Ostwald viscometer is also known as ocillating sphere viscometer falling sphere viscometer glass capillary viscometer bubble tube viscometer The force required to slip one layer of a fluid past another with a given velocity is * surface tension shear stress O viscosity Rate of shear

Ostwald viscometer is also known as ocillating sphere viscometer falling sphere viscometer glass capillary viscometer bubble tube viscometer The force required to slip one layer of a fluid past another with a given velocity is * surface tension shear stress O viscosity Rate of shear

Physical Chemistry

2nd Edition

ISBN:9781133958437

Author:Ball, David W. (david Warren), BAER, Tomas

Publisher:Ball, David W. (david Warren), BAER, Tomas

Chapter22: Surfaces

Section: Chapter Questions

Problem 22.7E

See similar textbooks

Related questions

Q: A right circular cone of base radius R, height H, and known density ρs floats base down in a liquid…

A: Archimedes principle states that the upward buoyant force exerted on a body immersed in a fluid,…

Q: For whole blood flowing in a capillary of radius 1.9x10-4 cm, estimate the maximum velocity for…

Q: can diffusion be reversed

A: Yes diffusion can be reversed.

Q: 3-D contour surfaces

A: In this question we have to draw the 3-D contour for a 4p orbital.

Q: A liquid (specific gravity =0.78, vapor pressure =3.2 kPa) flows through a contraction pipe at a…

Q: An ostwald viscometer was used to determine the time of flow of syrup at 20°C Data of water: Time of…

Q: The viscosity of methane at 20 °C and 1 atm pressure is 1.09x10-4 poise. Calculate the number of…

A: Please open the attachment.

Q: A plastic strip having a width of 0.2 m and a mass of (250+n) g passes between two layers A and B of…

A: Viscosity is the internal friction which opposes the relative motion of the adjacent layer of a…

Q: Water required 120.5 seconds to flow through a viscometer and the same volume of acetone required…

Q: Prove that for non-steady state of diffusion the penetration of a specified concentration is found…

A: Diffusion is the process of mixing up of gas into other gaseous substances. The rate of diffusion is…

Q: A Poiseuille flow experiment was carried out to measure the viscosity of air at 298 k. The sample…

A: Detail mathematical calculation is shown below to find out viscosity in cP unit . Here , 1 cm = 10…

Q: In an Ostwald viscometer, the measured distance the liquid travels (L) and L; and by procedure, the…

A: In an Ostwald viscometer the measured distance the liquid travels, L, will be always a constant; the…

Q: The viscosity coefficient of gaseous chlorine at 1 atm pressure and 20 C is 147.0 micropoise. Find…

Q: Resistance to flow. * Viscosity Shear surface tension Rate of shear Evaluate the statement whether…

A: Viscosity means the resistance of flow of fluid (liquid or gas) offer by one layer of fluid to…

Q: The measurement of flexural modulus over a wide range of temperatures of a thermoplastic elastomers…

A: The flexural modulus is the ratio of stress to strain and it is an intensive property. It indicates…

Q: solve the heat loss by warm water, latent heat of fusion of ice (experimental), and the percentage…

A: Solution

Q: The viscosity coefficient of methane at 0 °C is 102.6x10-6 poise. Calculate the molecular diameter.

Q: What is van deemter equation? Plot a graph showing relationship between height of theoretical plates…

A: Van deemter equation is an empirical formula which describes about the relationship between plate…

Q: The bulk flow of a liquid through a tube is directly proportional to tube diameter. This phenomenon…

A: fluid in larger diameter tubes has a higher viscocity

Q: Data for Syrup: Time of flow: 1.42 seconds Density at 20 °C: 1.153 g/cm³ 1. What is the fluidity of…

Q: Calculate the surface tension of a liquid at 25 °C given that at that temperature, the liquid climbs…

Q: Experiment conduct and observation: Temperature, deg. C Viscosity, Saybolt seconds 40 177 50 106 60…

Q: A Poiseuille flow experiment was carried out to measure the viscosity of air at 298 K. The sample…

A: Detail mathematical calculation is shown below

Q: Determine the maximum allowable spacing s of the nails used to hold the top flange to the web. e…

A: Question is solved below

Q: A hypothetical metal made up of one chemical element has a BCC crystal structure. A diffractometer…

A: Given wavelength = 0.1542 nm atomic radius = 0.1363 nm

Q: The principle of this viscometer is to determine the falling time of a sphere with known density and…

A: Viscometer is a device use to measure the viscosity of the liquid

Q: Determine the M,, and Mw for each concentration of polystyrene sample, which has an a value of (a-1)…

A: The ratio of time and time of descent is obtained. The obtained ratio is subtracted from the…

Q: A cylindrical specimen of a titanium alloy having an elastic modulus of 107 GPa and an original…

A: Final answer: 0.255m = 255mm ( 10.0 in. )

Q: Consider a metal single crystal oriented such that the normal to the slip plane and the slip…

A: Given: φ = 43.1°, λ = 47.9° critical resolved shear stress = 20.7 MPa and applied tensile stress =…

Q: computed viscosity of honey

Q: Source of error in viscosity for glycerin liquid.

Q: Draw a graph (not to scale) depicting the relationship between shear stress and shear rate…

A: Please find the graph attached.

Q: Draw stress strain curve for an amorphous polymer at operating temperature T (on same plot) a. T« Tg…

Q: In this viscometer, a liquid is allowed to flow through its capillary tube between two etched marks…

Q: Stress - Strain Behaviour Formula A cylindrical metal specimen 15.0 mm in diameter and 150 mm…

Q: 9 Gpa, A 0.35) is loaded by an axial force of 3 N, addas ou 22 24 mm 20 12 mm 15 mm d Detemine he…

A: givenaxial load P=3kNyoungs modulus E=69GPapoisson ratio μ=0.35Diameter of member AB d=12mmDiameter…

Q: According to Riippi et al. (1998), briefly discuss the effects of increased compression force to the…

A: When compression force increased drug material will suffer some deformation that causes the average…

Q: For whole blood flowing in a capillary of radius 1.9x10-4 cm, estimate the maximum velocity for…

Q: A poiseuille flow experiment was carried out to measure the viscosity of air at 298 k. the sample…

A: Given,Length of tube = 100 cmInternal diameter of tube = 1 mmHigh pressure = 865 TorrLow pressure…

Q: OMMONLY ENCOUNTERED "DIRICHLET" BOUNDARY CONDITION FOR THE HEAT DIFFUSION EQUATION AT A SURFACE…

A: According to the question, we need to determine the commonly encountered "Dirichlet" boundary…

Q: 12.7/ Determine the flow rate of air through an axial bush seal. The outer diameter of the inner…

Q: A poiseuille flow experiment was carried out to measure the viscosity of air at 298 K. The sample…

A: At 298 K the sample of air is passed through a 100 cm tube of 1mm internal diameter. The high…

Q: In an experiment with an Ostwald Viscometer, the viscosity of toluene and water at 30 degC is 0.5789…

A: Note - Since you have asked multiple question, we will solve the first question for you. If youwant…

Q: The viscosity coefficient of a liquid at 20 degrees C equals 151.7 cp. Find the force per unit area…

Q: An alloy has an elastic modulus of 115 GPa. For the alloy, plastic deformation begins at a stress of…

Q: Determine the viscosity of diethyl ether at 77 degrees Celsius. (Pa·s)

A: 1. From Dortmund data bank of diethyl ether, The viscosity of diethyl ether at 77°c = 350.15k is…

Q: For a face center cubic crystal, where the applied load is in the [1 0 0] direction, assume the ABC…

A: From the given data, Let a unit cell be A=[1,0,0], B = [0,0,1] and C = [0.1,1,0] Here, the equation…

Question

100%

Choose the best answer among the choices under each question/ statement. Thank you

Ostwald viscometer is also known as
ocillating sphere viscometer
falling sphere viscometer
glass capillary viscometer
bubble tube viscometer
The force required to slip one layer of a fluid past another with a given
velocity is *
surface tension
shear stress
O viscosity
Rate of shear

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

What is the surface tension of benzene(in micro-Newton/m), if it rises to a height of 1.06299 inch in a capillart tube with a circumference of 1.570796 mm. The density of benzene is 54.477 lb/ft³. With the contact angle to be 0°.
Measure the liquid viscosity from a core sample using lab experiments. Display the liquid viscosity using experimental results.
Source of error in viscosity for glycerin liquid.
PLEASE ANSWER THEM ALL IN ASAP FOR AN UPVOTE. I PROMISE THAT. THANKYOU. An Ostwald viscometer was used to determine the time of flow of honey at 20 °C. Data for Water:Time of flow: 0.23 secondsDensity at 20 °C: 0.998 g/cm³Viscosity: 0.0101 poise Data for Honey:Time of flow: 20.79 secondsDensity at 20 °C: 1.426 g/cm³ a.) What is the viscosity of honey? b.)From the computed viscosity of honey, what will be its kinematic viscosity? c.) From the computed viscosity of honey, what will be its fluidity?
A cylindrical specimen of a titanium alloy having an elastic modulus of 107 GPa and an original diameter of 3.8 mm. will experience only elastic deformation when a tensile load of 2000 N is applied. Compute the maximum length of the specimen before deformation if the maximum allowable elongation is 0.42 mm
An Ostwald viscometer was used to determine the time of flow of syrup at 20 °C. Data for Water:Time of flow: 0.23 secondsDensity at 20 °C: 0.998 g/cm³Viscosity: 0.0101 poiseData for Syrup:Time of flow: 1.42 secondsDensity at 20 °C: 1.153 g/cm³ Input all numerical answers to the 3rd decimal place 1. What is the viscosity of syrup? * 2. From the computed viscosity of syrup, what will be its fluidity? 3. What is the kinematic viscosity of water? 4. From the computed viscosity of syrup, what will be its kinematic viscosity? 5. What is the fluidity of water?
A poiseuille flow experiment was carried out to measure the viscosity of air at 298 K. The sample was allowed to flow through a 100 cm tube of internal diameter 1 mm. The high pressure end was at 865 torr and the low pressure end was at 760 torr. The volume was measured at the latter pressure. In 59 seconds a volume of 90.2 cm^3 passed through the tube. What is the viscosity in cp of air at this temperature
The viscosity of methane at 20 °C and 1 atm pressure is 1.09x10-4 poise. Calculate the number of collisions per second in 1 mL of the gas at 0 °C and 0.1 atm pressure (assume the collision diameter to remain constant).
solve the heat loss by warm water, latent heat of fusion of ice(experimental), and the percentage error
A bar of material with a cross sectional area of 50 mm? is subjected to tensile force of 200 N. Tensile stress in the material in Pascal (Pa) is equal to a. 1 000000 b. 2 000000 c. 8 000000 d. 4 000000
An ostwald viscometer was used to determine the time of flow of syrup at 20°C Data of water: Time of flow: 0.23 sec Density at 20°C: 0.998 g/cm3 Viscosity: 0.0101 poise Data of Syrup: Time of flow: 1.42 sec Density at 20°C: 1.153 g/cm3 1. What is the fluidity of water? 2. What is the Viscosity of syrup? 3. From the computed Viscosity of syrup, what will be its kinematic Viscosity? Show complete solution.
The viscosity of Ethyl acetate determined at 25°C was 4.2cp. The efflux time for water to flow from marks A to B was 3 minutes.Additional data: Viscosity of water at 25°C = 1.002cp Density of water at 25°C = 0.997g/mL Calculate for the time for a 10.0mL Ethyl acetate (equivalent to 5.0g) to flow from Marks A to B.