Logic gate No. 3 E
Q: Vcc +20 V LIST THE CAPACITANCES THAT AFFECT THE LOW-FREQUENCY Rc 2.2 kn R 33 kfl Be = 150 Ch = 4 pF ...
A: BJT BJT is the current-controlled device because the base current controls the devices. BJT is th...
Q: QUESTION 3 When performing math functions, care must be taken to ensure that the values remain in th...
A: When performing math functions, care must be taken to ensure that the values remain in the range tha...
Q: Two equal valued resistors dissipate a power of 100W. The resistors are connected in? choices seri...
A: Given: Two equal valued resistors dissipate a power of 100W. Then The resistors are connected in?
Q: 1. Calcule los voltajes Vg, Vg, Vc, Vce,Vout , la corriente Ic y la ganancia A, del siguiente circui...
A: The given circuit is a common collector amplifier the required parameters can be calculated by using...
Q: 1. A certain communication system is defined by following impulse response n h(n) = и(п) + и(-п - 1)...
A:
Q: 6- Design a beta-independent (voltage-divider) circuit to operate at VCEQ = 8 V and ICQ supply of VC...
A:
Q: no. 000 AWG wire is 100 meters long. For no. 000 wire, it has a wire resistance of 0.0618 ohms per 1...
A: In this question , we will find power loss in given AWG wire resistance length and current flowing t...
Q: A 4600 to 230 Volts, 60 Hz step down
A:
Q: a) Is it ON delay (TON) or OFF delay timer (TOF)? b) Timer base value c) Preset value d) Accumulated...
A: Timers are typically used to control a circuit for a set period of time. We can delay the operation ...
Q: A 30 kW, 300V d.c. shunt generator has armature and field resistances of 0.05 0 and 100 0 respective...
A: It is given that: V=300 VP=30 KWRa=0.05 ΩRsh=100 Ω
Q: A sinusiodal voltage having maximum amplitude of 680 V is applied to the terminals of 65 Ohm resisto...
A: Please refer the attached images for the complete answer..
Q: 33 LABUI レIIルし RC Co PRE-LABORATORY ASSIGN MENT 1. In a circuit such as the one in Figure 33-1 with ...
A:
Q: What value of capacitance is required to produce 50 2 of reactance at 450 MHz?
A: To solve above problem, one should know how to find equivalent capacitance for series and parallel c...
Q: 2.26. Using only the Fourier transform of the unit im- pulse function and appropriate transform theo...
A: As per company guidelines we are supposed to answer only one question. Kindly repost other questions...
Q: 1ms/div Question 3: What did you observe on the output waveform (PR2) compare to the input waveform ...
A: In this question, We need to what did you observe on the output waveform (PR2) compare to the input ...
Q: no. 000 AWG wire is 100 meters long. For no. 000 wire, it has a wire resistance of 0.0618 ohms per 1...
A: In this question AWG wire is given...We have to find out power loss due to current and due to this p...
Q: A 400V, 3-phase Induction motor has input power of 16 KW and operates at power factor of 0.87 laggin...
A: Given: A 400 V, 3 phase induction motor having Input power, Pin=16 kW Power factor, cosϕ=0.87 laggin...
Q: A appropriate op-amp circuit with a gain of +100 is required for the ultrasonic device. Create a two...
A:
Q: An AM transmitter has a 1-kW carrier and is modulated by three different sine waves having equal amp...
A: If the carrier is modulated by multiple input signals then the total modulation index is the square ...
Q: a. For the circuit shown below, load resistance is 180 ohm, determine load voltage, the resistance V...
A:
Q: A big PCB manufacturing and assembly factory has collected manufacturing data as shown in Table Q2(b...
A:
Q: In an Alternating Current Electricity with a voltage source rated 230 volts, 3 electrical appliances...
A: DC is not the only "type" of electricity in use, despite how convenient and simple it is. Certain en...
Q: 20 120 v 15 A Fig-
A: Given
Q: A load resistance of 250 £2 needs to be supplied with 12V. A 45V voltage source and a resistor of an...
A: The available supply voltage is 45 Volts. The voltage across the load resistance is 12 Volts. The ...
Q: Ri R2 Nor Si Si
A:
Q: 2. Calculate the total resistance of the circuit below and its total current. R1 3 R4 6 R7 9 R5 12 R...
A:
Q: The transformation ratio therefore is: 200 2 20.6 20
A: Given : a step down transformer Primary side voltage = 4600 v And secondary side voltage = 230 v
Q: Let {A1, B1, C1, D1} and {A2, B2, C2, D2} be realizations of the transfer functions G1(s) and G2(s),...
A: The realizations for the transfer functions G1(s) and G2(s) are,G1(s) =[A1, B1, C1, D1]andG2(s) =[A2...
Q: (b) Your team is working on a new walkie-talkie design that must be able to withstand harsh weather ...
A: It is asked to choose the suitable type of material that should be used as the casing of a walkie-ta...
Q: A 60 W power transistor is to be cooled by attaching it to a heat sink. Calculate the maximum therma...
A: Thermal resistance = (temperature difference)/ power loss. Use above formula to find maximum thermal...
Q: What did you observe on the output waveform (PR2) compare to the input waveform (PR1)? What type o...
A: In this question, What did you observe on the output waveform (PR2) compare to the input waveform (P...
Q: A source delivers an AC voltage of the form AV = 198 sin( 51 nt), where AV is in volts and t is in s...
A:
Q: Derive the general equation of polarization E E E E 2E E -cos 8 = sin? 8 E, E,
A: To derive the general equation of polarization
Q: A sinusiodal voltage having maximum amplitude of 680 V is applied to the terminals of 65 Ohm resisto...
A: This question belongs to circuit theory . It is based on the relation between r.m.s. and maximum val...
Q: 59. Which of the following is the most probable impedance of a 100MW alternator? а. 5% b. 100% с. 10...
A: An alternator is an electrical generator that converts mechanical energy into alternating current el...
Q: Consider the following circuit diagram: 3 V 2 V 20 kN 15 V 20 ΚΩ - 40 k2 R 160 k2 ov. -15 V What is ...
A: Given
Q: An oven takes 15A at 240V.It is required to reduce the current to 12A.Find a). the resistor which mu...
A: Given: Current taken by oven, I=15 A Supply voltage, V=240 V Required current, I'=12 A
Q: (a) Fonsider a cross-section of a single-conductor cable as shown in Figure 1. The conductor occupie...
A:
Q: 36. A proton is confined in a uranium nucleus of radius 7.2 X 10-15 m. Determine the proton's minimu...
A: Strategy: Let’s assume the minimum proton momentum is equal to that determined by the uncertainty pr...
Q: The simplest electric circuit (2 * contains only parts Two Three Four Five None of the above The res...
A:
Q: R, 10uF Emitter - follower CE amplifier i ka 10uF 4- 50 k2 2,-12 k2 R222 ka 2-4.6 ka 640 Z- 202
A: We are authorized to answer three subparts at a time since you have not mentioned which part you are...
Q: Qó: a) Draw circuit (window detector) to achieve output (high) between 3V and 5.5 V if Vcc = 10V. b)...
A:
Q: Design a gate-level implementation for the following expressions using the specified gate types. Use...
A: NAND AND NOR NAND and NOR are called universal gates because any logic functions can be implemen...
Q: Q2) Given x(t) = 6sin(2n200t), find and sketch its power spectral density.
A: Given x(t)=6sin(2π.2000t), we need to find and sketch its power spectral density.
Q: Prob.1. An air condenser of capacitance 0.005 µF is connected to a DC supply of 500 V. It is then di...
A:
Q: Discuss the mechanism of a short circuit and how it can lead to accident
A: Short circuit- Electrical current always try to flow least resistive path. Hence in case if insulati...
Q: 2.26. Using only the Fourier transform of the unit im- pulse function and appropriate transform theo...
A:
Q: 2. what is the maximum input voltage in Figure 1 to maintain the output voltage to 10 V without dama...
A: At maximum source voltage , zener diode will draw maximum current .
Q: The transfer function of an LVDT is 2 mV/mm and the maximum core motion is +14 cm. From +1 cm to +12...
A:
Q: 3. Find the transfer function 0(s)/T(s) of the circuit. I N-m'rad I kg-m IN-m-s'rad
A:
Step by step
Solved in 4 steps with 1 images
- Find the boolean algebraic expression and simplify!Construct the truth table for the Full Adder and show the standard Sop expressions for theoutputs. Use the Boolean algebra to simplify the output expressions and draw the simplifiedcircuit.can you please write a truth table for the circuit. Derive Boolean expression for all output. ,, and i will be thankful to you
- Draw a logic circuit for (A + B)C. For a special case B=C, create truth table for this expression. What value did you get? Compare your result with the list of Boolean Algebra identities.Please draw the logic circuit for the Boolean expression, attached. Do not simplify the expression.Q1\Convert the following Boolean expression to a circuit. F=(A' * B' +(C' + A))'?
- Fill in the F column and derive a Boolean expression.For an n-variable boolean function, what will be the maximum number of prime implicants? Please explain.Construct a karnaugh map for the given boolean expression without constructing a truth table . Also explain how the position of the minterm for which the output is 1 is known . The answer should come like this .As I tried according to how you explained the answer but got a different karnaugh map than the answer . So please explain.
- Using Boolean algebra theorems, simplify the logic expression above as far as possible. Create a Circuit Diagram for the new expression Then create a truthtable for the simplified circuitWrite the Boolean expression equivalent to the following logic circuit. Do not simplify!Write a truth table for each circuit. Derive Boolean expressions for all outputs. Thank you so much .