Part A The calcium ion Ca2+ has charge +2e, so equation for the Nernst potential must have e replaced by 2e. The Nernst potential of Ca?+ is +135 mV. If the Ca2+ ion concentration outside the cell is 2.0 mM, a typical value, what is its concentration inside the cell? Express your answer in terms of molarity. ? Cin = M Submit Request Answer

Part A The calcium ion Ca2+ has charge +2e, so equation for the Nernst potential must have e replaced by 2e. The Nernst potential of Ca?+ is +135 mV. If the Ca2+ ion concentration outside the cell is 2.0 mM, a typical value, what is its concentration inside the cell? Express your answer in terms of molarity. ? Cin = M Submit Request Answer

Appl Of Ms Excel In Analytical Chemistry

2nd Edition

ISBN:9781285686691

Author:Crouch

Publisher:Crouch

Chapter10: Potentiometry And Redox Titrations

Section: Chapter Questions

Problem 2P

See similar textbooks

Similar questions

When measured with a F− ion-selective electrode with a Nernstian response at 25°C, the potential due to F− in unfluoridated groundwater in a nearby city was 40.7 mV more positive than the potential of tap water in a distant city. The distant city maintains its fluoridated water at the recommended level of 1.00 ± 0.05 mg F−/L. What is the concentration of F− in mg/L in groundwater in the nearby city? (Disregard the uncertainty. Assume that the Nernst potential is 0.05916 V.)
Create a calibration curve. Electrode potential (mV) vs. log [Ca2+]. (complete with, the equations of the best fit line, and the correlation coefficient) log[Ca 2+] Electrode potential (mV) -5 -105.4 -105.1 -106.5 -6 -120.9 -120.3 -120.6 -4.4 -96.6 -97.2 -96.5 -4 -85.5 -85.8 -85.2 -3 -56.6 -56.2 -56.4 -2 -26.6 -27.1 -27.1
When measured with a Fion-selective electrode with a Nernstian response at 25oC, the potential due to Fin unfluoridated groundwater in Foxboro, Massachusetts, was 40.0 mV more positive than the potential of tap water in Providence, Rhode Island. Providence maintains its fluoridated water at the recommended level of 1.00 ± 0.05 mg F-/L. What is the concentration of F-in mg/L in groundwater in Foxboro? (Disregard the uncertainty.)
An ion-selective electrode (ISE) produces voltage output (mV) proportional to solution pH. You have three standard pH solutions (4, 7, and 10). Assuming that pH 7 buffer solution is used together with pH 4 for calibration prior to measuring acidic solutions and together with pH 10 before measuring alkaline solutions, produce a flowchart of the calibration routine for a single pH ISE.
In a voltammogram, which of the following statements is correct 2 a. The limiting current i, is used for quantitative analysis b. The half-wave potential E₁/2 is used for quantitative analysis c. The limiting current i depends on the identity of the analyte d. The half-wave potential E1/2 dependens on the analyte concentration A 0.20 g sample of primary standard Na₂C₂O4 (134 g/mol) needed 37.22 mL of of KMnO4 solution to reach the end point. What is the molarity of KMnO4 reagent a. 0.14 M b. 0.016 M C. 0.65 M d. 0.0014 M In the glucose sensor, the component diffuses through the inner layer of the electrode is the J a. gluconic acid b. hydrogen peroxide c. glucose d. glucose oxidase
Calculate the required voltage (V) if an unknown metal (M) was electrodeposited from an aqueous solution containing M2X2 (where X is the anion) with a supplied current of 5.92 A for 12 h, consuming 0.1731 kWh of electrical energy. Assume that the current efficiency is 87%. (Input values only with 2 decimal places).
The following data were obtained with a cadmium-selective solid-state electrode. The ionic strength of each solution was 0.30 M, and the reference electrode was a saturated calomel electrode. Determine the concentration of the unknown cadmium ion in the sample. [Cd2+], M 1.00x10-1 8.75x10-3 1.00x10-3 3.16x10-5 3.16x10-6 Unknown E, V -0.115 -0.150 -0.175 -0.213 -0.242 -0.200
Calculate the standard potential and the Ecell of Pt ǀ Fe2+ (0.05), Fe3+ (0.01) ǁ MnO-4 (0.02), Mn2+ (0.008) ǀ C
Show that E = +1:25 V when pH = 3.0 and the ratio [Mn2+]: [MnO4] =1: 100. Please answer ASAP
Calculate the measured current density for metal M when immersed in boiling water, it's found that the anodic potential is 0.2 V and cathodic potential is 0.09 V, and the exchange current density is 20 mA / m'.q = 0.5
5. An infinite flat plate of a solid has a surface potential of 50 mV in an infinite bath of 10-2 molL-1 NaCl(aq) aqueous solution at 298K. Make a plot of the potential, y, the Na+ ion concentration, and the Cl- ion concentration as a function of distance from the interface using (a) the exact equation for potential and (b) the low potential approximation. Comment on the difference between your answer for (a) and (b).
The sensitivity of a coulometer is governed by the delivery of its minimum current for its minimum time. Suppose that 5 mA can be delivered for 0.1 s.(a) How many moles of electrons are delivered at 5 mA for 0.1 s? (b) How many milliliters of a 0.01 M solution of a two-electron reducing agent are required to deliver the same number of electrons?