ince Vi = 20 mV, Vcc = 25 V, RB = 470 kΩ, RC = 3.2 kΩ, RE1 = 470 Ω, RE2 = 1.2 kΩ, RL = 42 kΩ and β = 110 in the circuit in the figure, the value of the output voltage (Vo) find it. NOTE-1: Capacitors are negligible at mid-band frequency. NOTE-2: The output impedance of the transistor (r0) will be neglected.   a. -197,96 mV b. -222,71 mV c. -98,98 mV d. -148,47 mV e. -123,73 mV f. -173,22 mV

Q: Calculate the CMRR (in dB) for the circuit measurements of Vd 1 mV, Vo 120 mV, and VC 1 mV, Vo 20 V…

A: For understanding the CMRR (common-mode rejection ratio) first we will understand about,…

Q: A 15.9 uF capacitor and a 15.1 mH inductor are connected in parallel. In series with these units are…

A:

Q: For the circuit shown, VCC= 11 V, RB=2 KO, RC=3.6 KO and BF=40, VCC 100 RC Vo Iin The Noise Margin…

A: VOH=VCC=11 V VIH=VBE(Sat)+VCC-VsatβF×RCRB=0.7+11-0.240×3.6 KΩ×2 KΩVIH=0.85 V

Q: Q. For the circuit shown, calculate the lower and the due to the output circuit. upper critical…

A:

Q: Q. For the circuit shown, calculate the upper critical frequency due to the input and output…

A:

Q: Given: A three-stage system comprised of two amplifiers and one filter. The input power Pin = 0.1 mW…

A:

Q: Question 6 When the bandwidth is high, the circuit is said to have a high quality factor True False

A: When the bandwidth is high, the circuit is said to have a high quality factor.

Q: i4 For the circuit in figure below, the upper critical frequency due to the output * RC circuit…

A:

Q: A coil of resistance 20 2 and inductance of 300 mH is connected in parallel with a capacitance of…

A: The circuit this is excited the use of alternating supply is referred to as an AC Circuit. The…

Q: kO, RE = 0.7 kN, RC = 5 k2, and RL = 10 kQ. The transistor parameters are: B = 120, VBE(on) = 0.7 V,…

A: Given circuit-

Q: In the circuit in the figure, Rs = 3.8 kohm, R₁ = 82 kohm, R₂ = 22 Kohm, Rc = 5.6 Kohm, RE = 1.5 k…

A:

Q: circuit has a resonant frequency of 440 kHz and a system Q of 30.  Determine the bandwidth and the…

A:

Q: A coil of resistance 20 ohms and inductance 200 microHenry is in parallel with a variable capacitor.…

A:

Q: Q. For the circuit shown, calculate the upper critical frequency due to the input and output…

A:

Q: Q4. Suppose the circuit shown has the given characteristics at resonance. Determine: a) the value of…

A: We need to analyse the parallel resonance circuit , we need to calculate R and L value  form given…

Q: Q. For the circuit shown, calculate the upper critical frequency due to the input and output…

A:

Q: 18. Find the voltage gain of the amplifier in Figure 10–60 at the following frequencies: f., 0. 1fe,…

A: Given: Transconductance:g=-2IDSSVGS(off)g=-2×15-6g=5 msVoltage gain: AV=Im(RD∥RL) AV=5×10-3560∥10 K…

Q: A coil of resistance 20hms and inductance 200uH is in parallel with a variable capacitor. The…

A: The value of capacitor can be calculated by using the frequency of resonance and the current can be…

Q: A 200 kVA, 230V/50 kV, 50 Hz, testing transformer has an 8% leakage reactance and a 2% winding…

A:

Q: Vcc +20 V LIST THE CAPACITANCES THAT AFFECT THE LOW-FREQUENCY Rc 2.2 kn R 33 kfl Be = 150 Ch = 4 pF…

A: BJT   BJT  is the current-controlled device because the base current controls the devices. BJT is…

Q: A 100 kVA, 50 Hz, 230/50 kV testing transformer has an 8% leakage reactance and a 2% winding…

A: It is given that: Transformer rating:100KVAVoltage ratio:23050kVFrequency:F=50HzR=0.2%X=0.8%

Q: ind trie IOW bulemee) ansindaki herilim Note-1: The voltage gain in the middle band frequency is…

A: Given the expression of overall gain of the circuit:…

Q: Vec RC R RL Rig Ry Vis Rn Figure 10.7.1 The amplifier in Fig. 10.7.1 has Rsig = 1 kQ, Cg = 1 µF, CĘ…

A:

Q: A parallel LC tuned circuit has a coil of 4 μH and a capacitance of 68 pF. The coil resistance is 9…

A: Given Data: L = 4 uH C = 68 pF R = 9 ohm

Q: Q. For the circuit shown, calculate the upper critical frequency due to the input and output…

A: For the given circuit upper critical frequency is calculated as shown below

Q: Output voltage corresponding to the sinusoidal input voltage (VCC = 12 V,, coupling capacitor values…

A:

Q: An impedance coil having a resistance of 25 ohms and an inductance of 20mH is connected in parallel…

A: coil resistance= 25 ohms  inductance = 20mH Coil is connected in parallel with a variable…

Q: Write the transfer function that describes the frequency-dependent voltage gain of the amplifier…

A:

Q: Q. For the circuit shown, calculate the lower and the upper critical frequency due to the output…

A:

Q: D Question 10 For the Class-C amplifier circuit as shown below, Vc + 15 V 470 pF 2 µH 0.01 µF 1 kN…

A: We need to find resonant frequency for given circuit .

Q: Q2. A series circuit consists of a 0.5 µF capacitor, a coil of inductance 0.32 H and resistance 40 2…

A: Series RLC circuit have inductance capacitance and resistance.  Calculate the resonance frequency,…

Q: Q4. Suppose the circuit shown has the given characteristics at resonance. Determine: a) the value of…

A: In the parallel RLC circuit we are finding  value of inductance and value of resistance at resonance…

Q: circuit comprises of a coil (resistance of 20W, inductance of 400mH), and a capacitor of 2.0mF…

A: In this solution the concepts related to the single phase AC circuits (series & parallel RLC) is…

Q: Q3) Find the quality for the circuit shown in Fig.2 by using approximat resonant circuit. SOKO 5 mH…

A: Given:- Parallel RLC circuit Here, Supply current (I)= 2mA Inductance (L)= 5mH Capacitance (C)…

Q: In the fig. shown below we can find the higher critical frequency due to the input is equal to . and…

A:

Q: Q.1 For the circuit shown, calculate the r, and the Rc that required to obtain 177HZ lower critical…

A: Given the circuit: We need to calculate re and the value of Rc that required to obtain 177 Hz lower…

Q: The -3 dB which the magnitude the input signal. O True frequency is the frequency of the input…

A:

Q: circuit comprises of a coil (resistance of 20W, inductance of 400mH), and a capacitor of 2.0mF…

A:

Q: Q.1 For the circuit shown, calculate the r, and the Rc that required to obtain 177Hz lower critical…

A: Given the circuit: We need to calculate re and the value of Rc that required to obtain 177 Hz lower…

Q: Question II The input to the circuit shown in Figure 2 is the source voltage, v:(t), and the…

A:

Q: Q. For the circuit shown, calculate the lower and the upper critical frequency due to the output…

A:

Q: 15. For the network of Fig. 11.65: (a) Determine re. (b) Find A, = V,/V;- (c) Calculate Z;. (d) Find…

A: "Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: Q.1 For the circuit shown, calculate the re and the Rc that required to obtain 177HZ lower critical…

A:

Q: The received signal at an antenna is displayed as 20 dBµV. The actual voltage in this case is:…

A:

Q: Q. For the circuit shown, calculate the upper critical frequency due to the input and output…

A: Given: Rs=50 ohm R1=33 kohm R2=4.7 kohm Vcc=20 V Rc=2.2 kohm Re=560 ohm Beta=150 Cbc= 4 PF Cbe=10 PF

Q: A circuit comprises of a coil (resistance of 20W, inductance of 600mH), and a capacitor of 2.0mF…

A: Explanation:   “Since you have posted a question with multiple sub-parts, we will solve the first…

Q: Vout -Ks The Bode plot, gain plot only. of an electric circuit with voltage gain as shown in Figure…

A:

Q: Q4/A)- Draw the low frequency response of the circuit below , where ( gm= 1.91 mS) o 20 V Cw = 4 pF…

A:

Q: Q. For the circuit shown, calculate the lower and the upper critical frequency due to the output…

A:

Q: 1. Find the cut off frequency of the circuit given in Figure 1 with R=10 2, C=4.7 uF and amplitude…

A: