Answered: In the fig. shown, compute the ff :…

In the fig. shown, compute the ff : (11-13) the tension in cable BD 7.5 rt Tuo = (14-15) the components of the support 10 rt At C. Ch = Cv = 5 rt 12.5 1000 lb ft

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter12: Static Equilibrium And Elasticity

Section: Chapter Questions

Problem 38P: A uniform horizontal strut weighs 400.0 N. One end of the strut is attached to a hinged support the...

See similar textbooks

Related questions

Q: Determine the forces in members BE and CE of the loaded truss. The forces are positive if in…

Q: One end of a uniform l = 3.80 m long rod of weight supported by an angle of theta = 37 degrees with…

Q: If the mass of the girder is 3 Mg, determine the tension developed in cables AB, BC, and BD for…

A: Find the tension in the cable AB FAB = 3000 x 9.81 = 29430 N FAB = 29.430 kN Find the tension in…

Q: Given: The P body of 20√2 N is hung as shown in the figure. Desired: If the system is in…

A: Given Data : The weight of the body is given as W = 202N.

Q: Three forces F, = 20 N, F, = 10 N and F, = 5.0 N act on the structure shown in fi fourth force F, to…

Q: 4/31 Determine the forces in members GH and CG for the truss loaded and supported as shown. Does the…

Q: The man has a weight W and stands at the center of the plank. If the planes at A and B are smooth,…

Q: Using the method of joints, determine the magnitude of force (Ib) in member BC of the truss shown if…

A: In this question we have to use the method of joints and we have to determine the magnitude of force…

Q: 4] The members of a truss are pin connected at joint O. Determine the magnitude of F, and its angle…

Q: A uniform drawbridge must be held at a 38.5 ∘∘ angle above the horizontal to allow ships to pass…

A: Given data-

Q: A uniform drawbridge must be held at a 37.5 ∘∘ angle above the horizontal to allow ships to pass…

A: Given Angle θ = 37.5 o Weight W = 45000 NLength L = 16.5 m Cable attached at d = 3.00 m Known Moment…

Q: Use the worked example above to help you solve this problem. A W = 51.7 N (11.6 Ib) weight is held…

A: In an equilibrium position, the net force acting on the system is zero. It means this the system is…

Q: Two rods and one cable are attached to the supports at O. If two of the forces are as shown,…

A: GivenTwo rods and one cable are attached to the supports at 0as shown in given figure

Q: Determine the horizontal compressive force spreader bar AB exerts on point A and the forec cable…

A: Given:- A nuclear-reactor vessel has a weight of 500 x (103) lb the figure is given in the above…

Q: Determine the magnitude of force at the pin A and in the cable BC needed to support the 500 N load.…

Q: Number 4

Q: The uniform rod has a length l and weight W. It is supported at one end A by a smooth wall and the…

A: The Free body diagram, The tension in the cable can be derived by summing moments about the point…

Q: The two structural members, one of which is in tension and the other in compression, exert the…

Q: Cable AB passes over the small ideal pulley C without a change in its tension. What length of cable…

A: Given data: - The angle of cable AC with horizontal is Φ = 42o. The mass of the block is W = 73…

Q: The two structural members, one of which is in ten- sion and the other in compression, exert the…

A: Given: The compression in the member is 3 kN. The tension in the member is 2 kN. The free-body…

Q: Calculate the forces in members BE and BD of the loaded truss. The forces are positive if in…

Q: FIGURE 1 60 kN B 0.75 E :1.00 1.00. 1.00 25 kN

Q: Auniform rod 1 m long with weight 6 N can be supported in a hortzontal its ends. What is the…

A: Draw the free-body diagram of the system. Here, x denotes the position of the balance.

Q: Approximately what magnitude force, FM, must the extensor muscle in the upper arm exert on the lower…

Q: Determine the resultant R (single equivalent force) of the three forces acting on the simple truss.…

Q: A uniform picute frane weighing 10.0 N is supported as shown in the image, where the right side…

Q: In the fig. shown, compute the ff : (11-13) the tension in cable BD Teo = (14-15) the components of…

A: Given that: To determine: TBDCh and Cv

Q: Answer must be according the correct signifcant numbers.

A: The length of the rod, The half-length of the rod,

Q: Determine the force in each member of the loaded truss. Discuss the effects of varying the angle of…

A: in this question we determine angle between AB and AC

Q: A uniform plank of length L=2.7m and weight W =735N is supported by three ropes as indicated in the…

A: Given information: The symbols have the same meaning as given in the question.

Q: The boom AB supports a load of W = 720 lb. The boom is supported by a ball-and-socket joint at A and…

A: In this question we are given with a figure and we have to find the tension in each cable and axial…

Q: A uniform 400 N beam of length L = 4 m is supporting a 2000 N box as shown. Find the tension in the…

A: Given

Q: B 15. 25 KN 30

Q: Find the force exerted by the biceps muscle in holding a 100-L milk carton (weight 9.90 N) with the…

Q: 10. An object weighing 225 N is supported by a uniform 120 N horizontal beam as shown in the figure.…

Q: a horizontal rod (m=5.2 kg) is hinged to a wall at the left end and three forces are acting on the…

Q: a uniferim rod AB is weighs SN. what is necessary to produced equilibrium c from A) ? Cand 5N A I 20…

A: Given: We need to find force F at distance x cm from point A to keep this rod in equilibrium.

Q: The two structural members, one of which is in ten- sion and the other in compression, exert the…

A: In this problem, forces are divided into x and y -direction and than find resultant force and it's…

Q: A uniform drawbridge must be held at a 38o angle above the horizontal to allow ships to pass…

A: Given. W = 55000 N a = 38° L = 15 m l = 3.5 m Concept Torque balancing about pivot.

Q: A unitorm 400 N beam of length L = 4 m is supporting a 2000 N box as shown. Find the tension in the…

A: Given: L=4m W_beam = 400 N W_box=2000 N

Q: The triceps muscle at the back of her upper arm has an effective lever arm of 1.75 cm, and she…

A: Given: The weight of the women = 50 kg. The triceps muscle at the back of her…

Q: A cutter is about to cut a cable with its jaws parallel as shown. The dimension b=0.069 m, and the…

A: Given,

Q: Determine the forces in members BE and CE of the loaded truss. The forces are positive if in…

Q: A uniform steel bar of length 10 m is supported at point A and B using two cables as shown in the…

Q: The two bars shown in the figure are used to support a load P. When unloaded, joint B has…

Q: A mass is hung from identical wires made of iron, lead, nickel, steel, and brass. Which wire will s…

A: All the wires are identical and mass hung is same.

Q: Determine the resultant R (single equivalent force) of the three forces acting on the simple truss.…

A: In this question we have to find the Resultant in vector form. Please give positive feedback if the…

Question

COMPUTE THE:

the tension in cable BD
the components of the support
At C.

the resultant using cosine law
(force polygon)
the angle of the R measured
CW from the x – axis.

In the fig. shown, compute the ff :
(11-13) the tension in cable BD
7.5 rt
Tuo =
(14-15) the components of the support
At C.
10 rt
Ch =
Cv =
5 rt
12.5
1000 lb
800 Il
In the fig. shown, compute the ff:
(16-18) the resultant using cosine law
(force polygon)
60°
R =
35
(19-20) the angle of the R measured
CW from the x - axis.
500 lb

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

In Figure 9.21, the cg of the pole held by the pole vaulter is 2.00 m from the left hand, and the hands are 0.700 m apart. Calculate the force exerted by (a) his right hand and (b) his left hand. (c) If each hand supports half the weight of the pole in Figure 9.19, show that the second condition for equilibrium (net =0 ) is satisfied for a pivot other than the one located at the center of gravity of the pole. Explicitly show how you follow the steps in the Problem-Solving Strategy for static equilibrium described above. Figure 9.21 A pole vaulter is holding a pole horizontally with both hands. The center of gravity is to the left side of the vaulter.
If an odd number of forces act on an object, the object cannot be in equilibrium.
Check Your Understanding A 400.0-N sign hangs from the end of a uniform strut. The strut is 4.0 m long and weighs 600.0 N. The strut is supported by a hinge at the wall and by a cable whose other end is tied to the wall at a point 3.0 m above the left end of the strut. Find the tension in the supporting cable and the force of the hinge on the strut.
Review the relationship between stress and strain. Can you find any similarities between the two quantities?
Given that the weight of the lower arm is Mg = 16.0 N , and that the force meter reads F = 87.0 N , what is the force FT exerted vertically upward by the triceps?
The figure shows three boards clamped together. The center board weighs 93.5 N, and the coefficient of static friction between the boards is 0.490. What is the minimum magnitude of the horizontal compression forces (in N) acting on either side of the center board so it does not slip?
If the resultant of the four forces is FR = {-360k}lb, determine the tension developed in each cable. Due to symmetry, the tension in the four cables is the same.
a horizontal rod (m=5.2 kg) is hinged to a wall at the left end and three forces are acting on the rod as shown in the figure: the force of gravity (mg), a tension force (T), and the force exerted by the hinge (broken into components Fx and Fy) If theta = 35 degrees, what must T be equal to in order to keep the rod static?
A uniform plank of length 2.00 m and mass 30.0 kg is supported by three ropes, as indicated by the blue vectors. Find the tension in each rope when a 700 N person is d = 0.500 m from the left end
How far is the person sitting from the left cable if 7m long beam of negligible mass is hanged horizontally and is supporyed at each end by vertical cables? A person of unknown weight is sitting on it somewhere between the cables. The tension in the left cable is 300N, and in the right cable is 400N.
A sign is supported by a uniform horizontal boom of length 3.10 m and weight 72.0 N. A cable, inclined at an angle of 16 °with the boom, is attached at a distance of 2.71 m from the hinge at the wall. The weight of the sign is 108.0 N. What is the tension in the cable and what are the horizontal and vertical forces Fx and Fy exerted on the boom by the hinge? Comment on the magnitude of Fy. T= In N Fx= in N Fy= in N The magnitude of Fy is select (small or large) compared to that of Fx and T.
A uniform drawbridge must be held at a 38o angle above the horizontal to allow ships to pass underneath. The drawbridge weights 55000 N and is 15.0 m long. A cable is connected 3.5 m from the hinge where the bridge pivots (measured along the bridge) and pulls horizontally on the bridge to hold it in place. What is the tension in the cable? Find the magnitude and direction of the force the hinge exerts on the bridge. If the cable suddenly breaks, what is the magnitude of the angular acceleration of the drawbridge just after the cable breaks? What is the angular speed of the drawbridge as it becomes horizontal? What is the velocity of the drawbridge, just before it “hits” (i.e. goes horizontal)?