of the parasitic imperfection of the Zener diode.a) IL = ?b) II = ?c) IZ = ?d) What impact does rz have on VL?
Load resistor RL as shown is 12 kΩ. What are the nominal and worst-case values of Zener diode current and power dissipation if the power supply voltage, Zener breakdown voltage and resistors all have 5 percent tolerances?
The npn transistor is connected in a “diode” configuration. Use the transport modelequations to show that the i-v characteristics of thisconnection are similar to those of a diode as defined. What is the reverse saturation currentof this “diode” if IS = 4 × 10−15 A, βF = 100, andβR = 0.25?
Two identical Schottky diodes are connected in series, one in the forward and the other in reverse direction, see figure. Assume the reverse saturation current, IS, of each diode to be known. Derive he current-voltage curve I(V) of this circuit. Plot it with the ratio I / IS on the y-axis and V / Vth on the x-axis. Make sure to cover a broad range of voltages, say, from –10 Vth to 10 Vth.
Consider the diode circuit shown below. If Vs is a sinewave with a peak amplitude of 12 Volts at 60Hz, and diodes D1 & D2 are considered ideal, sketch the appearance of the waveform at node voltage Vout . Sketch the appearance of the waveform at Vout .
Draw the circuit diagram of a single phase full-wave uncontrolledrectifier with R-load. Describe its principle of operation. Draw thewaveforms of: input voltage, voltage across the load, current throughthe diodes and their voltage. Write the expressions for: the averageoutput voltage Vd, the maximum reverse voltage across the diode and thestandard transformer power. Describe what the difference will be if acapacitor is added in parallel with the load at the output.
The npn transistor is connected in an alternate“diode” configuration. Use the transport model equations to show that the i-v characteristics of this connection are similar to thoseof a diode as defined. What is thereverse saturation current of this “diode” if IS =5 × 10−16 μA, βF = 60, and βR = 3?
Assume that an input signal is applied to the circuit given above, as shown in the figure next to it. Accordingly, answer the following questions. The diodes used are silicon diodes, their operating voltages are 0.7 volts, and can be omitted because their resistance is very small. a) Write the name of this circuit, thinking about which circuit we do in the courses is equivalent to the purpose. b) What are the diodes/diodes that are active in a positive half-loop? Please type. c) What are the diodes/diodes active in the negative half-loop? Please type. d) Calculate ? ?−???( ?? ) for this circuit.
Derive the equation of the Vdc, Vrms, Efficiency, RF, and TUF of a given three-phase half-wave rectifier circuit shown. Draw the output waveform of the pulsating DC voltage neatly and accurately.