inductor has the folowing characteristics: Air core, diameter = 5cm 852 turns Length = 15cm Given that the permeability of air is 1.25 x 10-6, what is the inductance of this inductor? Ensure that your answer is in mH.

inductor has the folowing characteristics: Air core, diameter = 5cm 852 turns Length = 15cm Given that the permeability of air is 1.25 x 10-6, what is the inductance of this inductor? Ensure that your answer is in mH.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 3RQ: A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted...

See similar textbooks

Related questions

Q: An inductor has the following characteristics: Air core, diameter = 5cm 980 turns Length = 15cm Give...

Q: Draw the block diagram for a 11001 sequence detector.. Showing the inputs and the outputs..

A: Block diagram of sequence detection of 11001: Let 'x' be the input and y be the output.

Q: Derive the Fourier Series expansion of ) given 4-Vpp, 1MHZ square wave signal shown in Figure 2.1. b...

A: The square wave signal is shown below, Where,The peak to peak voltage is,Vpp = 4 Vf=1MHz

Q: 01 km 2) vit lov t. 古ら a) Dekrmin Ve for C+) ( yele f vi b) Oraw V

Q: Elampleta Plat fhe ampl:Indespeclpum o Tue Sollowing sighal assume foIz ー% T Tifulsedration

Q: D1.4. The three vertices of a triangle are located at A(6.-1.2). B(-2,3. -4), and C(-3. 1.5). Find: ...

Q: DE MOIVRE'S THEOREM Copy the problems and show your full solutions on your answer sheet. Evaluate th...

Q: Consider the base 5 number 112s. Enter the base 5 digits in decimal form. place values 5= 25 5' = 5 ...

A: The solution is given below

Q: An inductor has the folowing characteristics: Air core, diameter = 5cm 980 turns Length = 15cm Given...

A: Given that Diameter of inductor d=5 ⇒r=d2=2.5 cm radius r=0.025 cm Number of turns N=980 turns Lengt...

Q: a Detwmine Vo if V, - 10v 1 V2 = ov. b. Dettrmine Vo if Vi= SV 1 Vz- Ov C Determire Vo if V, =10v q ...

Q: For the power amplifier circuit in Figure A: Find the maximum output power that can be delivered b...

Q: 1. Given Rs Determine: a. If the diode is "ON" b. IL, Is, Iz C. Pz 2202 Vi Vz RL 20V 10V 1802

A: The solution is given below

Q: 01 kn vit o Vo い a) Dekrmin Vo for Ct) () uele of vi b) Oraw V,

A: In this question, Input voltage waveform is given. Draw the output voltage waveform and output vol...

Q: Determine the total potential energy stored, in microjoules, in a cylinder of radius 7 m and height ...

Q: Solve for Vec, Veb, Ic, and identify the region of operation and explain why. Beta=200

A: In this question, We need to determine the voltage Vec, Veb, and current Ic, and identify the regio...

Q: Cross Arm iz mc 13 Line Conductor Pole 可工

Q: Discuss the effects of rotor resistance in T-S characteristics of 3 phase induction motor.

Q: B D Fig. 2 AC LINE LOAD

A: The given power converter is Pulse width modulation VFD(voltage frequency drive). These give more si...

Q: Find the equivalent resistance Rab in the circuit of Fig. 2.111. 6Ω ww 8Ω 10 2 wwo a d bow e ww 3Ω 3...

A: This question comes under network theory . It is related to calculation of equivalent resistance of ...

Q: Ex. Q 4. Determine the following for the network of Fig. D a. Ipo and VGS0 b. Vp- p 20 V Rp 26.2 kn ...

A: We need to find out the current and voltage for given circuit

Q: Determine the following: a. maximum charge of the capacitor in Circuit Y b. maximum current of Cir...

A: The solution is given below

Q: 3. Does the experimental data indicate that Bac is constant at all points? Does this have any effect...

A: In the case of a BJT, the input current controls the output voltage. This is due to the fact that BJ...

Q: Determine the steady-state output response of the causal system H(s) given below to an input ¤(t) = ...

Q: For the ladder network in Fig. 2.104, find I and Req• 2Ω 1Ω 8Ω 352 15 V Rea

Q: General Block diagram of an Electrical Drive system is shown in Figure 5. Electric Power Electric Me...

A: Induction Motor: It is a ac electric motor in which the electric current in the rotor needed to prod...

Q: Solve the complex number in complete solution

Q: (8<90°) (10+2i)

Q: Tdeal diodes D2 1-5kr 3. 9. Determine Vo For (H) and (-) ayde. Vi Vo b. Draw Vo. 2.sv - nov

A: This problem is belong to clippers and clamper

Q: Which LED segments will be on for a decoder/driver input of ... a. 1001 b. 0011

Q: A signal s(t) is ideally sampled at a sampling rate (a) 15HZ, (b) 9Hz, (c) 10HZ. If the sampled sign...

A: a f=15 Hzfm=6 Hzfs+fm=21 Hzfs-fm=9 Hz No aliasing

Q: Dielectric barrier discharges are used industrially for the generation of ozone in applications such...

A: Dielectric barrier discharge is define as the electrical discharge between two electrode which are s...

Q: A singe tore is wed to modulate FM transmiten. The tafal power is 450 watt into los2 sichia load. De...

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you ar...

Q: Design. Let's say we want to power up an LED (diode D2) by placing it between Rc and the transistor....

Q: A 150 Ohm resistor is in series with a 300 Ohm resistor and the power supply has 150 V. What is the...

A: Power = current ^2 * resistance P= I^2* R Power is measured in watts

Q: Tdeal diodes Dz 1-5kr 3. 9. Determine Vo (-) ayde. For (+) and Vi Vo b. Draw Vo. 2.sv+ + 1av

A: This question is belong to clippers and clamper diode circuits. Analysis is to be done with differen...

Q: Determine the magnitude and phase angle of the total impedance for the circuit below. R Xc 50 Ω 1V 1...

A: Given circuit:

Q: Ex. 314. Given a unity-feedback closed loop system with a unit ramp input. Forward TF: G(s)=K * (s+1...

A: The solution is given below

Q: 9430°N are delta-connected to a balanced three-phase ae conductors with impedance Z, = j10 per line....

A: The solution is given below

Q: A 5.3 V zener is rated at 1.5 watt. The maximum zener current is equal to Select one: О а. 2.83А. O ...

A: Given data, Zener voltage, VZ=5.3 V Power, PZ=1.5 W

Q: For the ladder network in Fig. 2.104, find I and Reg- 8Ω ww 33 2 5 V Reg (+1)

Q: What is the current I in the figure below? I 3Ω 10 A 4Ω 20 V 2Ω +1

A: We need to find out the current for given circuit

Q: a. Determine at time t by how much the oscillating charge is reduced to 50% of the initial charge? b...

Q: Give reason why dc motor requires starter.

A: When a DC supply is given to a motor through brush and commutator then the commutator generates a ro...

Q: Solve for alpha(a) collector current is 6.236mA and emitter current is 6.292mA O 0.9219 O 0.9901 O 0...

Q: J. q. Determine vo for (+) and G) cy de . Si (ov 1 h. Draw Vo. E IKI V. - lo V

Q: 1. Explain the trade-offs between relays and PLCS for control Applications.

A: We are authorized to answer one question at a time since you have not mentioned which one you are lo...

Q: R. For the circuit shown, • R1 = 3.9 k2 R, R6 • R2 = 82 k2 R. R3 = 4.7 k2 R, voW R4 = 6.8 k2 R5 = 47...

A: The solution is given below

Q: From the circuit in Fig. 2.83, find I, the power dis- sipated by the resistor, and the power supplie...

Q: For the ladder network in Fig. 2.104, find I and Req· 2Ω 12 15 V 3.5 2 2Ω Reg +1

A: This question belongs to circuit theory . It is based on the concept of calculation of equivalent re...

Q: Ex. 812. A PID controller has an integral gain of 48 and a derivative gain equal to 1. What is the p...

A: The solution is given below

Question

An inductor has the folowing characteristics: Air core, diameter = 5cm 852 turns Length = 15cm Given that the permeability of air is 1.25 x 10-6, what is the inductance of this inductor? Ensure that your answer is in mH.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
Three capacitors having values of 2.2 F, 280 F, and 470 pF are connected in parallel. What is the total capacitance?
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor to a 480-V, 60-Hz line. To determine the proper conductor and fuse size for this installation, you need to know the amount of current the inductor will draw from the line. The nameplate on the inductor indicates that it has an inductance of 0.1 H. An ohmmeter reveals that it has a wire resistance of 10 . How much current should this inductor draw when connected to the line?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
4. In what form is the energy of a capacitor stored?
What is the unit of measurement for the strength of a capacitor? microamp microtorque microfarad microwatt
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?