omplete the below free body diagram in your work and solve for the magnitude and angle of the r orce. Assume the following: the block has a mass of 15 kg, the spring is stretched 0.5 m and has a oring constant of 150 N/m, there is a cord attached to the block with a tension of T = 200 N onnected at an angle of 0 = 40°.

omplete the below free body diagram in your work and solve for the magnitude and angle of the r orce. Assume the following: the block has a mass of 15 kg, the spring is stretched 0.5 m and has a oring constant of 150 N/m, there is a cord attached to the block with a tension of T = 200 N onnected at an angle of 0 = 40°.

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter12: Static Equilibrium And Elasticity

Section: Chapter Questions

Problem 44P: A 90kg man walks on a sawhorse, as shown below. The sawhorse is 2.0m long and 1.0m high, and its...

See similar textbooks

Similar questions

A 90kg man walks on a sawhorse, as shown below. The sawhorse is 2.0m long and 1.0m high, and its mass is 25.0kg . Calculate the normal reaction force on each leg at the contact point with the floor when the man is 0.5m from the far end of the sawforce. (Hint: At each end, find the total reaction forces first. This reaction force is the vector sum of two reaction forces, each acting along one leg. The normal reaction force at the contact point with the floor is the normal (with respect to the floor) component of this force.)
Show neat work , Explanation required and Free body diagram.
If you weigh yourself on a bathroom scale at the equator,is the reading you get greater than, less than, or equal to thereading you get if you weigh yourself at the North Pole? Show your work and explain.
Shown to the right is a block of mass m sitting on a ramp that makes an angle θ with the horizontal. This block is being pushed by a horizontal force F. The coefficient of kinetic friction between the two surfaces is μ. A) Write an equation for the acceleration of the block up the ramp using variables from the problem statement together with g for the acceleration due to gravity. a=
Consider the information in the image below. Following the usual force problem procedure (using a force diagram , net force equations , etc. ) show that the maximum angle for which the box will not slide down the ramp is theta c with μs=tan(thetac), where μs is the coefficurnt of static friction.
Is my working method correct? I am also confused ablut the free body diagrams. Do i have to show the net force for that?
Does the mass of an abject affect the coefficient of friction? Like the ramp shown in the photo. How would I explan it mathamaticly knowing that the coefficient of friction is equal to the slope like (TAN THETA as I got in the other photo ) like would I have to do an example with mass and one without mass to see the difference.
Draw the free body diagram of a 10.0 kg block being pushed forward with 100.0 N. What force is needed that when applied to the block can yield a constant velocity of 20.0 m/s? What type of equilibrium is this block experiencing? How far will it travel in 60.0 seconds? plz show work so I can understand
SHOW COMPLETE AND CLEAR SOLUTION OR WRITING WITH FREE BODY DIAGRAM (FBD). EXPLAIN THE ANSWER SO THAT I CAN UNDERSTAND. EQUILIBRIUM OF NON-CONCURRENT FORCE SYSTEMS Where must the 2.2 kN force be applied so that the bar A whose mass is negligible will be in equilibrium in a horizontal position?
A 110-kg box is loaded into the trunk of a car. If the height ofthe car’s bumper decreases by 13 cm, what is the force constantof its rear suspension? Show your work and explain.
From the figure below, what is the net force acting on block Y?
A body with a mass of 5 kg rests on a rough horizontal table with a coefficient of static friction of 0.9. At a given moment, a horizontal force of 40 N is applied to this body, as shown in the figure. Analyze the propositions and answer the alternative that corresponds to the sum of the correct ones. Adopt g = 10 m/s². (01) With the data presented, we can conclude that the static friction force is 48 N. (02) In the proposed situation, the body will move with an acceleration of 5 m/s2. (04) In the proposed situation, the body will not move. (08) In the proposed situation, the body will be subjected to a frictional force of 40 N. (16) In the proposed situation, the body will be subjected to a frictional force of 45 N. (32) In the proposed situation, the net force in the body is null a) 12 b) 17 c) 19 d) 27 e) 44