inductor has an inductance of 3H. It is connected in series with a resistance of 1Ω. It is fed from a 86V supply. A switch controls current flow. What is τ (the time constant) for this circuit? Ensure that your answer is S.

inductor has an inductance of 3H. It is connected in series with a resistance of 1Ω. It is fed from a 86V supply. A switch controls current flow. What is τ (the time constant) for this circuit? Ensure that your answer is S.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter22: Resistive-capacitive Parallel Circuits

Section: Chapter Questions

Problem 2PP

See similar textbooks

Related questions

Q: 3. Two balanced three-phase loads that are connected in parallel are fed by a three-phase line havin...

A: It is given that: Xph=j2 ΩFor load 1:P1=100 KW=100×103 WQ1=50 KVAr=50×103 VArFor load 2:S2=100 KVA c...

Q: Determine the power dissipated in the 6-ohm resistor in the network in the figure. 4Ω Vx 12 v (+ 12 ...

Q: w- 2k 3 kl E120 V a. Find the total resistance. b. Calculate the current. Find the voltage across ea...

A: Please find the detailed solution in below images

Q: The power input of a synchronous motor is measured by two wattmeters both of which indicate 50 kW. I...

A: This problem belong to Measurement of power by 2 watt meter method

Q: A 3-phase 3-wire, 415 V supplies a balanced load of 20 A at power factor 0.8 lngging. Two wattmeters...

A: The solution is given below

Q: The power input to a 3-phase induction motor is read by two wattmeters. The readings are 860 W and 2...

Q: 9. Determine Vo por (+) and (-) ayde. 1-skr 3. diodes D2 loksn 2 Vo b. Draw Vo. 2.5v - nov

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: Q9: Given the circuit in Figure 9.3, find Zin for w = 1000rad/s 10 k2 Zin 20 H ; 0.1 µF Figure 9.3

Q: Determine the voltage V, in the circuit in the figure. 12V Vo 3 20 21 O -3.28V O 4.14V O-6.43V O 2.2...

A: Given,

Q: 2- For the systems listed in assignment Find suitable approximation model for system with degree hig...

Q: Utilization voltage is always lesser than system voltage

A: Conductor-Materials which have free electrons in valence which can flow when comes under any externa...

Q: Solve for the diode current Ip and the voltage across the load R using the three diode model: below:...

Q: Given the circuit, calculate the quiescent values Icq and Vceq.

Q: For the given Y (s) = , solve for the residuals A B & D on the partial fraction expansion shown belo...

Q: Determine the steady-state output response of the causal system H(s) given below to an input ¤(t) = ...

Q: Q5. Describe the following to protect and control the motors: (i) Using circuit diagram and the curr...

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts fo...

Q: m) For the circuit shown, answer the questions from 7 to 10. The voltage and current given are in RM...

A: Note: We are authorized to answer one question at a time, since you have not mentioned which questio...

Q: Consider a GSM1800 cellular radio system with 10W transmitted power from Base Station Transceiver (B...

A: Given: a GSM 18000 cellular system Pt=10W Gt=6dB Gr=2dB Ht=200m Hr=2m D=5Km we need to calculate th...

Q: Problem 2.8 Given the circuit shown in Fig. P2.8, find a.) the value of ia; b.) the value of ib; c.)...

Q: What is the voltage V1 in the circuit in the figure? V1 1Ω 20 10 V 8 A ( 4 A +)15 V +1) 3.

Q: Make a research question regarding with these topics A. Solar Powered Light Post B. Underground Ca...

A: Different energy sources are required in day to day life. These energy sources can be renewable or n...

Q: Let G be a d dimensional spherical Gaussian with variance 1/2 centered at the origin. Derive the exp...

A: The distribution which forms a curve like a bell or a bell curve is known as Gaussian Distribution. ...

Q: 3ic 1 mH 10 Ω 5Ω ell lic (1)6 cos 2.5 x 104t A :1 µF Figure P7.67: Circuit for Problem 7.67.

Q: Given the diagram below, solve for current flowing across each resistor using Kirchhoff's Laws. R R....

Q: I. Solve the current flowing through each resistors using Superposition Theorem: R1 R3 R5 20 2.50 V1...

Q: Det vo C-> b) draw

Q: 45. Determine the output voltage for the network of Fig. 8.87 if V; 0.8 mV and ra 9 30V 3.3 k2 40 M)...

A: GIVEN: a circuit diagram with Vi=0.8rd=40kΩ FIND: output voltage of the network ...

Q: 5. Conclusion frequency response of 2nd order and 4th order low pass filter. ?

A: The. Frequency response of higher order filter will be as

Q: For the ladder network in Fig. 2.104, find I and Reg- 12 15 V 352 Req

Q: 2. A certain conductor, has a resistance of 0.5 ohm. What is the resistance of the conductor of the ...

A: Given, Case 1: Resistance R1 = 0.5 ohm Length L1 = L Diameter D1 = D Case 2: Resistance R2 =? Leng...

Q: 10.4 Find the system function for the following structure. 5/2

Q: the next four items, consider a capacitor C = 2 x 10 -6 F with charge Q0 = 3 x 10 -6 C at time t = 0...

Q: A 120m large antenna is on the mast on the top of mountain ranges west of a city which broadcasts TV...

Q: 34. Consider the following statements: (1) If the vector field is curl free, a scalar potential may ...

A: Any charged particle produces an electric field. This electric field is directed from the positive c...

Q: Find the value of the load R, in the network in the figure below that will achieve maximum power tra...

Q: Ex. 316. Determine the closed-loop steady-state error given a R(s) + E(s) ->0----->| G(s) |---+---> ...

A: The solution is given below

Q: nd V, in the circuit in the figure. Vx ww 60 20 103 2v(+ 6 V Vo

Q: 8.32 A silicon pn junction diode at 7 = 300 K has the following parameters: N, = Na = 106 cm-, T0 = ...

A: A silicon PN junction diode at T=300 K has the following parameters: Na=Nd=1016 cm-3 , τp0=τn0=τ0=5×...

Q: GH (jw) = %3D

Q: Qu. 3 For the circuit shown in Fig. 3, answer the following: a) What is the relationship between Vi ...

A: In this question one converter is given....We have to find out it's type and will write relationship...

Q: From the circuit in Fig. 2.83, find I, the power c sipated by the resistor, and the power supplied e...

Q: 200 k2 10 k2 A2 200 kQ Vo3 20 ka A4 Vo Vo1 Voz 10 k2 A3 V, = 0.2 V 200 kN 20 kn

Q: 8. A network interface port has collision detection and carrier sensing enabled on a shared twisted ...

A: The given network interface has carrier sensing enabled on the given network and collision detection...

Q: In the circuit in Fig. 2.76, obtain vị, v2, and v3. +20 v - 40 V - - G0 V + + v2 - + + 40 V V1 V3

A: As per our guidelines we are supposed to be answer the first question only. Kindly repost the other ...

Q: Example Use the superposition theorem to find v in the circuit of Fig. 4.6. 8Ω Solution: Since there...

Q: 01 km 2) vit lov t. 古ら a) Dekrmin Ve for C+) ( yele f vi b) Oraw V

Q: Find the equivalent resistance Rab in the circuit of Fig. 2.111. 6Ω 10 Ω 8Ω d wwo a e 3Ω f

Q: *P5.97. A balanced wye-connected three-phase source has line-to-neutral voltages of 440 V rms. Find ...

A: In this question, A 3 phase star balanced sources is supplied to the 3 phase balanced star load. F...

Q: Find i¡, i2, and iz in Fig. 2.73. -5A 15A i2 A B -6 A 2 A C - 1A

Q: ating voltage, v, has a periodic time of 0.01 s and a peak value of 60V. When time t is zero, . Expr...

A: In this question we will sketch voltage waveform with given data.....

Question

An inductor has an inductance of 3H. It is connected in series with a resistance of 1Ω. It is fed from a 86V supply. A switch controls current flow. What is τ (the time constant) for this circuit? Ensure that your answer is S.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having values of 2.2 F, 280 F, and 470 pF are connected in parallel. What is the total capacitance?
If a capacitor produces 15 ampere on a 240-volt supply, which of the following is its microfarad rating? 166 microfarad 15 microfarad 200 microfarad 3450 microfarad
7. The resistor in an R-L series circuit has a voltage drop of 53 V, and the inductor has a voltage drop of 28 V. What is the applied voltage of the circuit?
Two capacitors having values of 80 F and 60 F are connected in series. What is the total capacitance?
34. An inductor has an inductance of 200 mH and is connected in series with a 1 kΩ resistor to a 24 V DC supply. Find the voltage drop across the resistor after a time equal to three time constants. A. 22.81 V C. 3.248 V B. 20.74 V D. 15.17 V
A series circuit having a resistor R = 25Ω and an inductor ( L ) = 0.15H connected in series to a 120V 50Hz supply . (a) Calculate for the current flowing in the circuit. (b) Calculate for the voltage across the inductor.
A coil with a resistance of 10 Ω and an inductance of 10 H is connected in series to a 100 V DC voltage source. a) Calculate the value of the current t = 0.1 s after the switch is closed b) Calculate the value of the current when t = ∞.
L.) Two identical coupled coils have an equivalent inductance of 100 mH when connected series aiding and 50 mH in series opposing. What are the values of the self-inductance L1 and L2? a. 3.75 mH b. 375 mH c. 0.375 mH d. 37.50 mH
The R-L Circuit: An inductor with an inductance of 2.50 H and a resistance of 7.00 n is connected to the terminals ofa battery with an emf of 6.00 V and an internal resistance of 1.00 n. What is the rate ofincrease of current at the instant when the current is 0.500 A? A) 0.8 A/s B) 0.6 A/s C) 0.4 A/s D) zero E) None of the above.
Two identical coils with self-inductance of 250 µH each are connected in series. When connected series aiding, the equivalent inductance is 550 µH and 450 µH when connected in series opposing. How much is the coupling coefficient of two coils? a. 0.2 b. 0.3 c. 0.1 d. 0.4
In the circuit, V is a 3.4 V battery, C is a 71.3 μC capacitor, L is a 29.6 mH coil (with no resistance), R1 = R3 = R4 = 3.99 Ω, R2 = 6.78 Ω and S is a switch, initially open. At t = 0 the switch is closed. At that instant: find dI/ dt, the rate at which the current is changing in the coil, in A/s. The sign of the answer will indicate if I (current) is increasing or decreasing.
Two identical coupled coils have an equivalent inductance of 100 mH when connected series aiding and 50 mH in series opposing. What are the values of the self-inductance L1 and 12? a. 3.75 mH b. 375 mH c. 0.375 mH d. 37.50 mH