In the system shown, the water discharge flow rate of 0.0025 m³/s is delivered through the 8 cm asphalted cast iron pipe? €=0.12 Calculate the total losses in the pipe For minor losses, take K for the Entrance: 0.34 Exit: 0.24 Open global Valve: 0.44 Bend radius: 0.04 Elbow = 0.14 Half open gate valve: 0.64 Water density=1000 kg/m³ and viscosity is 0.001 N s / m² Use your last three digits of your ID number for the pipe length in m 2₂ = 5 m Sharp entrance Open globe valve Screwed regular 90° elbow bend radius 8 cm diameter Sharp exit Half-open gate valve 2₁ = 20 m

In the system shown, the water discharge flow rate of 0.0025 m³/s is delivered through the 8 cm asphalted cast iron pipe? €=0.12 Calculate the total losses in the pipe For minor losses, take K for the Entrance: 0.34 Exit: 0.24 Open global Valve: 0.44 Bend radius: 0.04 Elbow = 0.14 Half open gate valve: 0.64 Water density=1000 kg/m³ and viscosity is 0.001 N s / m² Use your last three digits of your ID number for the pipe length in m 2₂ = 5 m Sharp entrance Open globe valve Screwed regular 90° elbow bend radius 8 cm diameter Sharp exit Half-open gate valve 2₁ = 20 m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Theflowrateofwaterthroughacastironpipeis5000GPM.The diameter of the pipe is 330mm, and the coefficient of friction is f=0.0173. What is the pressure drop over a 30m length of pipe
The water need of a district with a future population of 38800 and average daily water consumption qort = 189 lt / N / day will be met by leakage pipes fed double-sided (at the end of the collection box). Water layer thickness H = 5 m, k = 0.0018 m / s and n = 0.02 are given. Standard pipe diameters and costs are given as follows: 0.4 m (60 TL / m), 0.7 m (70 TL / m), 1.0 m (80 TL / m) and 1.3 m (85 TL / m). Size the leaking tube so that it is most economical (diameter, length and slope). Average flow velocity is between 0.2-0.4 m / s.
13. Situation 5 - A 0.60 m diameter pipeline 30 m long carries 0.4 m^3/s of water. a. Compute the head loss, in meters, if n = 0.014. Round off to three decimal places. b. Compute the head loss, in meters, if f = 0.014. Round off to three decimal places. c. Compute the head loss, in meters, if C = 140. Round off to three decimal places.
The three water filled tanks shownin the figure are connected by pipesas indicated. If minor losses areneglected, determine the flow ratein each pipe.
Irrigation and drainage, i need solutions in 15 minutes please. MCQ/A 30 cm diameter well completely penetrates a confined aquifer of permeability of 45 m/day. The thickness of the aquifer is 20 m. Under steady state of pumping the drawdown at the well found to be 3.0 m and the radius of influence was 300 m. Calculate the discharge of the well . A-0.0851 m³/min B-1.548 m³/min C-0.0258 m³/min D-0.258 m³/min
Can I get a thorough step by step for the following question? Estimate the head loss using Darcy-Wesbach equation for a 4-inch (101.6-mm) diameter pipe with a flow rate of 1.5 cfs (0.042 m's) and a length of 300 ft (91.44-m). Assume pipe roughness = 0.0006-inch (0.015-mm), Temp = 20°C (68°F).
1. THERE IS A LEAK IN A HORIZONTAL 300 MMDIAMETER PIPELINE. UPSTREAM FROM THE LEAK TWOGAGES 600 METER APART SHOWED A DIFFERENCE OF140 ???. DOWNSTREAM FROM THE LEAK TWO GAGES600 METER APART SHOWED A DIFFERENCE OF 126??? . ASSUMING ? = 0.025. HOW MUCH WATER ISBEING LOST FROM THE PIPE. show answer in litre per sec
2.A 25–mm diameter commercial steel pipe,50 m long,isused to drain an oil tank. Determine the discharge whenthe oil level in the tank is 5 m above the exit of the pipe.Neglect minor losses and assume f = 0.12.
Water flows in a Venturi meter shown at a rate of 1.49 ft3/s and the differential gage isdeflected as shown. If the SG of the gage liquid is 1.25, compute the following:a) the difference in pressure from A to B (psi),b) velocity at the throat (ft/s), andc) the coefficient of the venture meter.
Water is pumped between two reservoirs at 0.25 m³/s through 800 m of 250 mm diameter pipe and several minor losses, as shown in the figure. Assume f = 0.014. Determine: a.)Major head losses in m. b.) Minor head losses in m. c.) Head Added by the pump in m. d.) the pump horsepower required.
PLEASE PUT ALL THE DECIMAL PLACES. THANK YOU The average hourly water consumption per person is 2.5 Liters anf there are 264 people in the area. Determine the following. a. the minimum rate of flow in L/s in the spring b. Total Daily water demand in L/day c. The daily yield is sufficient to the water demand of the community if the rate of flow is 0.182 L/s d. the height of the cylinder in cm thatt the minimum discharge can fill within 300 secs. diameter of the cylinder is 10 cm.
Two pipes connected in parallel as in figure below. 20 L/s of discharge flows throughboth pipes from M to N. Estimate discharge for each pipe.