klenine the trans for function 66) = in the ginven systen: T()

Q: Q. 1. Transform the given vector to spherical coordinate system and evaluate it at point (3, . 4),…

A:

Q: The following test results of a single-phase step-down transformer which were measured at primary…

A: 7. It is given that: Open-circuit test: VOC=415 V; IOC=0.22 A; POC=7.64 W; Vo=240 VShort-circuit…

Q: 2. Find derivation of formula and solved example for the following circuit. Voltage Comparator…

A:

Q: H.W.leFind the laplace ransformsof the fallawing funclionS (6) sinh? at

A:

Q: Compare the frequency of the output voltage of both the half – wave and full- wave rectifiers with…

A: We need to find out output frequency of both rectifier .

Q: Q 4.12: The DC converter is used to control power flow from a DC voltage, V. = 110 V to a battery…

A: We are supposed to be answer of first question as per guildlines.

Q: 2. A 10-hp (7.46 kW), 250-V. shunt motor takes a line current of 5 A. when running light. Calculate…

A: This question is belongs to Dc shunt motors and requires kcl and power relations

Q: In the circuit below, assume the op amp is ideal. Find the equivalent resistance, Reg. seen by the…

A: Apply  KCL at non inverting terminal to find input and output relation.  Now apply KCL at another…

Q: D1.27 Reduce the block diagrams shown in Figure D1.27 to obtain the system transfer function. R(s)…

A: As per company guidelines, we are supposed to answer the first 3 subparts of the question. Kindly…

Q: The no load voltage of a 50 kW, 220 volts shunt generator in CIT Laboratory is 232 volts and rated…

A:

Q: A three-phase induction motor is supplied by a 50 Hz A.C. source and runs at 960 rev/min, evaluate…

A:

Q: A 300-kilovolt-ampere transformer bank consisting of three 100-kilovolt-ampere  transformers has a…

A: In this question,   We need to determine the full-load current in the primary? If A 300-kVA…

Q: H-w:- Fined the bilatera l Laplace transformof the signal xCt) = sin (at) u lt)

A:

Q: 6. Express v(t) in the given figure in terms of step functions. * v(t) A 15 10 5 -1 1 2 3 t -5 -10

A:

Q: 8.18.1 For the RLC circuit shown in the image below, assume the circuit has long reached steady…

A: Given data, R=18 Ω, L=1.1 H, C=0.39 F Circuit diagram is given as,

Q: 920 V Rp 2 k2 D Ipss= 12 mA RG 1 M2 V Z 1.5 V + ネ

A:

Q: Q2: a. By means of the Nyquist stability criterion (Polar plot) determine unity feed back system…

A: It is type 1 and order 3 system. Determining the phase cross over frequency.…

Q: A)-A 3-phase 400KVA, 11000/416 transformer is delta-connected on the primary and star connected on…

A: Given data: 3ϕ, 400 kVA,  11000/416 V Power factor PF=0.8 Iron loss=990 wattTurn ratio is given…

Q: For operation at 60 Hz and a given peak flux density, the core loss of a given core is 1W due to…

A:

Q: for the common -base configuration using a common value of 30 ohm for the input resistance, input…

A: The solution is given below

Q: Describe the nature of the output voltage out of half – wave and full – wave rectifiers with that of…

A:

Q: 1552 102 102 100 V 0.5 F 32H

A: Given circuit is shown below. At t<0 both switches are open. Therefore iL0-=iL0+=0=Vc0-=Vc0+

Q: D1.31 Use Mason's gain rule to find the transfer function of each system of Figure DI.31. RG) 1 R(s)…

A:

Q: The wiper of the 20 kn potentiometer in figure is positioned half way. Then the voltage V, of the…

A:

Q: Explain how to drive DC Motors!

A:

Q: The annual load factor of a power plant feeding a set of loads is 75%, the annual average load is…

A: Given: Annual load factor = 75% = 0.75 Annual average load = 30000 kW Utilization factor = 0.8

Q: Q4 \For the circuit shown in Figure below, calculate the current In and Iz using the mesh analysis…

A: The solution is given below

Q: Thermal noise is a type of noise that is produced when electrons move rapidly and randomly within a…

A:

Q: The voltage across a coil when di/dt = 20 mA/s and L = 8 H is 2.5 mv 160 mv 1.6 mV 16 mv

A: Given: Rate of change of current, didt=20 mAs Inductance, L = 8 H

Q: 4. How to use the PLL circuit and the logic circuit to comprise a doubler frequency circuit?

A: PLL circuit : PLL circuit is known as phase locked loop circuit it is an electronic circuit which is…

Q: Design the following system using one of the following technics: Technics: I 1 s2 + 8s + 10 1-…

A: The state-feedback method is a method used in the theory of feedback control system used to place…

Q: An inductor in series with a 5 uF capacitor is connected to a supply of 20v , 796Hz. What is the…

A:

Q: Which of the following is suitable for implementation in a read/write memory? A) A look up table…

A: Read/write memory: It is a volatile memory since data is lost when power is off. It allows user to…

Q: By algebraic manipulation, reduce the given Boolean expression to its simplest form and express your…

A: Given Boolean expression: Y=A'+CA'+C'A+B+C'D

Q: A balance delta load with impedances of 15-j9Ohms is connected to a three phase source by three…

A: The solution is given below

Q: Analysis of the load-voltage waveform gives a mean value of * ( Vmax)/2pi O 2( Vmax)*(1+cos alph) (…

A: The solution is given below

Q: Transducer is a device that can not convert energy from one form to another. Select one: True O…

A:

Q: A 6-pole, 500-V. wave-connected shunt motor has 1200 armature conductors and useful flux/pole of 20…

A: First calculate armature current and then find back emf. Now using back emf find speed of the motor.…

Q: the section supplies the large section of majority charge carrier is called * collector others Base…

A:

Q: Q3-Find the current through R. fr the netwoek in Figure shown below. R 342 R

A: In this question,   We need to determine the current in the resistance RL  ?  We know current I= V/R…

Q: 7.6 Special Case: Vas, = 0 V 18. For the network of Fig. 7.90. a. Find Ipo b. Determine VD, and Vpso…

A: The solution is given below

Q: Given the following proper rational function: F (s) = 6s + 12/((s2 + 4s + 5)(s2 + 6s + 5))  Find   F…

A:

Q: The expected output waveform will be:

A:

Q: What will be the Nyquist's (minimal) sampling frequency (in Hz) to recover an input signal x(t)=…

A: In this question,   We need to choose the correct options What is sampling frequency of the given…

Q: What are the different adder circuit? Briefly describe each.

A: We need to answer What are the different adder circuit and need to describe each one briefly.

Q: Comparison between induction motor and synchronous motor

A: Induction motor runs at a speed lower than the synchronous speed whereas synchronous motor runs at…

Q: 4. Find the Vout 200 mV w 24 k2 100 mV W 100 mV w 1 10 kn 24 n 200 2 S00 mV w 500 2

A: Types of Amplifier  Inverting amplifier ( output voltage opposite to input voltage) Non inverting…

Q: Q1: A single core 66 kV cable working on three phase system has a conduc diameter of 2 cm and a…

A: In this question we will find position of inter sheath and maximum and minimum stress....

Q: Cos

A: This question belongs to signal and system . It is based on the concept of Laplace transform . It is…

Q: 8.3.4 For the RLC circuit shown in the image below, if R1 = 10 S2 and R2 = 3 S2, C = di (0*) 0.23 F,…

A: We need to find out rate of change of inductor current at initial time.