Magnitude of current at resonance in R L C circuit a. depends upon the magnitude of R b. depends upon the magnitude of C c. depends upon the magnitude of L d. depends upon the magnitude of R, L and C.

Magnitude of current at resonance in R L C circuit a. depends upon the magnitude of R b. depends upon the magnitude of C c. depends upon the magnitude of L d. depends upon the magnitude of R, L and C.

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter22: Magnetism

Section: Chapter Questions

Problem 16CQ: Verify than the direction of the line force in an MHD drive, such as that in Figure 22.32, does not...

See similar textbooks

Related questions

Q: What happens when the loop encloses no current? What happens when the loop encloses both positive…

A: Let Ampere's circuital law is applied to an ideal solenoid.

Q: Parallel Circuit R1 Voltage = 240 Volts R2 45 ohm R3 360 ohm 120 ohm R1 Current = R1 Power = B R2…

Q: 94. Consider the circuit below. (a) What is the initial current through resistor R2 when the switch…

A: "As per the guidelines i solved the first three sub parts". (a) The initial current through resistor…

Q: Find the total current of the following circuit. R1 R2 R3 36 V 12 2 12 0 120 O 1) (36+36)amps 2) 36…

A: Given data: Three equal resistors are connected in parallel combination R1 = R2 = R3 = 12 Ω Battery…

Q: 19. The figure below shows a current-carrying wire and a circuit containing a resistor R. (a) If the…

A: Current carrying in the straight long wire = I Resistance of the loop = R

Q: The switch S in the circuit shown below has been open for a long time when, at time t = 0, it is…

A: Given: R1 = 110 ohm R2 = 220 ohm R3 = 330 ohm C1 = 40 microfarad C2 = 80 microfarad

Q: 1) A voltage is varied in a primary solenoid with 2900 +/- 100 turns of coil. The length of the…

Q: The 5 cables in the figure are perpendicular to the screen and in the directions shown in the…

Q: In the circuit below, assume that the current directions are as shown. Also, traverse the loops in…

A: (b) the same as

Q: Problems for Electric Current 23-1. A wire carries a current I. An amount of charge q moves past a…

A: Given:- A wire carries a current I. and the charge q moves past a point in the wire Find:- a)…

Q: For the following circuit R1 = 55 2, R2 = 120 Q, R3 = 160 consumed by R1· [6] R2

A: GivenR1=55 ΩR2=120 ΩR3=160 ΩVsource =22 V

Q: Calculate dI₃/dt.

Q: d k S Δν The circuit in figure consists of two identical parallel metal plates connected by…

A: Given data: Voltage, V=100 V Surface area of one plate, A=1778 m2 Distance of separation, d=10…

Q: In the circuit shown the branch current I3 = 2A. What is the correct loop equation for the left…

Q: 3. In the circuit of the figure shown, ɛ = 1.2 kV, C = 6.5 µF, R1 = R2 = R3 = 0.73 MO. With C…

A: Given that:- E=1.2kV

Q: urses For the below circuit, find Req across the source in KO. 3 kn 5 kng 4 kN 3 mA 10 kΩ 7 kn3…

Q: "In the RLC circuit of the following figure: R = 100 N , C = 0.1 µF, and L = 0.5 Henry. QUESTION 24…

Q: If the currents are in the same direction for a pair of parallel running wires, the currents on the…

A: Given Icm=5mA Idm=150mA d=4mm s=20mm

Q: Problem 6: An RL circuit is shown on the right. L 2.4 H. R 49 Ω.e 7.5 V Part (a) Switch A is closed…

A: When Switch A is closed and B is open, it is a simple RL circuit with a dc voltage source. Thus, the…

Q: Validity of Ampere's Law. In which of the following systems does Ampere's law apply? Consider that a…

A: Ampere's law gives the relationship between the current and the magnetic field that is created by…

Q: Şkildeki 7 kablo ekrana diktirler ve şekilde gösterilen yönlerde; I, = 1, = I = 1,0 A ve 1, = I; =…

Q: Copper conductors can withstand one ampere (rms current) for ____ seconds for every 42.25 circular…

Q: 67. The figure shows the cross-sections of three long vertical wires that pass through the corners…

Q: ia Rg ER2 R, R R3 1a) Figure shows a circuit whose elements have the following values: E, = 2.0 V,…

A: Given ε1=2V ε2=3V ε3=4V ε4=5VR1=3Ω R2=3Ω R3=1Ω R4=4Ω R5=5Ω

Q: R3 4. In a parallel circuit, there is more than one loop or pathway so charge flow gets split up or…

A: Given: Three resistance in parallel. Voltage = 6 V. Formula used: V = IR. Here, R is the equivalent…

Q: 3. In the circuit of the figure, ɛ1 =1.5 kV, C = 6.0 µF, R1 = R2 = R3 = 0.82 MQ. With C completely…

A: In RC circuit, at t=0 the capacitor will act as a short circuit. Equivalent resistance = R1 + 0.82/2…

Q: 9. What would be the implication if your curled fingers have the same direction with the induced…

A: 9)If curled fingers are in direction of induced current and induced emf, then it doesn't have any…

Q: Two conductors of equal length (1), radii r and 2r, and a third conductor with length 21 and radius…

Q: resistor R is connected between two parallel conducting rails separated by 39 cm, as shown in the…

Q: 3. In the circuit of the figure, &1 =1.5 kV, C= 6.0 µF, R1 = R2 = R3 = 0.82 MQ. With C completely…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: The switch S in the circuit shown below has been open for a long time when, at timet = 0, it is…

Q: R1 Loop 1 R2 R3 Loop 2 R5 Loop 3 R4 V1 Set the DC source voltage to 10.0 V. Set RI = 85 N, R2 = 60…

Q: R, R, I2 R, V, I3 Select all loop rules that apply to this circuit. SELECT ALL THAT APPLY A. 0 = -V1…

Q: R2 tn the circuit shown above, the battery supplies a constant voltage V when the switch S is…

Q: 14. Consider the following circuit. Rc3 RA RB Rp RA = 2 2, RB =2 2, Rc = 4 Q, and Rp =7 2. a) Find…

Q: 2.2.1 Find current ls, l2, la and la for the below circuit. 2.2.2 Potential difference between a and…

Q: A capacitor is charging in a simple RC circuit with a dc battery. Which one of the following…

A: Given that a capacitor is charging in a simple RC circuit with a dc battery. We have to find that…

Q: Q2 : If you increase the EMF of the used power supply , what will happen to the time constant & the…

A: Time constant remains unchanged and maximum current increases.

Q: 18. I| A wire with a resistance of 3.2 N is bent into the two-loop shape shown in Figure P25.18. The…

Q: A capacitor is connected to an alternating voltage. The current in the circuit varies with time as…

A: Given Information: Applied voltage →Alternating Current obtained →Alternating Device →Capacitor

Q: 3) Figure shows a RL circuit and a conducting rod. RL circuit has ɛ = 35 V, R = 7 2, and the time…

Q: 3. In the circuit of the figure, ɛ1 =1.5 kV, C = 6.0 µF, R1 = R2 = R3 = 0.82 MQ. With C completely…

A: Here given the circuit diagram with E1= 1.5kv ,C= 6 micro farad,R1=R2=R3= 0.82 M ohm. We have to…

Q: 2. The switch has been closed for a long period of time, and a constant current run through the…

Q: You want to protect an electrical equipment from getting damaged due to sudden surges in current?…

Q: R a 4. A rectangular circuit containing a resistance R is pulled at a constant velocity v away from…

Q: A wire coil connected to a battery and a switch in a closed circuit. Select a TRUE statement…

A: When a wire coil connected to a battery and a switch in a circus and when the switch is closed the…

Q: R1 R2 V R3 R4 hen the switch is placed in position 1, the measured current in the battery is 1.2 mA.…

Q: Please answer all questions, thank you!

Question

Q2 -

Magnitude of current at resonance in R L C circuit

depends upon the magnitude of R

depends upon the magnitude of C

depends upon the magnitude of L

depends upon the magnitude of R, L and C.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Verify than the direction of the line force in an MHD drive, such as that in Figure 22.32, does not depend on the sign of the charges carrying the current across the fluid.
Integrated Concepts Derive an expression for the current in a system like that in Figure 23.11, under the following conditions. The resistance between the rails is R, the rails and the moving red are identical in cross section A and have the same resistivity . The distance between the rails is l, and the rod moves at constant speed v perpendicular to the uniform field B. At time zero, the moving red is next to the resistance R.
A GFI may trip just because the live/hot and neutral wires connected to it are significantly different in length. Explain why.
The human body can exhibit a wide range of resistances to current depending on the path of the current, contact area, and sweatiness of the skin. Suppose the resistance across the chest from the left hand to the right hand is 1.0 106 . (a) How much voltage is required to cause possible heart fibrillation in a man, which corresponds to 500 mA of direct current? (b) Why should rubber-soled shoes and rubber gloves be worn when working around electricity?
What is the voltage across the open switch in Figure 21.43?
A hypothetical current flowing in the z-direction creates the field B=C[(x/y2)i+(1/y)j] in the rectangular region of the xy-plane shown in the accompanying figure. Use Ampere’s law to find the current through the rectangle.
The human body can exhibit a wide range of resistances to current depending on the path of the current, contact area, and sweatiness of the skin. Suppose the resistance across the chest from the left hand to the right hand is 1.0 106 . (a) How much voltage is required to cause possible heart fibrillation in a man, which corresponds to 500 mA of direct current? (b) Why should rubber-soled shoes and rubber gloves be worn when working around electricity?
Integrated Concepts (a) What is the direction of the force on a wire carrying a current due east in a location where the Earth’s field is due north? Both are parallel to the ground. (b) Calculate the force per meter if the wire carries 20.0 A and the field strength is 3.00105T. (c) What diameter copper wire would have its weight supported by this force? (d) Calculate the resistance per meter and the voltage per meter needed.
In this problem, you will verify statements made at the end of the power losses for Example 20.10. (a) What current is needed to transmit 100 MW of power at a voltage of 25.0 kV? (b) Find the power loss in a 1.00 transmission line. (c) What percent loss does this represent?
Consider the circuit below, (a) What is the initial current through resistor R2? when the switch is closed? (b) What is die current through resistor R2 when the capacitor is fully charged, long after die switch is closed? (c) What happens if the switch is opened after it has been closed for some rime? (d) If the switch has been closed for a time period long enough for the capacitor to become fully charged, and then the switch is opened, how long before the current through resistor R1 reaches half of its initial value?
A man foolishly tries to fish a burning piece of bread from a toaster with a metal butter knife and comes into contact with 120-V ac. He does not even feel it since, luckily, he is wearing rubber-soled shoes. What is the minimum resistance of the path tire current follows through the person?
Integrated Concepts Hydroelectric generators (see Figure 20.43) at Hoover Dam produce a maximum current of 8.00 103 A at 250 kV. (a) What is the power output? (b) The water that powers the generators enters and leaves the system at low speed (thus its kinetic energy does not change) but loses 160 m in altitude. How many cubic meters per second are needed, assuming 85.0% efficiency?