DA stamping device is used for work on sheet metal work piece. The puncher that moved by double acting cylinder (DAC- A) with sp stamp the sheet metal and lefur retracted back to its position. While the sheet metal inside the blank will push out using another DAC- B and retracted back with Spring return ) Design an Pneumatic-PLC circuit by using 5/2 way valve.

DA stamping device is used for work on sheet metal work piece. The puncher that moved by double acting cylinder (DAC- A) with sp stamp the sheet metal and lefur retracted back to its position. While the sheet metal inside the blank will push out using another DAC- B and retracted back with Spring return ) Design an Pneumatic-PLC circuit by using 5/2 way valve.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

illustrate a crank and slooted lever mechanism as an inversion of single slider crank chain. describe an expression for legth of stroke in terms of link length
Devise a ladder program that can be used with a solenoid valve-controlled double-acting cylinder, that is, a cylinder with a piston that can be moved either way by means of solenoids for each of its two positions, and moves the piston to the right, holds it there for 2 s, and then returns it to the left.
Find degree of freedom for dump truck dump mechanism showed in picture.
EQUATION SHEET TABLE A-9 LINKS BELOW bartleby doesn't allow more than 2 pic uploads so i attached them
Calculate the DOF of the following mechanisms. If there are compound hinge, passive DOF or Redundant Constraint, please point them out.
Derive a governing equation of at least one SDOF system
THE GOVERNOR MAINTAINS THE REQUIRED BALANCE BETWEEN ALL CONTROL FORCES BY METERING TO, OR DRAIN FROM, THE INBOARD SIDE OF THE PROPELLER MECHANISM TO MAINTAIN THE PROPELLER BLADE ANGLE FOR CONSTANT SPEED OPERATION. THAT BEING SAID. HOW DOES THE PROPELLER GOVERNOR OPERATE? AND WHAT ARE THE COMPONENTS THAT MAKE UP THE PROPELLER GOVERNOR?
Explain Vector Loop equation for four bar and slider crank mechanisms
Explain about controlling torque using Spring control method. Please do not write the answer on a paper
A product is pushed out of the gravity feed magazine and clamped by cylinder 1A. Cylinder 2A can stamp the product and retract only after that. Then, retract clamping cylinder 1A to its starting position. Cylinder 3A will discharge the stamped product before moving back to its starting position. Draw the displacement-step diagram, and then design the system's entire pneumatic circuit.
calculate the DOF of the mechanisms below (Mark the compound hinge, passive DOF and Redundant constraints if there are any)
A four-part mechanism like this one, if it is known the length of o2a (link 2) is 5 cm (link 3) is 4 cm (link 3) and the length of the bo4 (link 4) is 5.5 cm (5 in.). At the a point working the p = 50 Newton style with the sustric orientation of the horizontal line is 20⁰, look for styles that are going on and torque on link 4.