Part A 100 mL of water at 20.0 °C is placed in the freezer compartment of a refrigerator with a coefficient of performance of 4.00. How much heat energy is exhausted into the room as the water is changed to ice at -5.00 °C? Express your answer with the appropriate units. HA Value 6 Units Submit Request Answer ?

Part A 100 mL of water at 20.0 °C is placed in the freezer compartment of a refrigerator with a coefficient of performance of 4.00. How much heat energy is exhausted into the room as the water is changed to ice at -5.00 °C? Express your answer with the appropriate units. HA Value 6 Units Submit Request Answer ?

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter15: Thermodynamics

Section: Chapter Questions

Problem 42PE: (a) What is the best coefficient of performance for a refrigerator that cools an environment at...

See similar textbooks

Similar questions

An electrical power station uses 1.33 1014 J of heat input with an efficiency of 34.7%. (a) How much work is done? (b) How much waste heat is produced by the station? (c) What is the ratio of waste heat to work output?
What is the coefficient of performance of an ideal heat pump that has heat transfer from a cold temperature of -23.0°C to a hot temperature of 44.0°C?
Suppose a woman does 650 J of work and 9300 J of heat is transferred from her into the environment in the process. a. What is the change in her internal energy, in joules, assuming she does not consume any food? b. What is her percent efficiency?
In an air conditioner, 12.65 MJ of heat transfer occurs from a cold environment in 1.00 h. (a) What mass of ice melting would involve the same heat transfer? (b) How many hours of operation would be equivalent to melting 900 kg ofice? (c) If ice costs 20 cents per kg, do you think the air conditioner could be operated more cheaply than by simply using ice? Describe in detail how you evaluate the relative costs.
A power plant has been proposed that would make use of the temperature gradient in the ocean. The system is to operate between 19.0°C (surface water temperature) and 4.95°C (water temperature at a depth of about 1 km). (a) What is the maximum efficiency of such a system? ?%(b) If the useful power output of the plant is 80.0 MW, how much energy is absorbed per hour? ?J(c) In view of your answer to part (a), do you think such a system is worthwhile (considering that there is no charge for fuel)?
(II) How much less per year would it cost a family to operatea heat pump that has a coefficient of performance of 2.9 thanan electric heater that costs $2000 to heat their home for ayear? If the conversion to the heat pump costs $15,000, howlong would it take the family to break even on heating costs?How much would the family save in 20 years?
(II) (a) What is the coefficient of performance of an idealheat pump that extracts heat from 6°C air outside anddeposits heat inside a house at 24°C? (b) If this heat pumpoperates on 1200 W of electrical power, what is the maximumheat it can deliver into the house each hour? see the attached problem
A heat pump (h=0.3) uses 2500J of work to transfer heat energy. a)how much heat energy is absorbed by the hot reservoir? b) how much heat energy is released by the cold reservoir?
5. (a) How much heat transfer occurs to the environment by an electrical power station that uses1.25 × 10^14 J of heat transfer into the engine with an efficiency of 42.0%? (b) What is the ratioof heat transfer to the environment to work output? (c) How much work is done?
Suppose that a deep shaft were drilled in Earth’s crust near one of the poles, where the surface temperature is -40 C, to a depth where the temperature is 800 C. (a) What is the theoretical limit to the efficiency of an engine operating between these temperatures? (b) If all the energy released as heat into the lowtemperature reservoir were used to melt ice that was initially at -40 C, at what rate could liquid water at 0C be produced by a 100 MW power plant (treat it as an engine)? The specific heat of ice is 2220 J/kg K; water’s heat of fusion is 333 kJ/kg. (Note that the engine can operate only between 0C and 800C in this case. Energy exhausted at -40C cannot warm anything above -40C.)
(a) What is the best coefficient of performance for a heat pump that has a hot reservoir temperature of 60.0°C and a cold reservoir temperature of -22.0°C? (b) How much heat transfer (in kcal) occurs into the warm environment if 3.60 ✕ 107 J of work (10.0 kW · h) is put into it? _______kcal (c) If the cost of this work input is 10¢/kW · h, how does its cost compare with the direct heat transfer achieved by burning natural gas at a cost of 87.0 cents per therm. (A therm is a common unit of energy for natural gas and equals 1.055 ✕ 108 J.) cost of heat pump cost of natural gas
(a) How much food energy will a man metabolize in the process of doing 35.0 kJ of work with an efficiency of 5.00%? (b) How much heat transfer occurs to the environment to keep his temperature constant? Explicitly show how you follow the steps in the Problem-Solving Strategy