Name and explain two or more virtualization security issues among Drones and Autonomous Aerial Vehicles?

Q: Q.2 Vessels A and B contain water under pressure of 276 kPa and 138 kPa, respectively. What is the…

A:

Q: aquiclude aquifer capillary fringe cavernous porosity fracture porosity infiltration [Choose ]…

A: The given definitions have to match with the civil engineering parameters and terms used.

Q: PROBLEMS (7) A SUSPENSION CABLE 140 M SPAN AND 14 M CENTRAL DIP CARRIES A LOAD OF 1 KN/M. CALCULATE…

A:

Q: 4. Project managers have many resources that are not directly under their control, such as the…

A:

Q: What are the classifications of Fire? Explain each.

A: Fire- A chemical reaction known as fire produces energy in the form of heat. The process is referred…

Q: The magnitude of slope at end B for propped cantilever beam as shown in figure below if the end B is…

A:

Q: 1. A wastewater is treated in an aerobic CSTR with no cell recycle. The following hold: Ks= 50mg/l;…

A:

Q: A beam has a concentrated load (Pu) at midspan and has a fixed support at both ends. If the beam…

A: Given: Beam width, b = 211 mm Beam height, d = 389 mm Load at the center, Pu = 63.66 kN Span of the…

Q: Wo B Solve each of the Following 1. Maximum Deflection 2. Slope at point A and B 3. Location of…

A: Note:- Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Q: A vertical retaining wall 8 m high is supporting a horizontal backfill having a moist unit weight of…

A:

Q: Design the cantilever slab shown below. Use a live load of 4.8 kPa, f'c = 21 MPa, fy = 276 MPa, unit…

A: Given data Slab Span L = 4 m Live Load LL = 12 Kpa Dead load Dl = 5 Kpa f'c = 25 Mpa fy = 275 Mpa…

Q: The rigid bar of negligible weight is supported as shown. The assembly is initially stress-free.…

A:

Q: Complete the table below with the correct values in two decimal places, but "v" must be in five…

A:

Q: Determine the controlling (lowest) net area of the member. X = 2.69 Y = (6-2.69)/2 Z=0,7 Y" -X Y" 5…

A: Controlling net area

Q: The field capacity of a soil is 25%, its permanent wilting point is 15% and specific dry unit weight…

A: Given  -  Field capacity (F.C.) = 25% = 0.25 Permanent wilting point (PWP) = 15% = 0.15 Depth of the…

Q: Problem: Using WSD & USD, design the midspan reinforcement of stringer (B-3) for the second floor of…

A: Answer  Stringer beam B-3 b = 250 mm d = 400 mm f'c = 20.7 Mpa fy = 280 Mpa for 40 grade steel…

Q: 4 - A cantilever beam carries a tip load and moment applied at the tip, as shown in the figure. Find…

A: To determine The axial and shear stresses at point A, B, and C respectively. The representation in…

Q: 12-50. The beam is subjected to the load shown. Determine the equations of the slope and elastic…

A:

Q: What are the classifications of Fire Extinguisher? Please answer it completely.

A: Brief concept introduction- Fire Extinguisher- Fire extinguishers employ a material to lower the…

Q: A Cantilever Beam shown below has a difference with its Flexural Rigidity determine the Maximum…

A: Given cantilever beam with different Flexural rigidity and point load of intensity 71.25 Total…

Q: The below figure shows the flow net in a soil layer under an impermeable concrete dam with an…

A:

Q: H.W. 2: What is the total active force/unit width of wall and what is the location of the resultant…

A:

Q: A simple beam having a length of 4.5m, a width of 300mm, and an overall depth of 700mm has an…

A:

Q: each member of the trusses shown i using the method of consistent defor A 30 k B D 60° 40 k

A:

Q: H.W1 Prepare a preliminary estimate of a project with an area of 2000 m², the project consists of…

A: Given: Area of the project = 2000 m2 Project name. The percentage of the total project area.…

Q: How to solve it using ASD method

A: ASD solution

Q: Question 4 Your Answer: L (ft) For a W21x50 W-section beam with w = 2.9 k/ft and L= 10.5 ft, report…

A: Given data  W21×50 section  Sy = 36 ksi  ∆limit = L/300  Determine the maximum shear force (Vmax)…

Q: Describe how sand makes a good adsorbent?

A: Sand contains pores that allow it to absorb water. The sand's absorbency, or water retaining…

Q: Problem 1: Determine the flexural strength of a W 410 x 67 beam with a simple span of 8 m and Fy =…

A:

Q: In a falling head permeability test, the time taken for the head to fall from hi to h₂ is t. If the…

A:

Q: Design the torsional and shear reinforcement for the beam as shown in the figure. The resulting L…

A: Concrete shear reinforcement is designed to resist forces greater than concrete's shear strength. A…

Q: 4- Calculate the fluid acceleration along the nozzle centerline as a function of x and the given…

A:

Q: 4. For the vessel containing glycerin under pressure, calculate the total pressure at the bottom of…

A: Given Data Air pressure (Pa) = 50 kpa = 50 × 103 N/m2  Determine the total pressure at bottom of…

Q: Using rational method, rainfall intensity-duration curves and the data given in Fig. P 2.27 com-…

A:

Q: What are the applications and significants of jet of water impinging on solid flat and curved…

A: When a jet of water impinges on a solid surface, it can create various effects, depending on the…

Q: 14 The average rainfall for a 3 hour duration storm is 2.7 cm and the loss rate is 0.3 cm/hr. The…

A: Given data- 3 hour duration storm- Average rainfall=2.7 cm, Loss rate=0.3 cm/hr, Base flow=20 m3/s,…

Q: Question 10 of 25 If the pressure at a point in the ocean is 60 kPa, what is the pressure 27 m below…

A:

Q: what are the pros and cons and which one is better for a parking lot: porous asphalt vs pervious…

A: What are the pros and cons and which one is better for a parking lot: porous asphalt vs pervious…

Q: Rigib bar AB; attached to two vertical rods as shown, Is horizonta before the lead P is applied. If…

A:

Q: III. Beams will be designed for the roof and floor systems of an office building. The loads for…

A: Nominal Loads used in LRFD and ASD Load Combinations are as shown, D = dead loads = (30+62)psf =…

Q: 5. A horizontal curve on a six-lane highway has a radius of 1400 ft and 12 ft per lane. The highway…

A: Given:- The radius of the horizontal curve = 1400 ft The width per lane = 12 ft The design speed =…

Q: What would be the weight of soil solids in 1 m³ of a dry soil whose void ratio e=1.0? If this soil…

A:

Q: A beam with a span of 4.5 metres carries a point load of 30 KN at 3 metres from the left support. If…

A: Given data- Span of the beam L=4.5 m, Point load = 30 kN at 3 m from the left support, Section…

Q: Explain the relationships in the excel graph

A: The given plots are to be explained.

Q: . The beam below is used to support a part of the overhang at the entrance of the building (a). The…

A: Given: Properties of HEA 180 type of cross section are Depth=171 mmWidth=180 mmWeb thickness=6…

Q: re Question 14 of 25 A lead cube has a total mass of 80 kg. What is the length of its sides if SG =…

A:

Q: Prob. 4 The figure below gives a cross section of a concrete dam. The subsoil is anisotropic and has…

A:

Q: The rigid pipe is supported by a pin at A and an A-36 guy wire BD (E = 29 000 ksi). If the end C is…

A: Given,        A-36 guy wire BD having elasticity,E = 29000 ksi. End C displace downward by 0.75…

Q: What are the minimum qualifications, duties and number of required safety and health officer in the…

A: A safety officer usually referred to as an occupational health and safety officer is a vital member…

Q: The torque (C) to be transmitted by a drive at the welds is 650 Nm. Knowing that the diameter of the…

A:

Pavement Management

Pavement management is the process of planning the maintenance and repair of a roadway network or other paved infrastructure to improve road conditions throughout the network. It is also used on runways and airports. Every highway superintendent undertakes walkway management. Traffic management includes the cost of living cycles in a systematic way of repairing minor and major roads and reconstruction projects. The needs of the entire network and budget estimates are considered before the projects are undertaken, as the cost of data collection can change significantly. Pavement management incorporates many of the features and functions required to maintain the quality of the paved material as well as to ensure that the entire road network can sustain itself at the required levels. Although pedestrian management involves the life cycle of commuting from planning to maintenance of any transport infrastructure, road asset management, and road maintenance planning is primarily aimed at road infrastructure.