Macmillan Learning Pressure (atm) Mass (g) Syringe Volume (mL) Temperature (°C) 1.05 0.127 9.10 21.5 1.10 0.133 18.20 21.5 1.15 0.139 27.30 21.5 1.25 0.151 45.50 21.5 1.35 0.163 63.70 21.5 1.45 0.175 81.90 21.5 Using Excel, plot total volume (y-axis) versus number of moles of methane (x-axis). What is the slope (m) and y-intercept (b) the trendline? slope: m

Macmillan Learning Pressure (atm) Mass (g) Syringe Volume (mL) Temperature (°C) 1.05 0.127 9.10 21.5 1.10 0.133 18.20 21.5 1.15 0.139 27.30 21.5 1.25 0.151 45.50 21.5 1.35 0.163 63.70 21.5 1.45 0.175 81.90 21.5 Using Excel, plot total volume (y-axis) versus number of moles of methane (x-axis). What is the slope (m) and y-intercept (b) the trendline? slope: m

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter8: Properties Of Gases

Section: Chapter Questions

Problem 75QRT

See similar textbooks

Similar questions

a Table: (This is an example of what your data table should look like.) Pressure (kPa) Temperature (°C) Temperature (K) Constant, k(P / T or P•T) Ice water bath 91.58 2.4 275.55 Room temperature 96.54 21.1 294.25 Warm water 104.11 44.5 317.65 Boiling water 113.75 77.5 350.5 Calculations: One way to determine if a relationship is inverse or direct is to find a proportionality constant, k, from the data. If this relationship is direct, k = P/T. If it is inverse, k = P•T. Choose one of these formulas and calculate k for the pairs in your data table (divide or multiply the P and T values). Record the answers in the fourth column of the Data table. How constant were the values for k you obtained in Question 4? Good data may show some minor variation, but the values for k should be relatively constant. Comment on your calculated k values. Analysis Questions: What does temperature measure? Look at your graph. What type…
Physics for Engineers (Answer only. No long explanation needed. Rate will be given) A beaker of very small mass contains 400 g water at 80 degrees. How many grams of ice at -20 degrees must bbe dropped into the water so that the final T of the system will be 50 C? c of water = 1cal/g C; c of ice = 0.50 cal/g C; Lf of water = 80 cal/g a. 92.30 g b. 85.71 g c. 133.33 g d. 200.00 g
There are two particles, one is heavy and the other is light. The light particles diffuse faster than the heavy particles. This relationship is known as Graham’s Law of Effusion. Since both gases are at the same temperature, they must have the same average kinetic energy (½ mv2), where m is mass and v is the velocity (like speed). Since both gases have the same average kinetic energy, you can state that ½ mLvL2 = ½ mHvH2. Multiplying both sides by 2 gives you mLvL2 = mHvH2. Rearranging the equation to get both masses on the same side of the equation will give you mL/mH = VH2/VL2. In 3a and 3b, you probably noticed that the heavy gas particles took twice as long to diffuse as the light gas particles. This means that the light gas particles are moving twice as fast, VH/VL = ½. Therefore, VH2/VL2 = ¼. How many times heavier is the heavy gas compared to the light gas? If the light gas was Ne, what would be a reasonable identity for the heavy gas?
Chemistry I gathered all my data just need some help Table 1: Gas Molar Volume Data Trial Pressure (atm) Temperature (K) Reactant Mass (g) Water Displaced (L) 1 (NaHCO3) 1.0073107 294.9278 1.4g 0.19 L 2 (NaHCO3) 1.0073107 295.372 1.1g 0.185 L 3 (Na2CO3) 1.0073107 295.3167 1.2g 0.175 L 4 (Na2CO3) 1.0073107 295.2611 1.2g 0.17 L 1.Show your calculation for the molar volume of CO2 from Trial 1 according to your experimental data. 2.Show your calculation for the molar volume of CO2 from Trial 2 according to your experimental data. 3.Show your calculation for the molar volume of CO2 from Trial 3 according to your experimental data. 4.Show your calculation for the molar volume of CO2 from Trial 4 according to your experimental data. 5.What is the average experimental molar volume of the gas of all 4 trials? 6.What is the percent error in your calculation?
Composition of Dry Air at Sea Level Gas Mole% N2 78.084 O2 20.946 Ar 0.934 CO2 0.0345 Ne 0.00182 He 0.000524 CH4 0.000168 Kr 0.000114 A) Using data from the above table, calculate the partial pressure of Kr when the atmospheric pressure is 1.07 atm.My answer: 1.22×10-6 atm B) At the same atmospheric pressure, if the temperature is 22°C, how many Kr atoms would there be in 310 mL? ??? (Having trouble on this question)
A 0.2121-g sample of an organic compound was burned in a stream of oxygen, and the CO2 produced was collected in a solution of barium hydroxide Ba(OH)2. if 0.6006 g of BaCO3( 197.3 g/mol) was formed as precipice, Calculate: (write the answer without unit with 2 digits after decimal point) 1) mMoles CO2 2) the percentage of carbon(12 g/mol) in the sample (%C) CO2 + Ba(OH)2 BaCO3 + H2O
If the molecular weight of air is 28.9,what is the density of air at atmosphericpressure and a temperature of 368.7 K?1 atm = 1.013 × 10^5 N/m2, the mass ofa proton is 1.67262 × 10 ^−27 kg , Avogadro’snumber is 6.02214 × 10 ^23 mol−1and k =1.38065 × 10^ −23 N · m/K .Answer in units of kg/m3.
If 141.5 mL He balloon rises in altitude from sea-level where the pressure is 1.00 atm to 789ft. where the pressures is 284 torr, what is the volume of the balloon at this altitude? Round your answer to 1-decimal place and be sure to use the correct abbreviation for the UNITS
Question 12.A sample of Hydrogen occupies 80.0 mL at 27.0 oC. Calculate the final volume when the temperature rises to 77.0oC. The final answer is...use the G.U.E.S.S. Method formate V2 = Unit = Blank 1: Blank 2: Please make sure that you convert all temperature readings to Kelvin (K = C + 273). Please make sure to double and triple check your sigfig when entering your answers. All answers should be entered in standard notation (not scientific notation). Please be sure to capitalized the correct letters in your units.
A student constructs a simple constant volume gas thermometer and calibrates it using the boiling point of water, 100°C, and the freezing point of a specific brine solution, -17°C. The pressures measured at the calibration points are 1.366 atm and 0.9267 atm, respectively. **when explaining please use math symbols & equations rather than typing it out, gets confusing if something is in a fraction or whatnot. Thank you!
The compressibility factor Z = PV/nRT for O2 at -38.6°C and 519.6 atm is 1.60; at 162.8°C and 105.4 atm, it is 0.99. A certain mass of oxygen occupied a volume of 2.10 L at 162.8°C and 105.4 atm. Calculate the volume occupied by the same quantity of oxygen at -38.6°C and 519.6 atm. place the answer rounded to the hundredths place Please provide only typed answer solution no handwritten solution needed allowed
The volume of the mixture prepared by taking 1.158 mol and 0.842 mol of water and ethanol, respectively, was measured as 68.16 cm3 at 25 ° C.Since the partial molar volume of water in the mixture is 16.98 cm3 / mol, find the partial molar volume of ethanol.Since the densities at 25ᴼC for pure water and ethanol are given as 0,9970 g / cm3 and 0,7852 g / cm3, respectively, find the volume change during the preparation of the mixture and interpret the result. (MSu: 18 g / mol; Methanol = 46 g / mol)