Power for Pumping in a Flow System. Water is being pumped from an open water reservoir at the rate of 2.0 kg/s at 10°C to an open storage tank 1500 m away. The pipe used is Schedule 40 3 1\2 -in. pipe and the frictional losses in the system are 625 J/kg. The surface of the water reservoir is 20 m above the level of the storage tank. The pump has an efficiency of 75%. a. What is the kW power required for the pump ? b. If the pump is not present in the system, will there be a flow?

Q: The oil is pumped from a reservoir tank to the automobile tank. The volume flow rate of oil is 3,2…

A:

Q: A pump supplies water at a flow rate of 4ft3/s from an open reservoir through a horizontal 8-in…

A: Head loss alludes to an estimation of the energy disseminated in a liquid framework because of…

Q: An elbow is to be attached to a pressurized water tank ptank = 15 kPa (gauge). Water is to flow out…

A: An elbow is to be attached to a pressurized water tank Ptank = 15 kPa (gauge). Water is to flow out…

Q: A self-priming centrifugal pump is used to pump water at 25°C from a reservoir whose surface is 2.2…

A: The data given is, Diameter, D = 26 mm = 0.026 m Length, L = 2.8 m Total minor losses, KL = 0.85 +…

Q: 1. Given: A pipeline connecting a reservoir with a pump. - Properties of the pipeline: L= 450 m; D=…

A: Friction loss is the amount of energy lost by your piping system as a result of fluids encountering…

Q: Design a pipe system to supply water at 20° C from the elevated tank to the demand point at the…

A:

Q: 7.60. Water is to be pumped from a lake to a ranger station on the side of a mountain (see figure).…

A: Given data: Flow rate = 95 gal/min = 0.005994 m3/sPump power = 8 hp = 5.9656 kWLength of pipe =…

Q: The suction diameter of 60mm reads 2psi vaccum and 50mm diameter discharge with 250kpag. The suction…

A:

Q: 1. Given: A pipeline connecting a reservoir with a pump. Properties of the pipeline: L= 450 m; D=…

A: Given Data ; L=450 M D=0.4M ∈=0.5mm Q=380l/s we know that  Q=AV V=Q/A =380×10-3π4×0.42 =3.02 M/sec

Q: For the hydraulic system of Figure, the following data are given: The pump is adding2.984kW to the…

A:

Q: Calculate the power required to pump water at 120 kg/s from a supply tank, through an 18 cm diameter…

A: Given data: Mass flow rate of water, m˙=120 kg/s Diameter of the pipe, d=18 cm=0.18m Also, the pipe…

Q: A large tank is partly filled with water, the air space above being under pressure. A 2′′ hose…

A:

Q: During a trip to the beach (Patm = 1 atm = 101.325 kPa), a car runs out of gasoline, and it becomes…

A:

Q: 4. Water is circulated from a large tank, through a filter, and back to the tank. The required water…

A: Power of pump is, Wp = 8.224 x 1011 Watts.

Q: (Q1) A small reservoir based plant is planned in a remote location to supply water into a micro…

A:

Q: Water is retained in a small mountain lake whose surface is 280 ft above the inlet to the turbines…

A: Bernoulli's theorem is used in fluid dynamics and gives the relationship between the pressure,…

Q: A turbine is located at an elevation 200 m. below the surface of the water intake. The friction loss…

A:

Q: Benzene at 37.8 °C is pumped through the system of Figure at the rate of 0.1515 m³/min. The…

A: Given data Benzene temperature =  37.8 °C pumped at the rate = 0.1515 m³/min.. The gauge pressure…

Q: A new pump is required for the water supply system of a high-rise office building. The system…

A:

Q: Your second customer wants to determine the required electrical power, which will be used to pump…

A:

Q: Water pump operates under steady flow conditions delivers 1,900 kg/min of water from an initial…

A: According to the information, the initial pressure is 82700 pa, final pressure is 274000 pa, the…

Q: Francis turbine is used to produce power (Figure below), which has 300 m long penstock pipe of 1.0 m…

A: Given: Length of pen stock pipe L1=300 m Diameter of pen stock pipe d1=1m water level difference…

Q: Problem: Hot water in an open storage tank at 82.2°C is being pumped at the rate of 0.379 m3/min…

A:

Q: In an annular section made of commercial steel pipe with an outer diameter or 13.78 inches inside a…

A:

Q: A centrifugal pump that is used in pumping water to a tank operates at a rate of 1 gpm. The pump is…

A: The rate of flow of the pump is 1.29412 gpm.

Q: Determine the size of the diesel engine to be used for a 4 inches X pump. Pump discharge is 200gpm.…

A:

Q: A pump pumps water from one tank (open to atmosphere) to another tank (open to atmosphere) at a…

A: Given data,height h=25mμ=0.001Ns/m2d=50mm=0.05 m

Q: Provide solutions A penstock with a diameter of 4 ft and length of 225 ft carries water (γ = 62.4…

A:

Q: A reaction type hydro-electric plant use a 95% efficiency generator to produce its rated output of…

A: Given data: ηgen=95%Pout=20 MWPloss=2.5 MWH=30 mh=5 m Need to determine the power by the turbine ,…

Q: A water pump is used to pump water from one large reservoir to another large reservoir that is at a…

A: Elevation difference, z2-z1=22 ftDiameter of the pipe, D=1.2 m,Minor loss…

Q: Task (2) The water needs of a small farm are to be met by pumping water from a well that can supply…

A:

Q: 3. The water tank of a city is going to be drained for contamination purposes, calculate the maximum…

A:

Q: Q1: Water is to be pumped (whose characteristics below) from one large open tank into an apparatus…

A: To determine the following

Q: The catchment area for the reservoir of a hydro-electric power plant is 14 x 108 sq m having an…

A:

Q: 15. Refer to the figure below. In a hydroelectric power plant, 70m/s of water (p = 1010kg/m) flows…

A:

Q: Q2) Pelton wheel A) Power produced by a Pelton wheel is (596.8*10°Watt) under a head of (150 m) with…

A:

Q: 1. Flow through a pipe with cross sectional area of 15m^2 has an average velocity of 10 m/s. A pump…

A:

Q: 5. Refer to the figure below. In a hydroelectric power plant, 70m/s of water (p = 010kg/m³) flows…

A:

Q: Problem 3. A homeowner has a reservoir with a nominal elevation of 600 ft located 2000 ft from he…

A: Height H = 2000ft efficiency n0=0.88 C = 800 work done = w = 2πN60 W=2×π×100×10960 = 10.41×109 J…

Q: fire -5 m² Figure shows a portion of a protection system in which a pump draws water at 60°F (v…

A: Given data: Q=1500 gal/min=3.34 ft3/sd=10 in Need to determine the required height "h" of the water…

Q: Täsk A dam supplies water for a community as shown in Fig. 1. Also, a turbine is used before the…

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: Q16: Water is being pumped from the bottom of a well 150 ft deep at a rate of 50 gal/min through a…

A: Given: The depth of well, h = 150 ft The flow rate, V = 50 GPM The diameter of the pipe, d = 3.03 in…

Q: Homework 9- Determine the total energy production of a run-of-river plant having an total efficiency…

A: Given:

Q: The oil is pumped from a reservoir tank to the automobile tank. The volume flow rate of oil is 3,2…

A:

Q: A large tank is partly filled with oil (s.g.= 0.85), the air space above being under pressure. A 50…

A:

Q: Water at 15°C is transported from a large open tank to the bottom of another open tank above. The…

A: Answer: The Reynolds number of the flow: Re = 12438705.2

Q: For the hydraulic system of Figure 8, the following data are given: The pump is adding2.984kW to the…

A:

Q: The oil is pumped from a reservoir tank to the automobile tank. The volume flow rate of oil is 3,2…

A:

Q: A 10-hectare rice land is to be irrigated at the peak water requirement of 10 mm/day. The source of…

A: Write the area of the rice-land.   A=10 hectares=10 hectares×104 m21 hectareA=1×105 m2   Write the…