Microprocessors and microcontrollers are two independent types of electrical equipment. What differentiates them?

Q: Q5) In the circuit, shown in Fig. 5 determine the value of E so that the current 1-0. Use mesh…

A: Apply KVL in left and middle loop to find loop currents. Now again apply KVL in right loop to find…

Q: Calculate the equivalent admittance Y, for the network in Fig. the current I if Vs = 60/45° V.…

A:

Q: Q2: A three-phase Transmission line with 1,956 cm diameter conductor, the corona takes place if the…

A:

Q: 9) In a 208 V 3-phase motor load, the current drawn by the motor is 22 A and the PF is 0.6. a) What…

A: Given- For three phase motor load- Voltage, V= 208 Volts Current, A= 22 A Power factor = 0.6 To…

Q: Give the meaning of each acronym of solid state devices. Also sketch the schematic symbol for each…

A:

Q: Find the impulse response h [ n ] of the causal LTI discrete-time systems satisfying the following…

A:

Q: 1. Create the Relay logic of the four way hall-way with automatic lighting system D 0 1 0 1 0 1 1 0…

A:

Q: For the circuit shown in the figure, the Thevenin voltage (Vth) at terminals a-b is: 492 ww 502 O a.…

A:

Q: Question A 50 Hz, bar primary CT has a secondary with 500 turns. The secondary supplies 5A current…

A: Given- Magnetizing ampere turns=200, 50 Hz secondary turns=500, secondary current = 5A, To Find- The…

Q: A 12 V battery is connected across a load having a resistance of 40 Ω.Determine the current flowing…

A: Voltage V = 12 V Resistance R = 40 Ω We have to determine a) Load b) Power Consumed c) Energy…

Q: In Figure shown below, use Thevenin's Theorem to Determine RTH. VTH IN & Maximum power transfer at…

A:

Q: a 120v dc shunt motor has an armature resistance of 0.25 ohms is drawing 50a. if a fixed loss of…

A: In this question,  We need to determine the break horse power of the DC shunt motor.  We know 1HP=…

Q: Define fan-in and fan-out of a gate.

A:

Q: Q2: For a (3-0) medium transmission line model (T cct) as shown in next figure, find the, current…

A: Given: Sending End Voltage Vs = 247.4∠23.3 kv/phaseSending End Current  Is = 603.5∠-10.27∘ ampSeries…

Q: Convert the following voltage ratios to dB. (a) 3000 (b) √30

A: a) Given: The voltage ratio, Av=3000

Q: Q6) Determine the current drawn from the source in the given circuit in Fig. 6. R₁ V₂ 14V 292 R₁ R.…

A:

Q: 18V- 9Ω www. 8Ω Μ 12Ω 18Ω 11Ω www 5Ω ΖΩΙ ΜΕ ΠΩ 3Ω Μ ΠΩ ΕΣΤΩ 5Ω

A:

Q: lean algebra to simplify the following expression, then draw a logic gate circuit for the simpli…

A:

Q: A 3 Bus network is shown. Consider generators as ideal voltage sources. If rows 1, 2 and 3 of the…

A: Solution !!

Q: Low Pass Filter

A: 1. Low Pass Filter (LPF) :  Eliminates the high frequency.components present in the input analog…

Q: Consider the system below: Load X ZKX Y Capacity [MW] 51 248 201 B Generator X1-3 = 0.4 p.u. PMAX…

A:

Q: Find the amplitude and frequency of the following waves: 2.1. 15 sin 377t 2.2. 104 sin 754t

A: Given : 2.1 15 sin 377t

Q: Q6) Determine the current drawn from the source in the given circuit in Fig. 6. R₁ V₂ 14V 292 R₁ R.…

A:

Q: 36 V www 352 Vo 60 602 6 V In the circuit shown, the voltage Vo is most nearly V 21 O V 36 O V60 V…

A: Given data, Circuit diagram is given as,

Q: Which of the following are possible input of the system? (choose three) reference setpoint physical…

A:

Q: Determine the power delivered by the current source in the figure below: www 5Ω www 4Ω 4A 202

A: Solution:

Q: d) e) Light incident on a semiconductor will be absorbed if: The light has a longer wavelength than…

A: Introduction - Semiconductor is a broad term that refers to materials with electrical conductivity…

Q: 2. The field coils of a six-poles D. C. generator each having 600 turns, are connected in series. On…

A: Given data, Number of poles P = 6. Number of turns N = 600. Main magnetic flux ϕm=0.024 wb/pole.…

Q: Before turning ON the power switch of the power supply module, it is a good practice to position the…

A: In this question we need to verify the given statement is true or false

Q: 3 (Non-anonymous question ). Find the transfer function, G (s) = v(1) (+) 2 H oooo 292 www VL(S)…

A:

Q: 1. Find the transfer function, G(s) = vi(t) 1+ 1 H oooo 1 H Vo(s) V{(s) 1 H oooo for the given…

A:

Q: Use an ideal plus voltage drop model. +10 V Vin OV -10 V 3V 1.0 ΚΩ Vout

A:

Q: For given BJT, B=200. The applied input frequency is 20 Mhz and net internal capacitance is 100 pF.…

A: According to the question, the data given for the BJT is as  β = 200 Also, the value of input…

Q: A buck-boost converter has an input voltage of 12 V and the duty ratio is adjusted to 0.5. What is…

A: Given: A buck-boost converter has, Input voltage, Vin=12 V. Duty ratio, D=0.5.

Q: 1. The following circuit has three loads connected in parallel to a 1.0 kV RMS voltage source at a…

A: In this question we need to find total active power , reactive power and complex power and over all…

Q: The desired hexadecimal values are in octal format.

A:

Q: Figure shows a chopper. The device S1 is the main switching device. S2 is the auxiliary commutation…

A: Given- Load current- Io=20 A, voltage V=200 V, Capacitance C=2μF, L=200 mH, To Find- The peak…

Q: A buck converter is designed to supply a 5V cell phone from a 12V car battery. Determine the duty…

A: Given  Input voltage, Vi=12 V the output voltage, Vo=5 V

Q: A full wave rectified voltage filter as Steady-state expression for Volt) E X (FX) is shown in below…

A:

Q: RT 6. Find the total resistance of the following circuit R₁60 R₂90 R, 60 R720 R, on 6

A: Given circuit:

Q: Under uniform field conditions and standard atmospheric conditions, a test to determine the…

A: The breakdown strength of air is to be found for: (a) small gaps of 2 mm (b) large gaps of 15 cm The…

Q: lov (+ 150.0 11 2200 # V3 + 12- 13 - 12 3900 3302 2.2ka Ike 10.02 us + Vi= V2- V3 - V2 3-3K12 2.…

A:

Q: For the image shown, the 18 ohm resistor has a current through it of M 852 qr w 1852 56 V ?

A:

Q: An underground cable has the following primary constants: resistance R = 10/loop km, inductance L =…

A: Resistance R = 10Ω Inductance L = 1.5 mH Conductance G = 1.2μS Capacitance C = 0.06μF

Q: Problem 4 The circuit shown below contains a voltage-controlled voltage source: a) Use KVL to write…

A: Given: Circuit

Q: 2. Consider the closed loop system given below. r(t) e(t) G(s) = G(S) G(S) k (s+2)(s+3) K(S+1) S(S+…

A:

Q: Determine 45 V + mesh currents using mesh analysis 8 12-2 MA LOV wy m 5452 m 102 202 m 922

A: The given circuit diagram is shown below:

Q: A short circuited stub is shunt connected to a transmission line as shown in the figure is, if Zo =…

A: Solution is done according to the problem !!

Q: Determine the gate current and anode current when the switch is momentarily closed in the figure…

A:

Q: Q4) An LTI system is characterized by the differential equation below: d² z y(t)+5 = y(t)+6y(t) =…

A: NOTE: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts…

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.