Loop! +) 3.3A =212 22 www loopt SEIMO Toep 3 30.3262 -26V floop 4 0.80SA 30.22 Ź 9.3V

Q: Current through ammeter A2 and A3 in the figure below are 1/100 and 1/700 The reading of ammeter A1…

A: AC network given is, Here, I2=1∠10° A and I3=1∠70° A.

Q: 1. What is the role of the current transformer and voltage transformer? ➤ 2. Draw a CT and PT…

A: There are three different independent questions.

Q: In series R-L circuit, R is 10 ohm and L is 20 mH. If the circuit current is 10sin(314t) A. The…

A: In series RL circuit, R=10 Ω, L=20 mH,it=10sin314t A.

Q: An RLC-serial resonance circuit can be used as a band-pass filter. Find out how the filter works.…

A:

Q: 3.3 The characteristic equation of a closed loop control system is s³ + 3Ks² + (K+2)s + 4 = 0. Find…

A: The characteristic equation is given as, s3+3Ks2+K+2s+4=0

Q: 1. Calculate the frequency for each of the following values of cycle time(period): (b) 0.1 s (a) 10…

A: a) Time period of cycle time, T=10 s. b) Time period of cycle time, T=0.1 s. c) Time period of cycle…

Q: B: A three phase transmission line with 65 km long, 50 Hz. Each phase has a conductor of 0.83 cm as…

A: Given: Line Length = 65kmfrequency (f) = 50 HzConductor Diameter (D) = 0.83 cmConductor Radius (r) =…

Q: Given the electric flux density, D = 2xyax +4x²y²ay + 6z³az C/m². Use Gauss' law to evaluate the…

A:

Q: An AC voltage source is connected to a circuit. The current in the circuit leads the voltage by 90°.…

A: We need to select correct option for given statement .

Q: Q3) For the following ideal Op amp: a) What op amp circuit configuration is this? b) Calculate Vo 25…

A:

Q: d³c dts A) Finde the transfer function B) Obtain the state-space form dr +6c = 2 +3r dt The system…

A: In this question we need to find the following Transfer function of the given system State space…

Q: 10.3.4 Find all currents and voltages in the network in Fig. P10.3.4. 12/0° V + I 1Ω + 1:2 Ideal +…

A: In this question we need to find all current and voltage is the given network.

Q: Determine the phase angle by which v1 (t) leads i2(t), where v1(t)=4 sin (377t+37°) V i2(t)=-0.1 sin…

A:

Q: Consider the circuit shown below. The circuit is in steady state prior to t=0. (a) What is e(t > 0)?…

A: The circuit is at steady state prior to t=0 Only current source will be present in steady state. at…

Q: A 3.3kV, 20-pole, 50Hz, three phase star-connected induction motor with a slip-ring rotor runs at a…

A: Number of poles p =20 Voltage V=3.3 kV Frequency f = 50 Hz Speed Nr=294 rpm Reactance X2=0.28…

Q: OP-AMP TEST EX Determine the output voltage Vo of the Circ 2mA (↑) www. lok usu www dok 5k lok 9+ 2…

A:

Q: Q4) For the following ideal op amp: Va a) What op amp circuit configuration is this? b) Find an…

A: In this question we need to find the following What op amp circuit configuration is this ?…

Q: a) Find v. b) Find the power absorbed in the resistor. c) Reverse the direction of the current…

A: Circuit diagram is given as,

Q: You visited Greece and bought a 157 W light bulb there. The operating voltage in Greece (and most of…

A:

Q: 4. For the circuit of Fig. 20.51: a. Find the value of L in millihenries if the resonant fre- quency…

A: As per the guidelines of Bartleby we suppose to answer first three subpart only for solution of…

Q: Express the function below using window and step functions and compute its Laplace transform. 2190 Q…

A: In this question we need to find the expression of g(t) from the given graph and find its Laplace…

Q: Find the frequency-domain impedance Z, as shown in Fig. P8.8. (W=5, L=6) Z->> Figure P8.8 13.26/90°…

A:

Q: Create a circuit in Logisim that implements the Boolean expression: F(A, B, C, D, E) = AÐBOCODØE

A: The given boolean expression needs to be implemented in the logisim simulation software.

Q: 3. Find the Energy for the following signal x(t) = u(t-2)-u(t-4): A. 4 B. 2 C. 0.5 D. 6

A: Function is given as, xt=ut-2-ut-4.

Q: how grid system is important in the operation of a power system.

A: A grid system, also known as an electrical grid, is an interconnected network of transmission lines,…

Q: G₂/ 0011100110 Q2/ (manchester 27 polar NRZ.L 3) unipolar RZ

A: Given,  Binary data = 0011100110; We need to represent the given data in the following line coding…

Q: A DC chopper has a resistive load of R = 102 and an input voltage of Vs = 220 V. When the chopper…

A: DC chopper - A DC chopper is a power electronic gadget used to change a decent DC voltage over…

Q: IREF=2mA, (W/L)1=4 (W/L)2=2 (W/L)3=5 (W/L)4=15 R=2kOhm VDD=24V What is Vx? ал Answer: _V002 ILEF Fyl…

A: Given IREF=2mA (W/L)1=4 (W/L)2=2 (W/L)3=5 (W/L)4=15 R=2kohm VDD=24v We need to find the value of Vx…

Q: D Find the total energy dissipated in the 120 and 270 12 resistors Express your answers in joules to…

A: The total energy dissipated in the 120Ω and 270Ω resistors needs to be calculated by using the…

Q: 1. [Adapted from Final Exam 2019] Draw the differential-mode and common-mode small-signal AC…

A: The circuit diagram is shown below,

Q: A 20-KVA 8000/480-V distribution transformer has the following resistances and reactances: Rp= 32 Q…

A:

Q: Q2] In LTI system, the output of the system will be y(n) = {1,0,1,0,1} when its input x(n) =…

A: Given, An LTI system is having, Output, y(n) ={1,0,1,0,1} when input is x(n) = {1,1,1}. We need to…

Q: a 18V- 1092 b 2592 с 50Ω [2] A A 2592 www 210Ω 13 UQ d Solve the mesh currents (1₁, 12, and 13) in…

A: In this question We need to determine the mesh currents.  We are solving this problem using the mesh…

Q: What is the disadvantage of FR4? What is advantage of using ceramic substrates in PCB?

A: INSULATING STABILITY Insulating stability refers to the ability of an insulating material to…

Q: 6. Complete the timing diagram for the shown inputs sequences in Figure 14. 00111001 A Dax 10100100…

A:

Q: transfer function

A:

Q: Q.) A 200,000 VA transformer has an impedance of 5% and a power factor of 0.85. The primary voltage…

A: Given, A transformer with S=200,000 VA % Impedance, Z=5% % Power factor, %cosϕ=85% Primary voltage,…

Q: x(t) = 6e-¹¹u(t) h(t) = (-7e²t -9et 2e-³¹)u(t) Compute y(t) = x(t-3)* h(t-5) x(t) is convoluted with…

A:

Q: Graph the following signals: 4u(t); – 10u(t); 2u(t−4) ; 7u(6 −t)

A: In this question we need to draw the following signal  4u(t)  -10u(t)  2u(t-4) 7u(6-t)

Q: Q2: A:A three-phase transmission line with 1.955 cm diameter conductor, the corona takes place if…

A:

Q: 8. You have a 200kVA single phase transformer (shown below). It is 12kV to 120/240 volts. AØ CP o

A: The single phase transformer is shown below, Here,SkVA=200 kVA.V=12kV to 120/240 V.

Q: QUESTION 1 Realize the following plant transfer function using operational-amplifier circuit. I…

A: Given Data: A plant transfer function of, Gps=1s+1s+3 To Find: Realization using Op-Amp

Q: 1Ω 1Ω 1Ω 1Ω 202 2Ω 202 ΖΩ 10 12V 202 Get the total resistance, using Delta to Wye 1Ω 1Ω 1Ω 1Ω 1Ω

A:

Q: The rectangular coil shown in the figure below is in a magnetic field with B = 0.05(x + ŷ) T. Find…

A:

Q: 2) a)For the following circuit find the total capacitance and inductance and hence find the total…

A: The given circuit diagram is shown below,

Q: Q3] Find the output y(n) of the system h(n)= u(n)-u(n-3) if its input x(n)=()"u(n), by using a) y(n)…

A: CONTINUOUS AND DISCRETE-TIME SIGNALS: Because a signal is a function, we truly mean continuous-time…

Q: 02A 1.11 A 0.344 A 10 V O 0,5 A + O Different answer 5Ω www Ā Khi 15 Ω Assume ideal diodes. Find the…

A: In this question,  We need to determine the current in the 15 ohm resistance.  didoes are ideal so…

Q: 4. Consider the circuit shown in Fig. 4. a) Find Lo b) Verify the value of i, by showing that the…

A: Electricity created by an electrical energy source, such as a generator, solar panel, or battery, is…

Q: Q4) Consider the system below. x[n] h₁ [n]=88[n-1] h[n] h₂[n] = a"u[n] a) Find the impulse response…

A:

Q: . Determine the Fourier transform of the following signals the result if it is real valued: (a) f(t)…

A: Given Data: Continuous Time-signals of, ft=5cos5t+3sin 15t xt=cos26t yt=e-2tut*cos2t zt=1+cos…

Types of Thyristors

With four layers of alternating P- and N- materials, a thyristor is a solid-state semiconductor device. It acts as a type of bi-stable switch and it conducts when the gate receives a current trigger and continues to conduct until the voltage is reverse biased across the device or by some means until the voltage is removed. The silicon-controlled rectifier is considered synonymous with thyristors by some sources. Thyristors are defined as more complex by other sources as it contains at least four-layer of alternating N-type and P-type substrate. They find large applications in the control of electrical power supplies, electric motor speed control, and ranging of light dimmers because thyristors can control large amounts of power supplies and voltage with a small device. The circuit symbol of the thyristor is given below.