or the circuit shown in number 6, find the equivalent current source and also the load current.

Q: Unit 4 During tum-on and tum-off of a power transistor, the -Vx current-time and voltage-time…

A: “Since you have asked multiple questions, we will solve the first question for you. If youwant any…

Q: For the circuit shown, findR * and Vs

A: To solve above problem concept required are: In series the current remain the same In parallel…

Q: Ideally, a dc load line is a straight line drawn on the collector characteristic curves between…

A: A dc load line is straight line drawn on the collector characteristics curve between

Q: R = 58 k2 Cc R2 = 42 k2 RE = 10 k2 For the circuit shown in Figure above, let ß = 125. (a) Find Icq…

A:

Q: Given the AND circuit using transistors. Draw a similar circuit using transistors to perform the…

A:

Q: For the circuits given below find the voltage of drain , source and gate ( Vo ,Vs,VG) of each…

A: (a) The figure (a) is shown below: It can be observed from the above circuit diagram that:  Vdd=15…

Q: Design a four-resistor bias network for a pnptransistor to give IC = 850 μA, VEC = 2 V, andVE = 1 V…

A:

Q: Design a four-resistor bias network for an npntransistor to give IC = 1 mA, VC E = 5 V, andVE = 3 V…

A:

Q: The transistor in Figure has parameters VTN = 0.4 V, k'n= 100 HAN?, and W/L = 100. What are the…

A: NMOS

Q: c. Draw the d.c load line for the circuit diagram shown below. What will be the Q point if zero…

A: Given circuit can be drawn as zero signal-- Short circuit IB=25μAβ=60IC=βIB=25×60μA…

Q: Q3: For the circuit shown find the: Io, Va, Vr. Rp. Draw the characteristic load line curve and find…

A: As per Bartleby guidelines we are allowed to solve only three subparts,please ask the rest again.

Q: Rs 100 N Vs iB Vs = Vs + Vs RL = 1 kN VL = VL + v1 %3D + Biasing Component Vs = 6 V UB + 5 1

A: We need to find out unknown resistance value and Gain for given circuit

Q: Q3: For the circuit shown find the: ID, VD, VR, RD. Draw the characteristic load line curve and find…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Generate the state table and diagram of the circuit.

A: Consider the given circuit,

Q: The Si transistor of of the following figure is biased for constant base current. If B-80, VCr- 8V,…

A:

Q: 4 Construct state graph for the Circuiti- state table and given

A:

Q: PCM is very popular because of the many advantages it offers, enumerate these advantages? What is…

A: Since the full form of PCM is not mentioned so w are considering PCM as Pulse Code Modulation. It is…

Q: VDD R3 R1 R2 (VI |

A:

Q: Give an example problem of base resistor biasing  with their solution.

A: Method of the Base ResistorAs the name says, a high-resistance resistor RB is connected in the base…

Q: Draw the hybrid equivalent circuit for common base configuration and also write down the h-parameter…

A: Here, we have asked to draw the hybrid equivalent for the common-base configuration. So, we will…

Q: A 10mV signal is applied to the input of the circuit in the figure. What will be the gain when a 10…

A:

Q: IDSS=8mA , VP =-4V To help plot the DC load line VGS=VG-IDRS a)Attach a Plot of JFET Characteristic…

A: The required parameters can be calculated by using DC analysis of FET amplifier circuit.

Q: The transistor in the shown figre has Br-150 1) What is the type of this configuration ? 2) Draw the…

A:

Q: Consider the circuit shown: Obtain the AC and DC circuit analysis for the collector voltage.

A:

Q: What is threshold voltage for MOSFET? Derive the equation of Vt of MOSFET. V; = Vco + Y [V(2. @, +…

A:

Q: 3-5- Discussion:- 1- Why the output voltages drop when the load current is increased?

A: Since you have posted the multiple questions so we are supposed to answer 1st one.

Q: If we assume that the nominal load of this circuit is equal to the input resistance of the supply (1…

A: The nominal load of this circuit is equal to the input resistance of the supply i.e.,1 kΩ.

Q: Design the network that will maintain VL, at 12 V for a load current of 200 mA. That is determine…

A: The zener based voltage regulator circuit can be designed with the help of ohms law and voltage…

Q: Draw and design a FET circuit with voltage divider biasing arrangement that has the plot shown in…

A: Given, The transfer curve of the FET circuit is shown below, From the above graph,VGS=12.5 VID=6.7…

Q: Find the AC values for the unloaded common-base amplifier. Draw the equivalent AC network. Use 25…

A: The ac circuit of the amplifier can be redrawn as The DC circuit of the amplifier will Now the…

Q: A 2N5668 has VGS(off) = -4 v and IDSS = 5mA. What are gate voltage and drain current at the half…

A: Given, The gate to source voltage VGS(off) = -4 V The drain to source current IDSS =5 mA

Q: Generate the state table and diagram of the circuit

A: Given the sequential circuit: We need to generate the state table and state diagram of the circuit.

Q: 1. Determine in which mode (depletion, enhancement or neither) each D-MOSFET in the figure -Vpp…

A:

Q: Illustrate the circuit diagram

A: Given values, Terminal voltage, Vt= 230 V Load current, IL= 150 A Shunt field resistance, Rsh= 92…

Q: ind the Vds and Vce voltage values ​​for the given circuit

A: Given circuit is shown below. Given data is IDSS=6mA, Vp=-6V, β=100 Apply voltage division…

Q: Label properly the required final circuit and DC loadline. Complete the given BJT circuit. Solve…

A:

Q: Explain any two signal processing in the 3 measurement system with best diagrams

A: Measurement system :   Any of the systems employed in the process of integrating numbers with…

Q: 12U lotd VCE VBE 20018 ß =l00 VCE=? Vo=? %3D

A: We will apply KVL in base emitter loop to find base current.  Emitter current=Collector current+…

Q: The circuit in the visual containing a non-linear element will be analyzed with the Small Signal…

A:

Q: The dc load line on a family of collector characteristic curves of a transistor shows the active…

A: we need to identify what the DC load line on a family of collector characteristic curves of a…

Q: The transistor shown has B=100 and Exercises-8: Vee-10V VA=100V. (a) Find the de voltages at the…

A:

Q: + VDp= 24 V 100 k2 ER, Rp= 4702 15 k2 R2 ww

A: we need to find drain current ID and Vds.

Q: 4. For an n-channel enhancement-type MOSFET, it is given that Vh=4 V and Ip(on) = 4-mA at VGs(on)= 6…

A: Given:Vth=4 VIDon=4 mAVGSon=6 V

Q: In D-MOSFET, if VGS-off=-4 V & VDs is constant, then if VGS is varied to - 6 V, the D-MOSFET will…

A: We need to whether the given statement is true or false.

Q: B) Design BCD to Excess-5 converter, using Karanough-map.

A:

Q: Q2): For common collector circuit shown below: 1. Determine DC load line and Q-point? 2. Determine…

A: (i)  Now drawing the circuit according to dc analysis Applying KVL in BE junction,…

Q: Explain the generation of PWM by common collector circuit and also write at least five applications…

A: Pulse Width Modulation (PWM) is a typical technique for managing DC power to an electrical…