Maximizing the wind velocity of 92 m/s and 25 units of wind turbine was installed at the seaside shore. What is the total power if the area of turbine blade equal to 42 sq.m. with air density of 1.2041 Kg/cu.m. А) 1.969 MW В 1,968,998 Watts 4,923 watts D) 49.23 MW

Maximizing the wind velocity of 92 m/s and 25 units of wind turbine was installed at the seaside shore. What is the total power if the area of turbine blade equal to 42 sq.m. with air density of 1.2041 Kg/cu.m. А) 1.969 MW В 1,968,998 Watts 4,923 watts D) 49.23 MW

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter2: Matter And Energy

Section: Chapter Questions

Problem 21RQ

See similar textbooks

Related questions

Q: A single-strand roller chain drive connects a 50-hp engine to a lawn waste chipper/shredder, as…

Q: 3. For the structure carrying a uniform load of 4 kN/ m, compute the internal axial force, shear…

A: First draw the free body diagram of the horizontal beam, Then draw the free body diagram of the…

Q: 1) Given the pound(p) and eccentric(e), with a total area of 21 inch^2. What is the status of the…

A: Given that, Area of the cross-section, A=21 in2Load acting on the cube's top surface, P=28000…

Q: he composite material is fastened to their junction at rigid plate B and attached to rigid fixed…

A: Given DataE1=29×106psiA1=1.03in2L1=12in=1ftE2=10×106psiA2=8.92 in2L2=24in Free Body Diagram.

Q: The bracket shown in Figure ST - 228 is attached to a column by 6 - 20 mm diameter bolts and loaded…

A: The bearing stress between the bolt and the bracket is 61.46 MPa.

Q: If the cord is subjected to a horizontal force of P = 146 N, and the gear is supported by a fixed…

Q: This composite shape is composed of a square, a half-circle, a triangle and a circular hole.…

Q: Q2:- Find the natural frequency and the steady state amplitude of vibration for the system shown in…

Q: Find the diameter of a pipe of length 6 km when rate of flow of water through the pipe is 250…

Q: An ideal reheat rankine cycle is characterized by a steam generator pressure of 11 MPa and a…

Q: b) What is the measurement resolution, in degrees of arc, of an incremental optical angle encoder…

A: degree of arc of an incremental optical angle

Q: The system is released from rest with no slack in the cable and with the spring unstretched.…

Q: The force Pis applied to the 48-kg block when it is at rest. Determine the magnitude and direction…

Q: A pelton wheel working under a head of 50 meters, develops 80 kW at 230 rpm. Calculate the diameter…

A: In this problem, we know that a pelton wheel spinning at 230 rpm produces 80 kW under a 50 metre…

Q: The simply supported beam is built up from three boards by nailing them together as shown. Determine…

Q: The spherical gas tank is fabricated by bolting together two hemispherical thin shells of thickness…

Q: A pelton wheel working under a head of 50 meters, develops 80 kW at 230 rpm. Calculate the diameter…

A: In this problem, we know that a pelton wheel spinning at 230 rpm produces 80 kW under a 50 metre…

Q: the minimum force

A: Given; If the coefficient of the static friction for all surfaces is 0.4, Block R is tied to the…

Q: Determine the magnitude of the moment about point O due to the force F - 400 N acting as shown.

Q: Design the thickness of the cylinder tank in the shown figure if it is to be filled with oil whose…

Q: 3. Determine the torsion on the rigid supports and the maximum shearing stress developed in each…

Q: 1. From the given sets of parallel forces shown. a.) Which of the following gives the resultant…

A: (a) The resultant force, FR = 95 kN. (b) The moment of the resultant of forces about left support…

Q: A helical gear has a normal diametral pitch of 12. a nor- mal pressure angle of 20°, 48 teeth, a…

Q: respectively. The tank has an inner diameter of 4 m. The thickness of the cylindrical are made from…

A: A scalar quantity in when when an amount of force act on the object in a cross section area, that is…

Q: Instructions: Identify the brake system components in the drawing. Place the identifying letter next…

A: A - Reservior B- Pressure chamber C-Inlet port D-compensating port E-fluid outlet F- Check…

Q: A barrel contains a 15 cm layer of oil of density 5.88 kN/m3 floating on water that is 30 cm deep.…

Q: The 188-lb car of an amusement park ride is connected to a rotating telescopic boom. When r= 15 ft,…

Q: Figure 3. A bronze bar having a cross-sectional, area of 200 mm?.carries the axial loads shown in…

Q: The area of the upper face of a rectangular block is .5mx.5m The lower face is fixed. The height of…

Q: Using affinity laws, develop a pump curve and BHP curve for a 1 ½" AB pump for a 6" impeller. Use a…

Q: Calculate the moment of inertia of the shaded area about the x-axis. 76 mm 76 mm 45 mm Answer: Ix =…

Q: 1. Given: A pipeline connecting a reservoir with a pump. - Properties of the pipeline: L= 450 m; D=…

A: Friction loss is the amount of energy lost by your piping system as a result of fluids encountering…

Q: A 100 x 300 mm ammonia compressor with a compression efficiency of 82% operates with a suction…

A: Given, bore of the compressor , d = 100 mm stroke of the compressor , L = 200mm Condenser pressure…

Q: A certain gas weighs 3.19 x 10-3 slugs/ft3 at a certain temperature and pressure. What are the…

A: Densityρ or mass density or specific mass is defined as the ratio of mass attained by the object in…

Q: Florida Tidal power plant is one of the famous efficient tidal plant. What is the energy or power…

A: Barrage area, A= 1820 m^2 Vertical height range, h= 3.2 m Sea water density, ρ= 1.020 kg/m3 To…

Q: 24. A 2.0 kg disk is able to move on a straight, level track with negligible friction. With the disk…

Q: 4. The cable will fail when subjected to a tension of 8000 N. Determine the largest vertical load P…

Q: 1.calculate the tension in each cable if the tension is in equilibrium 2.calculate the combined…

A: Fttgg

Q: lateral displacement equation in each segment using coordinates x1 and x2 shown. EI The member is…

Q: Most modern electrical heating and cooling devices are provided with thermostat. What is the purpose…

A: Most modern electrical heating and cooling devices are provided with thermostat. Purpose of the…

Q: Determine the moment of inertia of the composite area about the z axis Set a- 450 mm b- 160 mm, h…

Q: A diesel power plant uses fuel with heating value of 45,325 kJ/kg. What is the density of the fuel…

A: Given data fuel used in powerplant = diesel heating value of diesel = 45325 kJ/kg

Q: 2.) A power plant operating on a Rankine cycle has steam entering the turbine at 500 °C and 2 MPa.…

Q: Q3) If in a standard vapor-compression cycle using refrigerant 22 the evaporating temperature is…

Q: the gauge pressure at point B. Two reservoirs are connected by a pipe 40 cm diameter and 2000 m…

A: Upon the neglecting the minor losses we know that pa=pc=0vA=VC=0 Applying the Bernoulli equation…

Q: Two strings, A and B, have respective mass densities µA and µB respectively. The linear mass…

A: The ratio between the mass of any object to the volume of that object is known as the density of…

Q: I deformation processes, friction and associated forces can account for a substantial percentage of…

A: Solution is attached below:

Q: term gB(T - To) represents

A: Given: 2-D momentum equation for natural convection over a surface immersed in a quiescent fluid at…

Q: A syringe (X), forces air, at a high velocity, over a straw (Y). The air in the water chamber (Z) is…

A: Solution is attached below

Q: Question 6 AGt kng semicircular drainage pipe is filled with water. Determine the total resutant…

A: as per guideline i have to solve only first part of your question

Question

Maximizing the wind velocity of 92 m/s and 25 units of wind turbine was installed at the seaside shore. What is the total power if the
area of turbine blade equal to 42 sq.m. with air density of 1.2041 Kg/cu.m.
A) 1.969 MW
B) 1,968,998 Watts
4,923 watts
D) 49.23 MW

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A house has an area of 195 m^2. What is its area in: dm^2
3. Steam enter a turbine with an enthalpy of 1292 Btu/lb anf leaves with an enthalpy of 1098 Btu/lb. The transferred heat is 13 BTU/lb. What is the work in BTU/min an in h for a flow of 2 lb/sec? 3 decimal in final answer pls
29 - Water is drawn from the bottom of a large tank filled with water open to the atmosphere. If the outlet velocity is 7.2 m/s, what could be the height of the water in the tank? a) 2.64m B) 4.38m NS) 3.65 m D) 5.46 m TO) 2.20m 30 - What would be the weight of an object with a mass of 100 kg in a place where the gravitational acceleration is 8 m/s²? a) 42.2 kgf B) 98.1 N NS) 800 N D) 9810 N TO) 196.2 N
A retail flower shop in Metro Manila, called Floreau, sel ls arranged flowers. The shop can make beautiful arrangem ents that consists of 12 flowers for a cost of P1,800. Thi e cost of materials of each bouquet is P2,500. and other cost is P650. The shop has a fixed cost of P6900 includin g the rents and miscellaneous. If a bouquet costs P69,00 0, how many pieces of flowers must be sold to break even?
2- Please I want a solution of this question. Many Thanks Determine the average wind velocity required to produce 4 MW of effective power by a wind turbine having the following data: blade length 65 m, hub diameter 6 m, air density 1.12 kg/m3, power coefficient 0.6, gear efficiency 85%, electrical efficiency 90% and generator efficiency 95%.
In an undisturbed airstream inside a wind tunnel, the pressure is 101325 Pa, density is 1.225 kg/m^3 and velocity is 200 m/s. What is the velocity if the pressure is 90,000 Pa.
Question: Continue the previous work, pls create me an Grann Chart for Production of High-Quality Organic Rice. You may assume the activities and days.
If you rent a car, you can (1) return it with a full gas tank, (2) return it without filling it and pay $5.75/gallon, or (3) accept a fixed price of $60 for gas. The local price is $3.50/gallon for gasoline, and you expect this car to get 25 miles per gallon. The car has a 16-gallon tank. What choice should you make if you expect to drive: (a) 150 miles? (b) 300 miles? (c) 450 miles? (d) How do your answers change if stopping at the filling station takes 20 minutes and your time is worth $15/hr?
Completely solve and box the final answers. Write legibly 4. A single stage air compressor handles 30 cubic meter per minute of atmospheric pressure, 30°C air and delivers it to a receiver at 3.0 mpa. Its volumetric efficiency is 83.0%, compression efficiency of 83.0% and mechanical efficiency of 80.30%. If it rotates at 300 rpm, what power in kW is required to drive it?
7 g = 10 m/s^2
a = 5 m b = 3 m c = 1 m m= 120 kgg= 9.80665 m/s^2
Q.5 A petrol engine with 6 cylinder of 82.55 mm bore and 79.5 mm stroke delevers 48 kW.If the compression ratio is 7.8 , mechanical efficiency is 80% and thermal efficiency is 21.1%, determine a)Total swept volume in cubic cm b) Clearance volume of each cylinder c)Indicaed power d)Friction power e)Indicated thermal efficiency