Answered: Please draw the voltage and current…

Please draw the voltage and current curves versus ωt for capacitor with sinusoidal AC power supply. Explain the phase shifting of capacitor

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.9MCQ

See similar textbooks

Related questions

Q: Three identical capacitors are connected in star to a 409 V, 50HZ, three-phase supply. If the line…

A: We will know current and voltage for given circuit . From that formula we will calculate reactance

Q: 16 An alternating voltage v = 250 sin 800 t volts is applied across a series circuit containing a 30…

Q: Q3. Find the inductance per phase per km if the conductors are transposed and are of radius 1 cm…

Q: C1 (ii). Three Identical capacitors are connected in star to 410 Volts, F = 50 Hz, 3 phase supply.…

A: Capacitor are connect in star Voltage 410V Line Current = 12A Reactance and capacitance?

Q: What is the reactance of 3.00 microfarad capacitor? What is the impedance of the capacitor in series…

A: Given: C=3 μFR=300 Ω

Q: 23. A 150- microfarad capacitor is connected to a 220 V, 60- cycle source. Calculate a. The…

Q: The effect of capacitance between line and ground in a short transmission line cannot be neglected.…

A: When the length of line is less than 80km its considered as short transmission line

Q: 1) Derive the following expression for the calculation of capacitance of three phase system…

A: 1) The expression for the calculation of capacitance of the three-phase system considering the earth…

Q: Three identical capacitors are connected in delta to a 440V, 50 Hz, 3-phase supply. If the line…

Q: In phasor representation of alternating quantity, one Complete cycle represents 120° rotation of…

A: We need to tell about given statement is true or false.

Q: Assume you are working on sinusoidal ac supply voltage which is in the form of 150 sin 220 t. So…

A: Given data, Voltage, V = 150sin220t V. Here, Vp = 150 V.

Q: 1-Choose the correct statement for pure resistor connected across single phase AC supply. a.…

A: Resistance Voltage and current are in same phase I=V/R So both are in same phase.

Q: What is the inductance per phase per km of a double circuit 3 phase line as shown in the fig. The…

Q: series RC circuit with R=4k ohms and C= 0.40 mF is connected to an AC voltage source e(t)= 100…

A: In this question we will find overall power factor and voltage drop across impedance...

Q: Find the average capacitance between each phase and neutral. The associated capacitive reactance for…

A: Given Parameters are: V=66kV, f=50Hz, The radius of each conductor, r=25mm,

Q: A 150 – microfarad capacitor is connected to a 220 – volt, 60 – cycle source. Calculate (a) the…

Q: 1. For the following pairs of voltages and currents, indicate whether the element involved is a…

A: Resistor -In a circuit, a resistor indicates a certain amount of resistance. The resistance of an…

Q: For the dual oscilloscope displays shown in the figure with H, of 500 µs/div and V of 20 mV/div find…

Q: 3-phase double circuit line has its conductors at the vertices of a regular hexagon with side 3.5 m.…

A: The solution can be achieved as follows.

Q: 3-phase single circuit 132 kV overhead line has conductors of diameter 1.8 cm each. The spacing…

Q: Given that vC(0) = 2 cos(155°) V, what is the instantaneous voltage across a 2- μF capacitor when…

Q: 1. What is the phase relationship between R, L, and C components in a series AC circuit? 2. What is…

A: The solution is given below

Q: Calculate the current IL b) Calculate the complex power of V1 c) How much average power is being…

Q: When two identical parallel wires are 3 m apart, the inductance per unit length is 2.5 μH/m.…

Q: Q/ The reactance X of inductance L =j/ WL True False

Q: 1. Explain why the phasor and the impedance have the same angle.

A: In the given question we discuss the phasor diagram A phasor is a vector that has an arrowhead at…

Q: Compute the amount of capacitive reactance needed to correct the power factor.

Q: - (a) Considering pure inductance in an ac cireuit element, show that the alternating current lags…

A: Given Pure inductance in an accident circuit.

Q: 4. For any capacitor in AC circuits, its current ic and voltage ve are not in the same phase. (а)…

A: In the above question they are interested in the calculation of capacitor current and capacitor…

Q: Three identical capacitors are connected in STAR to a 420V, 50Hz 3-phase supply. If the line current…

Q: In phasor representation of alternating quantity, one Complete cycle represents 360° rotation of…

A: Phasors are used to represent AC quantities in electrical engineering.

Q: In phasor representation of alternating quantity, one Complete cycle represents 360° rotation of…

Q: 1.1 Given the circuit in Figure 1, using Kirchoffs voliage law show that: jwME, R1+ j@L1 E2= R. R…

A: we will apply KVL on primary side E1 = I1R1+I1(jwL1)I1 = E1R1+jwL1 A E2 EMF induce E2 = I1jwME2 =…

Q: A 120V adjustable frequency ac source is connected in series with a resistor, an inductor, and a…

Q: What will be the total capacitance of the given network?

A: Given circuit,

Q: SECTION 10 Ss Assessment Student Handouts MODULE 4: INDUCTANCE AND CAPACITANCE Date: Student Name:…

A: Given two capacitance are connected in parallel. Parallel combination of capacitance is: CT=C1+C2

Q: An impedance coil having a resistance of 15 ohms and an inductance of 0.08 henry is connected in…

A: Given -: All the resistance, inductance & capacitance are connected in series hence the same…

Q: How many degrees are the current and voltage out of phase with each other in a pure inductive…

A: Total impedance offered by a purely inductive circuit is purely imaginary which means the real part…

Q: 17. The representation of the inductive and capacitive reactance in a given AC circuit

Q: The capacitance of one conductor with respect to the neutral plane is times the capacitance of the…

A: Correct option is two The capacitance of one conductor with respect to the neutral plane is two…

Q: A capacitor, an electric resistance heater, and an impedance are connected in parallel to a 120 V,…

A: Solution: According to the given condition, the circuit diagram is, Given: For capacitor, Q1=50…

Q: 60 hz voltage of 220 volts from a convenience outlet is impressed on a capacitance of 800 pF.…

A: Given capacitor of capacitance 800 pF is connected across 220 volts rms source. capacitive reactance…

Q: An RL load, energised form I-phase 230V, 50HZ AC supply through a single SCR has R=10N and L=0.08H.…

Q: Given the following Resistances and Inductors in Series and Voltage Source: R1 = 1,301 ohms R2 =…

Q: In the circuit E = 230 V 50 Hz, sinusoidal AC voltage, R = 9 Ω and L = 0.9 How large should…

Q: The series capacitance causes real power loss in the conductor. Select one: O True O False

A: Capacitor is can supply leading VAR to the line and does not consume any real or active power in the…

Q: The reactance of an inductor is 2.35 kohms when it is connected across a 50 Hz ac source. Estimate…

A: The reactance of an inductor of inductance L can be expressed as XL=2πfL Ω--->(1) where f is the…

Q: coil and capacitor are in parallel, with jBL = j0.05 and jBC = j0.03. What is the admittance vector,…

Q: 12. The generation of "back voltage" is a significant factor for which of the following? O A.…

A: Back voltage is a voltage that opposes the cause of producing it. This phenomenon is common in DC…

Question

Please draw the voltage and current curves versus ωt for capacitor with sinusoidal AC power supply. Explain the phase shifting of capacitor.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The instantaneous power absorbed by the load in a single-phase ac circuit, for a general R LC load under sinusoidal-steady-state excitation. is (a) Nonzero constant (b) Zero (c) Containing double-frequency components
Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor, and a 4 capacitor. (a) Draw the circuit diagram. (b) Compute the series impedance. (C) Determine the current I delivered by the source. Is the current lagging or leading the source voltage? What is the power factor of this circuit?
A 60Hz, single-phase source with V=27730 volts is applied to a circuit element. (a) Determine the instantaneous source voltage. Also determine the phasor and instantaneous currents entering the positive terminal if the circuit element is (b) a 20 resistor. (C) a 10mH inductor, and (d) a capacitor with 25 reactance.
How many degrees are the current and voltage out of phase in a pure capacitive circuit?
Compute the amount of capacitive reactance needed to correct the power factor.
A 120V adjustable frequency ac source is connected in series with a resistor, an inductor, and a capacitor. At 60Hz, the resistance is 5 ohms, the inductive reactance is 3 ohms, and the capacitive reactance is 4 ohms. Compute: (a)load impedance at 60Hz (b) value of the capacitance and inductance Explain each step.
A 120V adjustable frequency ac source is connected in series with a resistor, an inductor, and a capacitor. At 60Hz, the resistance is 5 ohms, the inductive reactance is 3 ohms, and the capacitive reactance is 4 ohms. Compute: (a)load impedance at 60Hz (b) value of the capacitance and inductance Explain each step. Please recheck
A series circuit consisting of a 50 – ohm resistor, 0.5 – henry inductor, and a 100 – microfarad capacitor is connected to a 110 – volt, 50 cycle source. Calculate the following: a.) TOTAL IMPEDANCE b.) CURRENT c.) VOLTAGE DROP ACROSS THE RESISTOR d.) VOLTAGE DROP ACROSS THE INDUCTOR e.) VOLTAGE DROP ACROSS THE CAPACITOR f.) AVERAGE POWER g.) APPARENT POWER h.) REACTIVE POWER i.) POWER FACTOR j.) POWER FACTOR ANGLE DRAW THE PHASOR DIAGRAM IF POSSIBLE AND ROUND OFF TO FOUR DECIMAL PLACES
Three identical capacitors are connected in STAR to a 420V, 50Hz 3-phase supply. If the line current is 22A determine the capacitance of each of the capacitors?
What is the main direct cause of reactive power in AC system?A. Resistance of transmission linesB. Inductance and capacitance in the loadsC. Ideal transformer connected in the systemD. Power produced by generator
Impedance of AC circuit and Admittance of AC circuitSHOW THE CIRCUIT USING ANY SOFTWARE OR YOU CAN DRAW IT MANUAALYY thNAKSS
The Power consumed by an inductive load connected across 230V, 50 Hz supply is 5KW at 0.6 power factor lag. Determine the value of Capacitance of the capacitor to be connected across the supply to improve the power factor of the system to 0.95 Lagging.