Jack who weighs 68 kg is 45 years old and has severe hypomagnesaemia. He requires 0.26 g/kg of magnesium sulfate heptahydrate to be given intramuscularly over 4 hours. Magnesium Sulfate Concentrated Injection (2.465 g magnesium sulfate heptahydrate (MgSO4.7H₂O MWt = 246.5) in each 5 mL ampoule) is to be diluted to 40 %w/v with 0.9%w/v sodium chloride solution. Calculate the volume of 0.9% sodium chloride solution that would be required. (Answer to 1 decimal place.)

Jack who weighs 68 kg is 45 years old and has severe hypomagnesaemia. He requires 0.26 g/kg of magnesium sulfate heptahydrate to be given intramuscularly over 4 hours. Magnesium Sulfate Concentrated Injection (2.465 g magnesium sulfate heptahydrate (MgSO4.7H₂O MWt = 246.5) in each 5 mL ampoule) is to be diluted to 40 %w/v with 0.9%w/v sodium chloride solution. Calculate the volume of 0.9% sodium chloride solution that would be required. (Answer to 1 decimal place.)

Introduction to General, Organic and Biochemistry

11th Edition

ISBN:9781285869759

Author:Frederick A. Bettelheim, William H. Brown, Mary K. Campbell, Shawn O. Farrell, Omar Torres

Publisher:Frederick A. Bettelheim, William H. Brown, Mary K. Campbell, Shawn O. Farrell, Omar Torres

Chapter6: Solutions And Colloids

Section: Chapter Questions

Problem 6.36P

See similar textbooks

Similar questions

A spent 1.0 percent caustic soda solution (ρNaOH = 8.42 lb/gal) with a volumetric flow rate of 3.0gpm is to be neutralized using either sulfuric acid or hydrochloric acid. First, determine the massflow rate (lb/day) of NaOH in the spent caustic soda solution, and then use that value todetermine the stoichiometric amounts (lb/day) of:1. H2SO4 required for neutralizing the OH− ions contributed by the spent caustic soda.[Hints: (1) write the balanced chemical equation for the acid-base reaction betweenNaOH and H2SO4, and use it to establish the stoichiometric weight ratio H2SO4 : NaOH.]2. HCl required for neutralizing the OH− ions contributed by the spent caustic soda. [Hints:(1) write the balanced chemical equation for the acid-base reaction between NaOH andHCl and use it to establish the stoichiometric weight ratio HCl : NaOH.]
A sample may contain any combination of sodium hydroxide, sodium carbonate and sodium bicarbonate with inert matter. A 3.00g sample requires 57.57ml of 0.5N hydrochloric acid to reach phenolphthalein endpoint and a total of 105.4ml of acid was used until the methyl orange endpoint was reached. What is the percentage inerts in the mixture? What is the percentage sodium bicarbonate in the mixture? What is the percentage sodium hydroxide in the mixture? What is the percentage sodium carbonate in the mixture?
1. A solution of 1200 mL of water is prepared with 157 grams of NaCl and 40.0 grams of Sucrose. Find the boiling point of the solution at sea level? At 3000 ft? (MW NaCI 58, Sucrose 342)
A core sample is saturated with an oil (?o = 35oAPI), gas and water. The initial weight of the sample is 224.14 g. After the gas is displaced by water (?w = 1 g/cm3 ), the weight is increased to 225.90 g. The sample is the placed in a Soxhlet distillation apparatus, and 4.4 cm3 water is extracted. After drying the core sample, the weight is now 209.75 g. The sample bulk volume, 95 cm3 is measured in a mercury pycnometer. Find the porosity, water saturation, oil saturation, gas saturation and lithology of the core sample.
You are wanting to apply a soil conditioner to your garden. 10mL of conditioner cover 3m^(2) of your garden. However, before you use it you must dilute the concentrate by placing 10ml of Seasol in a 9L bucket. How many litres of the diluted mixture do you need to cover a garden of 80m^(2).
A 100-liter empty jar was spiked with 20 mg of TCE (C2HCl3) under room temperature condition. The jar was then closed tightly. What is the concentration (in atm.) of TCE in the air at 25 C? (TCE: MW: 131.4 g/mol; TCE solubility in water (Cs) = 1100 mg/L; Pv (pure liquid at 25oC) = 10^-1.01 atm. KH = 10^1.03 L atm mol-1; KOW = 102.42). if the jar was half filled with water and half filled with air, what were the concentrations of TCE in both air and water at 25C?
As a dialysis patient, Michelle has a 4-h dialysis treatment three times a week. When she arrives at the dialysis clinic, her weight, temperature, and blood pressure are taken and blood tests are done to determine the level of electrolytes and urea in her blood. In the dialysis center, tubes to the dialyzer are connected to the catheter she has had implanted. Blood is then pumped out of her body, through the dialyzer where it is filtered, and returned to her body. As Michelle's blood flows through the dialyzer, electrolytes from the dialysate move into her blood, and waste products in her blood move into the dialysate, which is continually renewed. To achieve normal serum electrolyte levels, dialysate fluid contains sodium, chloride, and magnesium levels that are equal to serum concentrations. These electrolytes are removed from the blood only if their concentrations are higher than normal. Typically, in dialysis patients, the potassium ion level is higher than normal. Therefore,…
6. A stock solution containing 25% w/v of chlorhexidine is used to prepare an antiseptic such that when the antiseptic is diluted 1 in 25, a 1 in 500 wash solution is obtained which is ready for use by the patient. What volume (ml) of the stock solution is required to prepare 5 litres of the antiseptic to fulfil a bulk manufacturing order?
Take the solution 10.12g, add 10mL of deionized water, and cool the solution to 0 degrees Celsius. How much CuSO4, 5H2O crystallizes out?
What is the molarity of a concentrated solution of sulfuric acid with a specific gravity of 1.84 and 95.0% by weight sulfuric acid? specific gravity = density of substance at certain temp/density of water at 4 degrees C the density of water is 0.999973 g/mL at 4 degrees celsius. Describe how to prepare 3.0 L of 0.100M. I will pipet ______ and add this to 200mL water. The solution will be stirred and diluted to 3L with water.
A 15.0% by weight solution was prepared using 90.0g of KCl and the resulting density of the solution is 1.101g/mL. (MW KCl 74g/n). volume of solution(mL)? milliosmole of solute? %w/v? weight of solvent(g? N?
What is the boiling point of the automobile radiator fluid prepared by mixing 1.02 L of ethylene glycol (HOCH2CH2OH, density = 1.114 g/mL) with 1.04 L of water (density = 1.000 g/mL)?