An inductor is connected across an oscillating emf. The peak current through the inductor is 2.0 A. ▼ Part A What is the peak current if the inductance L is doubled? Express your answer with the appropriate units. I = Submit Part B I = Submit Part C 0. μA Value I = Request Answer What is the peak current if the peak emf &o is doubled? Express your answer with the appropriate units. μA Value Request Answer μÀ Value Units Submit Request Answer C Units What is the peak current if the frequency w is doubled? Express your answer with the appropriate units. w B Units ? ? ?

An inductor is connected across an oscillating emf. The peak current through the inductor is 2.0 A. ▼ Part A What is the peak current if the inductance L is doubled? Express your answer with the appropriate units. I = Submit Part B I = Submit Part C 0. μA Value I = Request Answer What is the peak current if the peak emf &o is doubled? Express your answer with the appropriate units. μA Value Request Answer μÀ Value Units Submit Request Answer C Units What is the peak current if the frequency w is doubled? Express your answer with the appropriate units. w B Units ? ? ?

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter33: Inductors And Ac Circuits

Section: Chapter Questions

Problem 5PQ

See similar textbooks

Similar questions

The current I(t) through a 5.0-mH inductor varies with time, as shown below. The resistance of the inductor is 5.0 . Calculate the voltage across the inductor at t = 2.0 ms, r = 4.0 ms, and t = 8.0 ms.
When a camera uses a flash, a fully charged capacitor discharges through an inductor. In what time must the 0.100-A current through a 2.00-mH inductor be switched on or off to induce a 500-V emf?
One application of an RL circuit is the generation of lime-varying high voltage from a low-volt age source as shown in Figure P32.82. (a) What is the current in the circuit a long time after the switch has been in position a? (b) Now the switch is thrown quickly from a to b. Compute the initial voltage across each resistor and across the inductor. (c) How much time elapses before the voltage across the inductor drops to 12.0 Y?
A series RLC circuit has resistance R = 50.0 and inductance L. = 0.500 H. (a) Find the circuits capacitance C if the voltage source operates at a frequency of f = 60.0 Hz and the impedance is Z = R = 50.0 . (b) What is the phase angle between the current and the voltage?
When the switch in Figure P32.18 is closed, the current takes 3.00 ms to reach 98.0% of its final value. If R = 10.0 , what is the inductance?
In the LC circuit in Figure 33.11, the inductance is L = 19.8 mH and the capacitance is C = 19.6 mF. At some moment, UB = UE= 17.5 mJ. a. What is the maximum charge stored by the capacitor? b. What is the maximum current in the circuit? c. At t = 0, the capacitor is fully charged. Write an expression for the charge stored by the capacitor as a function of lime. d. Write an expression for the current as a function of time.
(a) An inductor designed to filter high-frequency noise from power supplied to a personal computer is placed in series with the computer. What minimum inductance should it have to produce a 2.00 k(reactance for 15.0 kHz noise? (b) What is its reactance at 60.0 Hz?
The self-inductance and capacitance of an oscillating LC circuit are L = 20 mH and C = 1.0 F , respectively. (a) What is the frequency of the oscillation? (b) If the maximum potential difference the plates of the capacitor is 50 V, what is the maximum current in the circuit?
A solenoid 50 cm long is wound with 500 turns of wire. The cross-sectional area of the coil is 2.0 cm2. What is the self-inductance of the solenoid?
A coil with a self-inductance of 3.0 H carries a current that decreases at a uniform rate dl/dt = -0.050 A/s. What is the emf induced in the coil? Describe the polarity of the induced emf.