о to holdd the piv pivot in position to control the pointer movement

Q: 8.a. What is the purpose of relay CRE in the roll stand machine? A. Relay CRE is used as an…

A: CRE relay is used to detect fault in the input circuit. It is used in stop button of contact welding…

Q: 51. Four resistances each of value 42 are connected as shown in Fig. 2.36. The equivalent resistance…

A: Given circuit,

Q: 10m V Refer to Figure 5. 1. If v, = 5 mV, find current io 4kQ2 8K02 to V₁ 2k12 Vo Fig. 5 2. If v, =…

A:

Q: 2. Assuming ideal op amps, find the voltage gain vo/vin and input resistance Rin in each of the…

A: Solution (a) : Given Circuit  The voltage gain of the inverting amplifier is given by V0Vi = -RfRin…

Q: please show it clearly

A: It is given that:t13% of V∞=696.3103μsec

Q: Q1: Considering the modulation constellation diagram in figure below, x (k) (0,1) (0,0) & (1,1) a-…

A: Let the four symbols are  S1, S2, S3, S4 and they are as follows in the constellation diagram.…

Q: Given the open loop transfer function a system with unity feedback, K G(jw) = jw(1 + jw) (5+ jw)…

A: The given loop transfer function is Gjω=Kjω1+jω5+jω. Feedback is unity feedback Hjω=1. There are two…

Q: Consider the RC circuit shown in the figure below. The resistance of the circuit is R = 5.2k2 and…

A: During RC Charging circuit, the voltage across capacitor and resistor is equal to Vc(t) =Vin…

Q: Which of the following electrical devices or components operate based on the basic physical…

A: Heating effect of electric current - The heating effect of electric current is widely used in our…

Q: a) Convert the PCM binary sequence 1101000101 to NRZ(M) encoding and sketch the ASK and PSK waveform…

A:

Q: 6.a. The voltage in a 460-volt motor is changed to 425 volts. If the original torque was 125 lb-ft,…

A: Dear student as per our guidelines we are supposed to solve only one question in which it should…

Q: Determine R and Vz Given: ILMAX=200 micro ampere ILMIN=0 ampere V₁=12V V-16V R VL=12V

A: The Zener diode is used as a voltage regulator in the above circuit, where it cut-offs the supply to…

Q: sentences): 1) In relation to a transformer, the ratio 20 : 1 indicates that for every (20) twenty…

A: As per bartleby guidelines, for more than three true false type questions asked, only first three…

Q: The unit-step response of a unity feedback system with open loop transfer function is shown in the…

A: Given a unity feedback open-loop transfer function, Gs=Ks+1s+2 Hs=1 Unit response, Rs=1s Curve:

Q: What is the transfer function of the following arrangement: C₁ Gy

A: Given: The system block diagram,

Q: Determine VCB in the transistor circuit shown. The transistor is of silicon and has B = 150 * Rc100…

A: Given, The transistor circuit, β=150

Q: 1. To minimize the effect of the feedback circuit loading in oscillation frequency we we..........…

A: Since there are 4 different questions, as per the guidelines, in the following section, the first…

Q: A) Two 1-phase transformers with equal turn ratio have impedances of (0.5 + j3) and (0.6+j10) with…

A: The parallel configuration of transformer in s distribution system or load driving application helps…

Q: 8. An 8-bit ADC with a 10.0 V reference has an input of 3.637 V i. Determine the digital output. ii.…

A: Given, 8-bit ADC has  Reference voltage (Vref) = 10.0 V Input voltage (Vi) = 3.637 V

Q: What is the resolution of a analog to digital converter if the full scale voltage range is 8 volt…

A: Given: An ADC has Full scale voltage range, Range=8 V Number of bits, n=2

Q: Q2 If the unit step response of a network is (1 - e-at), then Find its unit impulse response

A: Given here a unit step response and asked to find the impulse response.

Q: hat is the definition of Diamagnetic, Paramagnetic and Ferromagnetic give examples and their…

A:

Q: 10m V Refer to Figure 5. 1. If v, = 5 mV, find current io 4k(2 8k(2 + V 2k2 Va Fig. 5 2. If v, = 20…

A:

Q: (a) Find the Q-point for the transistor in the circu in Fig. P4.114(a) if VDD = +12 V. (b) Repeat f…

A: Q point is a operating device it is also known as bias point. The steady state DC voltage &…

Q: Determine the current through the galvanometer using Thevenin's theorem. 30 Ω MN 20 Ω G 1940. Ω 100…

A:

Q: f the USART asynchronous transmitter is enabled and it takes 0.5x10s to transmit one frame, then…

A: For transmitting one frame the time taken is 0.5 ms. The baud rate is,  Baud rate=1tt=0.5×10-3 sBaud…

Q: CMOS stands for A) Common Metal Oxide Semiconductor B) Common Mono Oxide Semiconductor C) Common…

A: Given CMOS

Q: 9- Only one of the following interrupt numbers is available for the user: a. 1H X b. 255H c. 28H d.…

A: 9) which one of the following interrupt numbers is available for the user ?

Q: SOLVE FOR THE VALUE OF VOLTAGE (V)

A: Given that the different currents and resistance By using ohm law relation V= I*R.voltage is…

Q: The parameters of a 400/100V, 50Hz single phase transformer are given below: Z 1+j10, Z₂= 0.1 +…

A:

Q: A kWh meter can be classified as a /an O deflecting O digital Orecording indicating instrument.

A:

Q: Calculate the common emitter amplification factor of a transistor with a common base amplification…

A: For the above given question we need to calculate the value of common emitter amplification factor.

Q: R1 leee Fig. 7 Given that U = 12V, R₁ = 302, R₂ = R₂ =502, L=0.2H C = 4F. The switch has long time,…

A:

Q: calculate 80% response time for the sytem 0.8T+T=8u(t)

A: Given: the system 0.8T+T=8u(t)

Q: Find the equivalent capacitance

A:

Q: Given the circuit below with VO=4 V, R1 = 2 ohms, R2 = 8 ohms, and 10 = 3 A, R1 Va L 10 R2 VO…

A:

Q: 4. By using trigonometric functions, find the resultant horizontal and vertical components,…

A: Given:

Q: Given the characteristic equation of the denominator below, what is the damped frequency (od) of the…

A: Given, Transfer function, Gs=25s2+3s+25

Q: What will be the binary representation of 66 DEC in BCD coding system

A: Given: Decimal number 66

Q: A feeder-selector device at one of the stations of an automated assembly machine has a feed rate of…

A: Given data is shown below. Feed rate of automated assembly machine 20 parts/min It provides…

Q: - Define the Zeroth law of Thermodynamic? -What is Energy? And Energy forms?

A:

Q: 3. What is a fuel cell? With a neat diagram, explain the working principle of any one type of fuel…

A: 3. A fuel cell is a device that uses a chemical reaction to create electricity. Each fuel cell has…

Q: Consider a single phase transformer of rating 150 KVA, 3600/360, 50 Hz. Let the series resistance…

A: Formula to calculate voltage required to produce rated current at short circuit is: VSC=V1×ZPUwhere…

Q: Z₁= 1.2 + j2.4 , Z₂= 2.3 + j6.5 N, R=100 ₪, X=500 2 and Z₁=23 +j20 №.

A: Given: Z1= 1.2 +j 2.4 Ω Z2= 2.3+j6.5Ω R0= 100 Ω  X0= 500Ω ZL = 23+j20Ω

Q: Two 70 kW single-phase transformers are connected in parallel. The impedances of the first and…

A: The Given Two 70kW 1ϕ Transformer are connected in parallel. The 1st and 2nd transformer are 0.6+j6Ω…

Q: Q91 For the Logic Circuit shown in figure (6) write the SOP logical expression of the function (F)…

A:

Q: 2. A long shunt compound generator has full load output of 100 kW at 250 volts. The armature, series…

A: Given data, Pout=100kW Vt=250V Ra=0.05ohm Rsf=0.03ohm Rf=55ohm

Q: Q1) The impulse response of a linear time-invariant system is: h(n) [1 0 -1 3-2 4-2], Determine the…

A:

Q: The drawing shows three ac circuits, as shown below, each connected to identical generators.…

A:

Q: 3. Bandwidth efficiency is the ratio of the transmission bit rate to the minimum bandwidth required…

A:

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.