N₂O, decomposes into NO₂ and NO3 with a rate constant of 1.96 X 10¹4 exp [-10,660/T]s At t= 0, pure N₂O5 is admitted into a constant temperature and volume reactor with an initial pressure of 2 atm. After 1 min, what is the total pressure of the reactor? T = 273 K.

Q: Determine the value of Kc in Figure Q2(b) for a regulator case in which the closed-loop response has…

A:

Q: QUESTION 9 At which temperature will carbon dioxide be in the corresponding state to argon at 32 atm…

A: It is given that carbon dioxide and argon are in the corresponding state. Given pressure is 32 atm…

Q: 2x₁ - 7x₂ + 4x₂ = 9 X₁ +9x₂ - 6x3 = 1 −3x₁ +8x₂ +5x₂ = 6

A: The given simultaneous equations are as follows: 2x1 - 7x2 + 4x3 = 9x1+9x2-6x3 = 1-3x1+8x2+5x3 = -6…

Q: The lowest temperature at which auto-ignition of the joil vapor occurs above the heated oil sample…

A: Cloud point is the temperature at which the solution forms an emulsion by liquid-liquid phase…

Q: The heart is effectively made up of two pumps that create flow through the human circulatory system…

A: Introduction  A pump is a tool that moves fluids (drinks or gases), or occasionally slurries, via…

Q: O He 1.0 L 0.50 atm O Ne 1.0 L 0.40 atm All gases at T = 0°C Ar 2.0 L 0.20 atm Which gas has highest…

A: Given data is for three gases at T=00 C=273.15 K (constant temperature)- Helium (He) at, P=0.50 atm,…

Q: 1. Two thousand kilograms of a 94% NaNO3 solution in water is at a temperature of 1000C. This is…

A:

Q: 11.7. A tubular condenser with 120 2-in. BWG 16 copper tubes & ft long condenses 22,100 lb/h of…

A: Mass flow rate is calculated from density and volumetric flow rate. Heat gained by water is…

Q: What happens to the trend of Xm (liquid mole fraction) and Ym(vapor mole fraction) as the boiling…

A:

Q: Flow of Liquid in a Pipe and Mass Balance.

A:

Q: FR&B 3.32. A mixture of methane and air is capable of being ignited only if the mole percent of…

A: Given that- For basis air- methane mixture feed= 1 mol Mol of methane in mixture= 9 mol % = 0.09 mol…

Q: The percentage of MnO₂ in a 500 mg sample which after the addition of 80.00 mL of 0.1056 M FeSO4…

A: The given sample contains impurities and MnO2. A FeSO4 solution is therefore used to titrate the…

Q: 1718 A computer IC chip consumes 10 W of power, which is dissipated as heat. The chip measures 4 cm…

A:

Q: In the concentration of fruit juices, a portion of the feed is redirected to bypass the evaporator…

A: Given  Amount of feed (F) = 433 kg/ h  Feed concentration = 13.27% = 0.1327 Final product…

Q: Solid calcium fluoride (CaF2) reacts with sulfuric acid (H2SO4) to form solid calcium sulfate…

A: It is given that Fluorite ore is having 96.0 wt% CaF2 and 4.0 wt% SiO2. This calcium fluoride (CaF2)…

Q: Calculate the pressure ( in atm) at which the freezing temperature of water is -20°C = 253 K H₂O(s)…

A: Given data: Enthalpy of fusion = 6010 J/mol Initial temperature = 273 K Initial pressure = 1 atm…

Q: 8.3 Polycarbonate is made by mixing 25 kg bisphenol A with 15 kg phosgene (see Example 2.4N) in a…

A: Given that- Mass of bisphenol A= 25 kg = 25000 g Mass of phosgene = 15 kg = 15000 g Molar mass of…

Q: The retention times of cis- and trans stilbene isomers on a GC column were 6.80 min and 7.30 min,…

A: Introduction Gas chromatography (GC) is a separation method that uses variations in the mode of…

Q: The following temperature/composition data were obtained for a mixture of octane (O) and…

A: Given, Pressure of the mixture= 1 atm x=mole fraction of liquid at equilibrium. and y= mole fraction…

Q: differential manometer is shown below. Calculate the pressure difference between points A and B in…

A:

Q: A group of students are doing an analysis of copper in 1-peso coin. They were tasked to prepare…

A: Types of errors.... 1. Determinate error – also known as systemic error, causes the mean of a data…

Q: Using the figure below, the lower plate is being pulled at a relative velocity of 3.14 m/s greater…

A: Given, Viscosity of fluid = 2.75 centipoise = 0.00275 Pa-sec Distance between plates = 1.3 m Reality…

Q: 2.-. ) Suppose an ethanol(¹)-benzene(2) mixture at 298K. exhibits an azeotrope at a mole fraction of…

A: Given that for binary mixture of ethanol(1)-benzene(2), Temperature, T=298 K Ethanol (1) mole…

Q: Boiling Point ("C) 82.0 80.0 78.0 76.0 74.0 72.0 70.0 T T T 0.0 0.20 0.40 0.60 Xisopropanol 0.80 (a)…

A: Student ask for only part E so I answered only part E........

Q: In the photosynthesis assuming an elementary reaction: a. Give the rate equation for the depletion…

A: The photosynthesis reaction assuming it is an elementary reaction is as follows: 6CO2 + 6H2O + light…

Q: On a clear night, when the effective blackbody temperature of the space is - 30°C, the air contains…

A:

Q: Derive the Kremser equation for a stripper with three equilibrium stages

A: Kremser equation for stripping section is to be derived.

Q: 3: A concentration C (g/L) varies with time (min) according to the equation; C = 3.00 exp(-2.00t) a)…

A: Given thatC =3.00 exp(-2.00 t )where C is concentration in g/L and t is time in hr Accordint to…

Q: A double pipe heat exchanger consists of a 2" Sch 40 steel pipe inside a 3inch Sch 40 steel pipe, 10…

A: It is given that double pipe heat exchanger is used to condense steam in the annulus bu help of…

Q: blood serum sample is analyzed and round to contain ug of the serum is 1053 kg/m³; AW Ca= 40.08.…

A:

Q: The purchased-equipment cost for a plant which produces pentaerythritol (solid-fluid pro- cessing…

A: Given: Solid-fluid processing plant Purchased equipment cost is $300,000 Contractor's fee is 7 % of…

Q: At 25°C, what is the pH of the solution produced when 0.0700 mL of 36.0 wt % HCI is diluted to 500…

A: Calculating the normality (or the [H+]) concentration first for calculating the pH, N1V1=N2V2N1 =…

Q: 1.6 1.2 + 0.8 0.4+ O -0.4 -0.8 -1.2 - -2 Fe3+ 2 1 4 Fe²+ 0 3 Fe(s) 4 Fe₂O3(s) 5 FeOH+ Fe3O4(s)…

A:

Q: Take the wholesale price of refined sugar (containing 0.1% water) to be 42 cents/lbm. Assume that…

A: For a detailed solution, please see the attached files.

Q: What are tannins and how were these separated from caffeine in the experiment?

A: Foods and drinks like tea, coffee, chocolate, and wine all include naturally occurring plant…

Q: Given the figure below, If the barometric pressure is 1.07 bar and the gauge pressure at the bottom…

A: Given data: Barometric pressure = 1.07 bar Gauge pressure at the bottom of tank = 138.52 kPa…

Q: Verify that thermal conductivity

A:

Q: 2. Consider this item as REAL gases: Two hundred and fifty pounds of a mixture of 6.63.% propane…

A: Given, The mass flow rate of the gas mixture,  m = 250lbhr×453.592 g1 lb×1 hr3600 s= 31.5 g/s   The…

Q: Convection, Conduction, and Overall U. A gas at 450 K is flowing inside a 2-in. steel pipe, schedule…

A: Inlet temperature = 450 K Dimension of pipe = 2 in Schedule 40 Thickness of lagging = 51 mm Thermal…

Q: Ternary Diagram) Mark the following features on triangular coordinates: (i) the point (0.2, 0.2,…

A: Mark the following features on triangular coordinates: (i) the point (0.2, 0.2, 0.6), (ii) the point…

Q: a generic civilian Air Car - a type in this case has an assumed weight of 36287.4 kilos. It is…

A: It is given that weight of hovercar is 36287.4Kg. Hovercar is designed to lift one meter off. It is…

Q: b. How many total atoms are there in a body-centered cubic cell? Answer:

A: A unit cell is the crystal's building block. This is the smallest repeating unit in the crystal…

Q: A given reactant decomposes in water with a second-order rate constant of k =0.43 L/mol ·s. If a…

A:

Q: How many phases are at point: A B X

A: The graphical representation of phases is phase diagram. A phase diagram gives the transition…

Q: Silica gel is to be used to separate a mixture of butane and butylene. The feed containing 55%…

A:

Q: C = Coe-kt where C is the solute concentration (mM), Co is the initial concentration (mM), k is the…

A:

Q: 1. Consider this item as ideal gas: A rigid tank containing 3 lb of gaseous mixture of nitrogen,…

A: Given, The initial mass of the mixture is 3 lb. The temperature of the mixture, Ti = 65.56°C = 65.56…

Q: Freshly mined ore is to be cleaned so that later processing units are not contaminated with dirt.…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part…

Q: 5. The tank in Example 3.8 has a leak that admits air at the rate. 0.0005lbm (Poutside - Piank) min…

A:

Q: 1. The heat capacity (Cp) of a fluid is given as function of temperature by the following equation:…

A: