need the answer quickly

Q: If LM = 00, the next state of the flip-flop is 0. If LM = 01, the next state of the flip-flop is the…

A: Given:  An LM flip-flop works as follows: If LM = 00, the next state of the flip-flop is 1. If LM =…

Q: A series circuit consists of a reactor of 0.1 henry inductance and 5 ohms resistance and a capacitor…

A: In this question,   We need to determine the resonance frequency and percentage change in the…

Q: b) For the Logic Circuit shown below, Find the output function F and re-draw the circuit after…

A:

Q: 1) Design a four-bit binary synchronous counter with D flip-flops.

A: We need to design a 4 bit binary synchronous counter using d flip flop.

Q: B. Determine the collector current in Q4 and reference current Ix of the circuit below. Assume…

A:

Q: two electric units are connected across a source whose frequency is 50 cps. If the rms values of the…

A: In this question,   We need to determine the equation of the voltage across the source?  If…

Q: Assume that a tone message m(t) = 2cos(20πt) is transmitted using the modulation system depicted…

A: We need to tell about given modulated signal

Q: We want to design a causal discrete-time LTI system with the property where the input is 피(m) =…

A: As per the guidelines of Bartley we supposed to answer first three subpart only for solution of…

Q: What is the voltage gain of the given circuit? 16 V 270 k2 B 110 I, oVo Z, 2.7 k2

A: We need to find voltage gain for given circuit

Q: Design a Memory system size 8K-bytes to interface with the 8085 microprocessor. Start with address…

A:

Q: Given the state diagram below, generate the state table, state equations, output equation and…

A:

Q: ROBLEM 3: ind the charge for t>0 in the RLC circuit with an inductance of 3/4 H, a resistance o…

A:

Q: Determine the output voltage in V with VA-4.4 V, VB-2.54 V, RA-4 kohm, RB-4 kohm, RC-6 kohm and RD=6…

A:

Q: E2 The first step in determining the AC equivalent model for a transistor is setting all dc sources…

A:

Q: 2. Consider the voltage divider circuit for biasing an n-channel E-MÓSFET. Given the following…

A: We need to find out current and voltage for given circuit

Q: Problem #15: A manufacturing plant has a load of 3600 kVA at a lagging pf of 0.707. A 500-hp…

A: The solution is given below

Q: At 60 Hz , the impedance of coils A and B are each 10 ohms . At 25Hz , the impedance of A is 5.38…

A: To find the total impedance of coils A and B at 60 Hz when connected in series

Q: Solve the Transfer Function, T(s) -1,(s)/V(s) where I(s) loops at the source side while I2(s) loops…

A:

Q: Q2. Order the output stages below based on their DC collector current. Use a descending order. +Vcc…

A: According to the question,  for the given output stages, we need to arrange them in descending…

Q: TUTORIAL PROBLEMS A 3-phase, star-connected alternator is rated at 15000 kVA, 11 kV. The armature…

A: Solve the problem

Q: (d) Calculate the following for the AC signal V(t) - voltage at time t (seconds) given by the…

A: The solution is given below

Q: Find the folal fransfer funchon CO for the ystem shown belows- Gy

A:

Q: Determine the Nyquist rate of a signal whose frequency spectrum is given by x(f) = r(f) – r(f –…

A: In this question,   We need to choose the correct options  What is Nyquist rate of the given signal.…

Q: R 2 kn ww Vout 2.2 kn 5 V 1.8 k0 a) What is the required value of R for a voltage gain of b)…

A: In this question we will find output voltage for opamp and required value of R for given voltage…

Q: ator was designed using ass5 cy of the out Put signal should 1.duty cycle y ourdesgin ternal…

A:

Q: Problem Solving: Determine the applied voltage VD for a diode with an ID = 6 mA, VT = 26 mV, n = 1,…

A: We need to find out voltage across diode for given current .

Q: draw the circuit

A:

Q: Q 2: Astable multivibrator was designed using a 555 timer. The frequency of the output signal should…

A: We need to find out value of resistance for given timer

Q: A 11 120 V R1 3000 V1 V Fig. 5-3 easured Values Calculated Values Remarks V1 = 1 = IT = %3D

A:

Q: Solve for: VB = V  VE = V  IE =  mA  VCE = V  VC = V  re' = ohms

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost the other…

Q: suming the propagation delays of all the components that are shown in gure equal to zero second. X.…

A:

Q: input impedance parameter (hie) in CE configuration is almost equal to________. a.re b.Rc c.Rb d.Bre

A: We need to select correct option for given statement

Q: Given the main frequency of the wideband channel to be 250MHZ with a bandwidth of 200MHZ, what will…

A: Given,For a wideband channel,The main frequency is,f=250 MHzThe bandwidth of the channel is,BW=200…

Q: Q1 Analyse the circuit shown in Figure Q1, (a) Name the function of each Op-Amp, Al, A2, A3, and A4…

A: Name the function of each Op-Amp, A1, A2, A3, and A4

Q: the input impedance

A:

Q: A fixed-bias common-emitter amplifier has an unbypassed, 1.2 kQ emitter resistor, and 270 kN base…

A:

Q: Problem No. 1 (PI) For the common-base configuration (re model), an ac signal of 10 mV is applied,…

A: Brief description : In the above given question they have mentioned a common base amplifier circuit.…

Q: A sampling process uses a sampling rate of fg. Determine which of the following input signal…

A: The solution is given below

Q: Determine the output peak voltage, Vo R1=10546 ohms, R2-8797ohms,R33D8004 ohms, R4 = 8021 ohms, with…

A:

Q: A 11 ( mA 12 ( mA mA ) 13 120 V V1 V2 V3 V R1 3002 V R2 6002 R3 1.2kS. V

A: Given here a circuit and asked to measure and calculate the voltages and currents in the circuit.

Q: Q1. An equilateral transmission line has a total corona loss of 53 kW at 106 kV and a loss of 98 kW…

A:

Q: mine the number of bits per level required when using FSK with 4 alffere frequencies and QAM with a…

A: It is given that: FSK with 4 different frequencies QAM with a constellation of 256 points

Q: 2.31 Find the power supplied by each source in the circuit in Fig. P2.31. 4 k2 2 kN (+-) 12 V 6 V(+…

A:

Q: 102 0.3H 1mF i, (1) v, (t) = 200 sin100t V

A:

Q: 1. Graph the following complex numbers and convert in the specified forn a. 5-j7 to exponential form…

A:

Q: 10U ID 0.SK HE Rr JOMA = 0.5K Vin Rast Rin A IDQ? Find Ac Voltage gain Rin ģ Root Out FET:Depletion…

A: Given

Q: The input impedance of an ac network can be measured with an ohmmeter. a.False b.True c.True if the…

A: In this question,   We need to choose the correct options The input impedance of an ac network can…

Q: 2. Solve for the branch currents using any method. 10V 15V 50 50 32 20V

A:

Q: Q1 Analyse the circuit shown in Figure Q1, (а) Name the function of each Op-Amp, A1, A2, A3, and A4…

A:

Q: S t A or B: (A) The voltage across a 5-mF capaciter is shown. Determine the current through the…

A: