PC1 PC2 IP: 192.168.1.2 IP: 192.168.1.3 Refer the above diagram. Scenario Two PC's are connected to a switch. The IP addresses of the PC's are as displayed in the diagram. PC (192.168.1.2) is connected to port 2 on the switch and PC (192.168.1.3) is connected to port 3 on the switch Questions 1. Does the switch need an IP address for PC1 to communicate with PC2 2. What would be the mac-address learned by the switch on port 2 3. If the PC on port is disconnected, would the mac-address table be flushed

PC1 PC2 IP: 192.168.1.2 IP: 192.168.1.3 Refer the above diagram. Scenario Two PC's are connected to a switch. The IP addresses of the PC's are as displayed in the diagram. PC (192.168.1.2) is connected to port 2 on the switch and PC (192.168.1.3) is connected to port 3 on the switch Questions 1. Does the switch need an IP address for PC1 to communicate with PC2 2. What would be the mac-address learned by the switch on port 2 3. If the PC on port is disconnected, would the mac-address table be flushed

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter13: Internet And Distributed Application Services

Section: Chapter Questions

Problem 15VE

See similar textbooks

Similar questions

21.) Consider the following configuration. Computer “A” IP address: 172.16.100.100 Subnet mask: 255.255.0.0 Computer “B” IP address: 172.16.200.200 Subnet mask: /16 What should be done to allow these computers to send and receive data to and from each other? A.) Nothing needs to be changed. B.) Delete the subnet mask from each computer. C.) A router must be configured and placed between the two computers. D.) Remove the hub between the two computers and replace it with a switch.
Subnetting IP Networks - Given the address block 192.168.30.0/24, create an IP addressing scheme that would allow for 2 subnets with 126 host IP addresses per subnet. Compute for the first two subnets only
Assume that Computer A, which is connected through an Ethernet cable to the Switch S1, is just powered on. The user opens a browser and then types a website address to receive the website from the Server (as shown in Figure 1). Write down all the important protocols that come into play by the time the first frame containing HTTP request reaches R1. (Note: Before HTTP frame, other frames have already been sent by other protocol(s).) Write down all the protocols with reference to the TCP Model as follows? Application Layer: Transport Layer: Internet Layer: Link Layer:
You are assign to setup a real LAN network with 2 real servers PC with Centos. The nework IP address range selected from the network is 172.16.16.0/24.The two(2) servers to be setup is a FTP server (172.16.16.23) and a Web Server and DHCP Server setup in a VirtualBox environment in the 2nd server. WebServer(172.16.16.80) and DHCPServer(172.16.16.2).Show the instruction step by step to Setup the IP address of all the servers using the nmcli command.
. Assume: Your laptop's Ethernet address is 0a:0b:0c:0d:0e:0f, DHCP server address is 131.111.7.3, your IPv4 address will be 131.111.7.121, the gateway's IP address is 131.111.7.1, and Ethernet address is 00:01:02:03:04:05, the network subnet mask is 255.255.255.0.Write the series of protocol/packet exchanges that occur on the wired Ethernet link, up until you can send a single packet to 128.232.0.20. You do not need to describe packets after this packet has left the link. Include ARP and DHCP
A network configuration of a modem is given as following:LTE interface IP = 77.110.156.22 MASK 255.255.252.0Default GATEWAY = 77.110.156.1Masquerade NAT, and DNS address = 1.1.1.1Local IP setup: 192.168.128.1 MASK 255.255.255.0And, ip route 192.168.128.0 255.255.252.0 192.168.128.254 Devices numbered R1, R2, R4, R5 are routers. PC is a computer.Image of network with interface names such as f1/0 are added. You must use only static IP addreses and static IP routes to configure the network and make PC able to connect (ping) to Modem.
An IP address can be written as a 32-bit number. For a class B network, the two most significant bits are set to 10. The 16 most significant bits are used as a network ID, and the 16 least significant bits are used as a host ID. However, the host ID cannot be all 0's or all 1's. How many hosts (i.e., host IDs) can there be on a class B network?
Transcribed Image Text 2. You are required to design IP addressing scheme for the Pantai Siring's branch for all floors using VLSM subnetting. You may use any private IP address class (10.0.0.0 to 10.255.255.255, 172.16.0.0 to 172.31.255.255 or 192.168.0.0 to 192.168.255.255). User group are as follows: a. Ground Floor- Administrator – 10 hosts b. 1* Floor - Lecturer – (Based on the last 2 digits of your Matric Number) For Example: B031910402 – 2 hosts only c. 2nd Floor - Student – 250 hosts d. 3rd Floor - Management – 80 hosts Explain in steps the calculations of your IP addressing scheme.
2.1-4 TCP service. When an application uses a TCP socket, what transport services are provided to the application by TCP? Check all that apply.
consider 3 hosts (A , B and C) where A is running 3-TCP process, B has 1-TCP process and C is running 2-UDP process all process are trying to connect to a web server to download a file . How many new socket(s) will be created at the server side? Explain why?
Draw a sequence diagram for the following scenario. In a network, two nodes communicate with each other. These are the sequence. 1) Node J sends ping message to Node L 2) Node L sends ICMP echo reply to node L. Now Node A is having the MAC address of Node L. 3) Node J starts TCP handshake with Node L by sending SYN message. 4) Node L sends (SYN+ACK) back to node J. 5) Node J sends the ACK to Node L.
Using packet tracer, implement a network that has the following components: 1- At least five routers 2- At least 7 subnets 3- At least 12 PCs 4- At least 4 switches 5- Use RIP routing protocol To assign IP addresses of the routers and PCs, use the IP address from your ID as follows Assume your id is 118zyxw, Consider the numbers z, y, x and w as deciemal You have the subnet 118.0.0.0/24 If your ID is 1181234 then the IP is 118.0.0.0/24 Use this subnet to get at least 7 subnets.