P. L Z(1) L.

Q: )Water 10°c flows down through a 53.13 deg, nclined, converging pipe section as shown. The fiow…

A:

Q: An unfinished concrete duct, of diameter 1.5 m, is flowinghalf-full at 8.0 m3/s. (a) Is this a…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: Q2: Find the piezometric head at tank (C), if the discharge in pipe (1) = (65 L/sec). Use (-0.025)…

A: 2)   Given:   find the piezometric head at tank c        Q1= Discahrge in pipe 1=65…

Q: 6. Draw the hydrograph and flow duration curve for the following data. Also find aven powerdevelo…

A: Given that, Week Discharge 1 100 2 200 3 300 4 1200 5 600 6 900 7 800 8 600 9…

Q: Q2: Water is flowing through a horizontal venture meter. The inlet diameter is 250 mm, while the…

A:

Q: Fresh water at 20°C flows from reservoir A to reservoir B as indicated. Calculate the flow rate by…

A:

Q: Water flows from a faucet into a sink at 3 U.S. gallonsper minute. The stopper is closed, and the…

A: As it is mention that the water level remains constant, water entering the system is equal to the…

Q: 6.60 Potential flow against a flat plate (Fig. P6.60a) can be de- scribed with the stream function ý…

A:

Q: For the water channel fl ow of Fig.=, h 1 = 0.45 ft,H = 2.2 ft, and V 1 = 16 ft/s. Neglecting losses…

A: Write the given data.

Q: The reservoirs in Fig. contains water at 208C. If thepipe is smooth with L = 4500 m and d = 4 cm,…

A: The temperature of the water in the reservoir is T=208 C. The length of the pipe is L=4500 m. The…

Q: Water at 40°C flows horizontally through a constriction similar to that in Fig. S3.9 when the…

A: Given,  Temperature of flow 40 C Pressure at section 1 , P1 = 35 KPa Diameter at section 1 , d1 =…

Q: In Fig. , free discharge, a gate opening of 0.72 ft willallow a fl ow rate of 30,000 gal/min. Recall…

A: Given dataflow rate Q=30 000 gal/min width b=8 ft    y1=6 ft    y2=4 ft    H=0.72 ft

Q: The Kishwaukee river has a volume flow rate of 21 ft3/sec with a depth of 2.8 ft. If the…

A:

Q: The connecting pipe is commercial steel 6 cm in diameter. Estimate the flow rate, in m³/s, if the…

A:

Q: C- Estimate the velocity at point (2) and discharge of oil that as a petroleum engineer want to…

A: From the data given, Change in pressure between section 1 and 2 = P1 - P2 = 100 kPa = 100 x 103 Pa…

Q: Q5: A fluid flow is given by: V =(4x*)i – (16x’y)j Find shear strain rate and whether the flow is…

A:

Q: A straight 10-cm commercial-steel pipe is 1 km long and islaid on a constant slope of 5°. Water at…

A: Properties of water at 20°C Using Bernoulli equation at point 1 and 2

Q: Water falls vertically downward from an open faucet with an initial velocity of 47 cm/s. If the…

A:

Q: What is the diameter of smalle pipe,

A: For solution refer below images.

Q: An incompressible fluid flows past an impermeable flat plate with a uniform inlet profile (Uo ) and…

A: GIvenInitial velocity=u=UoFinal velocity=u=Uo3η-η32Here η=yδ

Q: For the series-parallel system of Fig.2, all pipes are 8 cm-diameter asphalted cast iron. If the…

A: p2-p1 = 750 kpa Diagram

Q: Refer to Fig. P5.4. Water at 10°C flows up AB (5 m long, 40 mm diameter), B then along BC (3 m long,…

A:

Q: (Hardy Cross Method (2 iterations) and EPANET) For the same system, determine the pressures and…

A: applying the bernoullis equation we get P1ρg+V122g+z1=P2ρg+V222g+z20.8 x 14462.4 x 39.17+d22 x…

Q: Assume that r = 0.137 m, ro = 0.138 m, µ = 1.49 kg/m-s (glycerin), p = 1260 kg/m3, and Qj = 120…

A:

Q: An engineer claims that the flow of SAE 30W oil, at 20 °C,through a 5-cm-diameter smooth pipe at 1…

A: Given data: The diameter pipe, d = 5 cm. Flow rate through pipe, Q = 1 million N/h. Now density of…

Q: 2. A flow of water of 100 litres per second flows down in a rectangular flume of width 60 cm having…

A: Given data: Discharge (Q) = 100 lts/s                        = 100/1000                        = 0.1…

Q: Question 3 Calculate the Kentrance = 0.04 Kexit = 1 total head loss, Kvalve = 5 Kelbow = 0.9 1 m H,…

A:

Q: air through a slhock wave the upstream ve3 V,= 600m/s To=500k,=700k Pa, Compute the downstream…

A: Given: Upstream conditions: V1 = 600 m/s Po = 700 kPa To = 500 K

Q: Gasoline (s = 0.68, μ = 0.00029 kg/m.s) is being siphoned through a 18 mm, diameter plastic tube, as…

A: Given; Calculate the cross-sectional area of the pipe. Here, D is the diameter of the pipe.…

Q: 25 mm Hg -> 0.09 m2 150 mm Water Problem 4.17 4.17. For a flowrate of 2 m'/s of air (y = 12.0 N/m')…

A:

Q: -Example Calculate the values asystem total head against. Capacity curve for the initial condition,…

A:

Q: P6.55 The reservoirs in Fig. P6.55 contain water at 20°C. If the pipe is smooth with L = 4500 m and…

A: As per the given question..

Q: A soda straw is 20 cm long and 2 mm in diameter. It deliverscold cola, approximated as water at…

A: (a) The value of density and viscosities of the weather at 10°C are: ρ=1000 kgm3 and μ=1.307×10-3…

Q: Recall that the transverse velocity for Poiseuille flow is Ap u(r) = 4µL + cị Inr+ c2, 0 < r < R,…

A:

Q: A thin water (density 997 and dynamic viscosity 0.001009 Pa.s) sheet of 2.127 mm thickness, slides…

A: Ans: option (d) is correct.

Q: Fluid flows steadily, at volume rate Q, through a large horizontalpipe and then divides into two…

A: Given data: The inside diameter of the large pipe is dL = 25 mm.

Q: Consider a turbine extracting energy from a penstock in a dam, as in Fig. P3.171. For turbulent pipe…

A: Draw a diagram for the problem. Write the Bernoulli’s equation assuming steady flow between points…

Q: If L =4.5 km, d- 40 mm and Az 100 m, what will be the flow rate of water in m'/hr. Make suitable…

A:

Q: For flow of oil sg=0.82, through a 120mm diameter pipe, for what flow rate in liters per minute…

A: Given data: SG=0.82μ=0.105 Pa.sd=120 mm Need to determine the flow rate in liters per minute would…

Q: Prob4 Flowing Liquid: Water; Pipe length: L=600 m; Diameter: D=0.15 m; Q = 0.06 m³/s; h₁ = 50 m…

A: Head losses in the pipe: When fluid flows through a pipe, there are two types of head losses: large…

Q: A large Rankine oval, with a= 1 m and h = 1 m, isimmersed in 20°C water flowing at 10 m/s. The…

A: Given, A large Rankine oval with a=1m and h=1m. Water temperature =20°C Water velocity, U∞=10m/s.…

Q: Two water tanks, each with base area of 1 ft2, are connectedby a 0.5-in-diameter long-radius nozzle…

A: For water at 20oC, take density as  1.94 slug/ft3 and viscosity   2.09x10-5 slug/ft.s. For a…

Q: 10.32 Water at 20°C flows through a 3 cm ID smooth brass tube at a rate of 0.002 m³/s. What is ƒ for…

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: Water at 40°C flows horizontally through a constriction similar to that in Fig. S5.9 when the…

A: Given: Pressure P1=35kPaAtmospheric pressure Patm=715mmHgDiameter D1=0.5mDiameter D2=0.15mSpecific…

Q: Ethylene glycol at 20°C flows through 80 m of cast ironpipe of diameter 6 cm. The measured pressure…

A: Given dataLength of cast iron pipe L =80mDiameter of the pipe d= 6 cm = 0.06mPressure drop ∆p=…

Q: A heat exchanger consists of a series of passages between parallel plates. The pressure drop is…

A:

Fluid Dynamics

The study of the flow of gases and liquids, usually in and around solid surfaces, is known as fluid dynamics in physics and engineering. Fluid dynamics, for example, can be used to evaluate the movement of air through an airplane wing or the surface of a vehicle. It can also be used in ship design to increase the speed at which ships pass through water.