NPN BJT is considered as two diodes their anodes are connected together True or false

Q: For the following circuit, consider that both diodes D1 and D2 are ideal, that is VK = 0 V. Consider…

A: Analog electronics

Q: A full-wave rectifier operating from a 60HZ supply develops a peak rectifier voltage of 23V.…

A: Ripple factor is given by where, and, f=60 C=223uF Idc = 76mA

Q: A single-phase full-wave transistor rectifier power to motor load. The source feeds voltage is 230V,…

A: In this question, choose the correct option What is average load current Io ?  This is single phase…

Q: True or False. Please explain. thank you As the temperature increases, the forward voltage…

A: In this question we will write about forward voltage dependence on temperature in diode....

Q: An LM7812 ground terminal is connected to a zener diode operating in its zener region. If the zener…

A: In this question,  An LM7812 ground terminal is connected to a zener diode operating in its zener…

Q: Find VDc if VAN = VBN = VCN= 120 volts... Half-wave Three-phase Rectifier Conduction Waveform…

A: To convert the AC into DC, Rectifiers are used . It can be controlled as well as uncontrolled .diode…

Q: What are the main differences among Generic Diode, Zener Diode, Schottky Diode and Trans-Vers diode…

A:

Q: xProblem No.2 (P2). A fixed bias NPN BJT (Beta = 80) circuit is connected to a 12VDC supply. The…

A:

Q: E2 Problem No. 3 (P3) A CE Fixed Bias BJT configuration has the following parameters Vcc=12V,…

A:

Q: NPN BJT is considered as two diodes their anodes are connected together. O True False

A: In the question,  Choose the correct option Is it true or false.  "NPN BJT is considered as two…

Q: FOLLOW UP QUESTIONS: BIPOLAR JUNCTION TRANSISTOR (BJT) SOLVE FOR a.) IC(sat) b.) VCE(off)…

A:

Q: 3. Write any three differences between BJT and UJT

A:

Q: . Give the short answer offollowing questions each question carries equal marks Don’t need…

A: As per bartleby expert policy, only one individual question is to be answered. Kindly repost…

Q: From the given semiconductor diodes which will act as a source of microwave

A:

Q: The following set up the circuit with the numbers below. system By finding the required Ckomp value…

A:

Q: The vertical deflection of the electron beam in a CRO is provided by,

A: A cathode-ray oscilloscope (CRO) is an instrument that provides accurate time and aplitude…

Q: 4 "A diode of 600V voltage rating" means А. The peak reverse voltage is 600V. The maximum average…

A: 4)  Voltage rating of diode is PIV ( peak inverse voltage ) across diode . It is a maximum reverse…

Q: 3. Bridge type Power Supply with Capacitor 12V AC Ripple D₂ C Charges Bridge Rectifier D₁ (a) Output…

A: It is given that:

Q: Problem No. 3 (P3) A CE Fixed Bias BJT configuration has the following parameters: Vcc=l2V,…

A: CE fixed bias BJT: In this BJT circuit, the common terminal is the emitter and input terminal is the…

Q: The mode of operation for the D-MOSFET is Select one: a. the ohmic region only b. the enhancement…

A: A D MOSFET works generally in depletion region but under certain condition it can also work in…

Q: Q5: Full the following Blanks (Choose 10 only). 1. . . is a voltage controlled device. 2. The…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Analyse the collector characteristic curves of a Bipolar Junction Transistor (BJT) and the de load…

A: To find the values of IB, Ic, and Vce

Q: For the JFET shown in Figure, Determine the minimum value of VDD required to put the device in the…

A: Need to find VDD By drawing  diagram and applying KVL

Q: The ________parameters may not reflect the actual operating conditions but simply provide an…

A: For the AC analysis of BJT or MOSFET based circuits, It is important to convert it into different…

Q: XProblem No.1 (P). A fixed bias NPN BJT (Beta = 90) circuit is connected to a 16VDC supply with the…

A:

Q: A loaded zener regulator has a VZ of 11 V with IZ equal to 23 mA, with IZK equal to 0.25 mA, ZZ…

A: Given Vz=11 VIz=23 mA=0.023 AIzk=0.25mA=0.00025 AZz=8 ΩPD(max)=1 WR=32 Ω   let VENT=VinVSAL=V0

Q: Using the second approximation with VT=0.7V for both diodes, what are the states of D1 and D2…

A: Given :   Brief description: In the given question they have mentioned an electrical circuit having…

Q: What is the required input voltage at AREF pin in Arduino UNO to have LSB voltage resolution of 1.47…

A: Given, Resolution of Arduino Uno is 1.47 mV. The Arduino Uno ADC is of 10 bit resolutions.

Q: The datasheet shown below for a group of commercial Zener diodes, according to the datasheet the…

A: Leakage current: It is small amount of current flow when the diode is reversed biased. When reverse…

Q: A single-phase bridge inverter is fed from 230 V dc. In output voltage wave, only fundamental…

A: Given: A single-phase bridge inverter V=230 V

Q: The power of an 80 Watt, 220V lamp is to be varied by controlling the firing angle of an SCR in a…

A: In the given question we note that  The power of an 80 Watt, 220 v lamp is varied by controlling the…

Q: The two power MOSFETS with a tonnage current of 10A and RDS(on)1=0.90 and RDS (on)2=1.10 are…

A:

Q: 12. A Germanium based Diode requires ts at the wit the Bias and allow 13. A Silicone based Diode…

A:

Q: The diode that has a metal-to-semiconductor junction and used in fast-switching is: Select one: a.…

A: Schottky diode is a semiconductor diode formed by the junction of a semiconductor with a metal. It…

Q: How many pn junctions are there in a BJT?

A:

Q: In BJT, to diasable a voltage source, we replace the voltage source with what?   a. short circuit…

A: Give & to find: In BJT, to disable a voltage source, we replace the voltage source with what? a.…

Q: The voltage across a BJT during its switch-on transition falls linearly from 284 V to 0 V in 1…

A: In this question we need to find a switching power loss during tON process.

Q: Q7. What is the specialty of Zener diode so as we can operate it in breakdown region for longer…

A: V-I Characteristics of Zener diode:- In forward biased condition, the Zener diode operate similar…

Q: 4: An AC voltmeter uses a bridge rectifier with silicon diodes and PMMC instrument with FSD 75µA. If…

A: The solution can be achieved as follows.

Q: Q 3 Bring out the advantages and disadvantages of microwave tube devices and semiconductor devices.

A: Cost of equipment or installation cost is high.Microwave tube-A Advantage - Supports larger…

Q: Study the circuit below: +12V R2 is a light-dependent-resistor (LDR). It is 5002 when exposed to…

A:

Q: 4 "A diode of 600V voltage rating" means А. The peak reverse voltage is 600V. В. The maximum average…

A: 4) correct option  is peak inverse voltage 600V. Usually the forward voltage drop across the diode…

Q: Discuss about! Depletion Type MOSFET Construction Systematic Diagrams Working Application

A: MOSFET stands for Metal oxide silicon field effect transistor. They are of two types Depletion and…

Q: A 1N4748A zener diode has a ZZ of 23 Ω. Taking the data from the datasheet VZ = 22 V with a test…

A: Case 1: Current is 6mA The change in current from the test current IZ = 11.5 mA is; ΔIz=6mA-11.5mA…

Q: COMPLETE TABLE

A: These are all practical transistors. We can get the related data about each device from its…

Q: Find Vpc if VAN = VBN = VcN= 120 volts... Half-wave Three-phase Rectifier Conduction Waveform…

A:

Q: A 1N4738A zener diode has a ZZ of 4.5 Ω. Taking the data from the datasheet we have VZ = 8.2 V with…

A: Given Zz=4.5 ohmVz=8.2 VIzT=31 mA

Q: Which of the following statements about bridge tip rectifiers is false? A) If the 1-phase type has…

A: A  single-phase bridge-type uncontrolled rectifier consists of four diodes D1, D2, D3, and D4 (as…

Q: XProblem No.1 (PI). A fixed bias NPN BJT (Beta = 90) circuit is connected to a 16VDC supply with the…

A: