Loss tangent is a standard measure of lossiness in a dielectric which is typically used to classify a dielectric material as or А. a good dielectric (tan & << 1), a good conductor (tan & >> 1) В. a good conductor (tan & << 1), a good dielectric (tan & << 1) C. a good conductor and a good dielectric (tan & << 1) D. All the above

Loss tangent is a standard measure of lossiness in a dielectric which is typically used to classify a dielectric material as or А. a good dielectric (tan & << 1), a good conductor (tan & >> 1) В. a good conductor (tan & << 1), a good dielectric (tan & << 1) C. a good conductor and a good dielectric (tan & << 1) D. All the above

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

2. A lossy material has μ=5μ0, ε=2ε0. If at 5MHz, the phase constant is 10 rad/m, calculate; The loss tangent Conductivity of the material The complex permittivity The attenuation constant The intrinsic impedance
The ratio of the inner conductor perimeter to the outer conductor perimeter of a coaxial cable is 0.4993 and how many structure capacitance pF/m is the insulated coaxial line?
A lossless coaxial cable transmission line has L = 200 uH/ft and C = 100 nF/ft. The inner diameter of the outer conductor is 3cm and the diameter of the inner conductor is 1cm. What is the dielectric constant of the insulator?
It is desired to construct uniform transmission lines using polyethylene (εr = 2.25) as the dielectric medium. Assuming negligible losses, find the distance of separation (in mm) for a 308 Ω two–wire line, where the radius of the conducting wires is 0.6 (mm).
A lossless coaxial cable transmission line has L = 200 uH/ft and C = 100 nF/ft. The inner diameter of the outer conductor is 3 cm and the diameter of the inner conductor is 1 cm. What is the dielectric constant of the insulator?
A parallel-wire transmission line has separation between conductors equal to four times the conductor diameter. If the dielectric material separating the two conductors is Foam Polystyrene with a velocity factor equal to 0.91, what is the characteristic impedance of the transmission line?
The geometric mean radius of the conductor in a 380 kV, 120 km long transmission line 24mm. The roughness factor of the conductor is 0,98. Geometric mean length between phases of conductors 3,2 m. Air pressure across the line 725 mmHg, temperature 18 degrees Celcius and the conductor surface temperature is 85 degrees Celsius.According to this,a) Calculate the voltage at which ionization starts and the corona voltage.b) Find the corona loss for operating voltage with Peek formula.c) Calculate the total corona loss of the line with the Peek formula for a 15% increase in operating voltage.
In a lossless medium for which η = 30 π, μr = 1, and H = -0.1 cos (ωt-z)ax +0.5 cos (ωt-z)ay A/m, calculate εr, ω, and E.
It is viewed from the cross-section of a coaxial cable consisting of a cylindrical conductive tube with an internal radius R and an outer radius of Rz wrapped around a cylindrical conductive wire with a RADIUS of R. r to indicate the radial distance from the center, the inner cylindrical conductor,if it is j1 = Gr and the outer conductive tube, j2 = Car has improper current densities. Here, the two conductors carry the same I flow in zit directions. What is the size of the B2 magnetic fields at r=1 cm and B2 at r= 8 cm?(R=4 cm; R=7 cm, R3=9 cm; Io=2 A; uo=47.10-7 T.m/A and our aquani-positive forehead outward from the page plane).
1. We have a two-wire overhead transmission line, powered by a constant voltage source of 700 V. The values for the inductance of the conductors are 2.348x10-3 H/km and the capacitance values are 6.325x10-9 F/km. Assuming an ideal (lossless) line and its length of 130 km, determine the speed at which it propagates. PLEASE MAKE IT DIGITAL BECAUSE HAND WRITING GETS UNDERSTANDING
A lossless parallel-plate transmission line having a characteristic impedance 50 is terminated with an impedance (40+30) Q at an operating frequency of 200 MHz. The dielectric constant of the insulator is 2.25 and its thickness is 0.4 mm. Find (a) the width w of the metal plates, and (b) the reflection coefficient at the load.
PROBLEM SOLVING NO. 1: A Three-Phase, 75 KV, 50 Hz Transmission Line consists of 0.44 cm radius conductors spaced at 1.2 meters apart in an equilateral triangular formation. If the Temperature is 34°C and Atmospheric Pressure is 75 cm of Hg, calculate the Critical Disruptive Voltage at which Corona occurs. Take m0 = 0.83.