/800800/9092.03/7130 +/87= 8.693/12APRACTICE PROBLEM 13.2Determine the phasor currents I, and 12 in the circuit of Fig. 13.Bj2 92592www.mj3 212/60° Vj6 92=-40Figure 13.13For Practice Prob. 13.2.Answer: 2.15/86.56°, 3.23/86.56° A.URLED CIRCUIT

Answered: Image /qna-images/answer/b0649f73-be1b-49ee-91f2-3ffada370e35.jpg

Answered: 12/60° V 592 € j2 52 j3 92 12.12 For…

Engineering

Electrical Engineering

12/60° V 592 € j2 52 j3 92 12.12 For Practice Prob. 13.2. j692 =-449

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 11. Use the Routh array to assist in computing the roots of the polynomial q(s) = 25³ +25² + s + 1 =…

A: Given data, Characteristic equation , 2S^3 + 2S^2 + S + 1 = 0 By Routh array criteria,

Q: A 34 balanced system, stem, ", -re sequence with line voltage 380 Vrms feed a delta connected load…

Q: (11) What is the 4800bps?

Q: b. Design a circuit using operational amplifier to implement the following: d = [x₁ x1 dt - 0.5 x2-…

Q: A transformer has 1200 primary turns and 200 secondary turns. The primary and secondary resistances…

A: It is given that: N1=1200N2=200R1=0.2ohmR2=0.02ohmX1=1.20hmX2=0.05ohm

Q: A decoder with 4-bit input signal has outputs none of the mentioned O 4 O 2 O 1 16 O

A: Decoder:- It is opposite to encoder. Decoders are combinational circuits which converts N binary…

Q: The R.M.S. value of a half-wave rectified current is 10A, its value for full-wave rectification…

A: This question belongs to power electronics . It is based on the concept of half wave rectifier and…

Q: / Construct 4-to-16 live decoder with 2-to-4 а line decoders with enable.

A: A 2 to 4 line decoder is a modular digital logic circuit which has 2 input lines and 4 output lines.…

Q: Q.2 The open-loop transfer function of a unity negative feedback system is G(s) = , where T₁ > 0, T₂…

A: The open-loop transfer function of a unity negative feedback system is Gs=1s1+sT11+sT2 where T1>0…

Q: An amplifier has a gain of 45,000, which is too much for the application. With an input voltage of…

A: It is given that: AT=45000Vin=20μVVout=100mVA1=45000

Q: Solve the question in the simplest way Determine the y parameters for the two-port shown in Fig.…

A: We need to find out the Y parameters of given circuit

Q: Solve the question in the simplest way Determine the y parameters for the two-port shown in Fig.…

Q: arrays cannot allow the pattern to scan electronically

Q: What is the order of precedence in ?python

Q: 4Ω και = 20 sin(10r + 30°) V 0.2 Η Answers: 8.944 sin(10t + 93.43) V, 4.472 sin(10t + 3.43

Q: 2. The equation for an alternating current is given by I-40 sin (200xt +0.5) volts, find: a) Time…

Q: An alternating voltage, v, has a periodic time of 20 ms and a peak value of 80V. When time t=0, v…

Q: Z * To implement the Boolean function F(Z,Y,X)=[m(0,1,2,4,6,7) using a multiplexer as shown in the…

A: We need to find out the input of given mux

Q: For the circuit shown the switch has been closed for a long time. The switch is opened at t=0. find…

Q: . Determine the Fourier series of full wave rectified signal whose amplitude is Vm and period is π

Q: A 3300/230 V, 50-kVA, transformer is found to have impedance of 4% and a Cu loss of 1.8% at…

A: Given data, A 3300/230 V, 50-kVA transformer percentage impedance = 4% and Cu loss = 1.8% at…

Q: a. The AC system used instead of DC system in power transmission in o possible to: 1) Reduce the…

Q: i) Analyse and identify the types of the buses shown in the figure from the specification. 11/33 kV…

A: Given: Consider the following figure: To find: Analyze and identify the types of the buses shown in…

Q: For an ordinary end fire uniform linear array, the progressive phase current K is 90 +/-Bd O 45 O…

A: The cut-off frequency for Transverse magnetic transmission mode and Transverse electric transmission…

Q: Calculate the skin depth (in microns) for bronze ( = frequency f= 100 MHz $) a S.) m 107 S at a

A: Given data, For bronze Conductivity, σ=107 S/m Frequency, f=100 MHz

Q: Ex: 2.3 An angle-modulated signal is given by : x₂ (t) = 10 cos [2π (10³)t + 0.1 sin (10³) Tet] a-…

Q: Explain with drawing Instruction set of PIC 16fxx Microcontroller List the Interrupt sources in…

A: We need to explain with the drawing instruction set of the PIC16fxx Microcontroller. We need to list…

Q: A square plate residing in the x-y plane is situated in the space defined by -3 m ≤x≤3 m and -3…

Q: BW of an analog signal is 150 Hz. The sampling rate of ADC which :converts that signal to discrete…

Q: For a transformer given of 100 kVA, 220/6000-V transformer, short circuit test is performed. What…

Q: Q6/ A. for the following network Find the voltages VI, V3, and Vab for the network of Fig (6) ? R₁…

Q: 2. Current is defined as the rate of charge. .flow. If a charge of 0.0065 colombs passes a given…

A: This question belongs to circuit theory . It is based on the concept of formula of current . Problem…

Q: 3. A 4-pole, single-phase, squirrel-cage induction motor operates from a 115 V, 50 Hz supply. The…

Q: Problem 4: Find Zth, (Z-Thevenin) for the following circuit j20 12 1052 wwww 50/30° V >10 Ω

A: Given circuit:

Q: Consider an IP datagram with the following characteristics: Length of IP header: 20 bytes Total…

A: (a) We can get the fragment payload size by subtracting the header, the dividing by 8, then…

Q: Find the Thevenin equivalent circuit for the network below of variable resistance. Then find the…

A: This question belongs to circuit theory . It is based on the concept of Thevenin's theorem in the…

Q: Q1: For the J-K flip-flop, determine the Q output for the inputs in figure below Assume that Q…

Q: Q19/ Point charges of 4x10-5 C and 6 x10-6 Care located at points A(1,3,4) and B(4,0,4),…

Q: If the initial content of a 3-bit ripple down counter is 000. fter the first clock trigger, the…

A: Ripple counter is also know as asynchronous counter. Here output of the 1st FF will be clk input for…

Q: Calculate the e.m.f. generated in the stator winding

A: Synchronous generator is also known as alternator. The generated emf of the synchronous generator is…

Q: int(-expression-) converts the value of the expression to float value O character value string value…

A: Answer : Integer Value

Q: Using Thevenin's theorem, find vo in the circuit given in the figure.

A: The thevenin's equivalent circuit can be obtained by using nodal analysis of the given circuit.

Q: - b) Draw the block diagram of the phase- locked loop (PLL) that can be used to demodulate FM…

A: `

Q: To prevent mal-operation of differentially connected relay while energising a transformer, the relay…

A: To prevent mal-operation of differentially connected relay while energising a transformer, the relay…

Q: If the surface-leakage current is 2 nA for a reverse voltage of 25 V, what is the surface leakage…

A: Given: Surface-leakage current, I=2 nA,Reverse voltage, V=25 V

Q: * If X= (1100101)excess-3 X=(101)octal O X=(65)decimal O X=(110000)gray O X=(1000001) binay O none…

Q: Ex. 1: Determine the PSM (plug setting multiplier) of a 5A, 2.2 sec over current relay having a plug…

Q: 2) Find the unit ramp response of first order control system shown in figure 2

A: The given first order control system is shown below:

Q: 1- The R.M.S. value of a half-wave rectified current is 10A, its value for full-wave rectification…

A: Given data:- Current=10A

Q: Draw logic circuit for the following expressions then simplify the expressions and redraw the…

Question

/800
800/90
92.03/71
30 +/87
= 8.693/12A
PRACTICE PROBLEM 13.2
Determine the phasor currents I, and 12 in the circuit of Fig. 13.B
j2 92
592
www.m
j3 2
12/60° V
j6 92
=-40
Figure 13.13
For Practice Prob. 13.2.
Answer: 2.15/86.56°, 3.23/86.56° A.
URLED CIRCUIT

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The resistance and inductance of a coil can be obtained by connecting the coil in series with a known resistance R and measuring the coil voltage Vcoil, the resistor voltage Vr and the total voltage V. The frequency must also be known, but the phase angles of the voltages are not known. Given that f = 60 Hz, R = 10 ohms, Vcoil = 22.4 V, Vr = 20 V and V = 36V. Calculate Xl and Xc
The resistance and inductance of a coil can be obtained by connecting the coil in series with a known resistance R and measuring the coil voltage Vcoil, the resistor voltage VR and the total voltage V. The frequency must also be known, but the phase angles of the voltages are not known. Given that f = 60Hz , R = 10 ohm Vcoil = 22.4 V. VR = 20 V and v = 36v , find the resistance and inductance of the coil.
termine the phasor currents Iy and I, in the circuit of Fig. 13.13. 5Q j2 AMN—TIT Q . 3Q 20460°v. @ éjéﬂ @ = -j4Q . ey Figure 13.13 For Practice Prob. 13.2.
A circuit branch is found to have an equivalent impedance of Z=120−j45Ω. It is given that this impedance is a series combination of a 120Ω resistor and another passive component. If the circuit has a sinusoidal voltage source whose frequency is 120 Hz. What is the value of the component in series with the 120Ω resistor? (Note: Express the value assuming a metric scaling of μ(10-6). Provide your answer in decimal form, up to 3 decimal places.)
QI Consider the circuit of Figure (1) z )0+ j40 Q Figl a. Calculate the sinusoidal voltages v1 and v2 using phasors and the voltage divider rule. b, Sketch the phasor diagram showing E, V1, and V2
A coil has an inductance of 478µH.What is its reactance in 1000Hz ac circuit? 3.00ohms if connected in series with a resistor of 4.00ohms. What is the reactance of a 3.00microfaradcapacitor? What is the impedance of thecapacitor in series of 300ohms? What would be the current if the capacitorand resistor are connected in series with1200V line?
a coil of unknown resistance and a reactance of j8 Ohms is in parallel with a pure capacitor of -j16 Ohms reactance.Determine all possible values of coil resistance if the total impedance is 16 Ohms at a power factor of 0.96.\ Answer/s: 6 ohms (if lagging pf) 10.6667 Ohms (if leading pf)
Q10. If the impedance of a circuit = 20 – j10n, if a voltage source is connected across this impedance, which if the following statements is correct?
-Asap answer it all tnx
Circuit elements with an inductance of 200 mH, a capacity of 50 μF and a resistance of 10 Ω are connected in parallel. If the average value of 198 V sinusoidal AC voltage is applied to this system, find the line current, impedance and phase angle of the circuit. (Take the frequency as 60 Hz.)
A coil of wire having a value of (5 + j8) ohms is connected in series with a capacitive reactance Xc, and this series combination is then connected in parallel with a resistor R. If the equivalent impedance of the circuit is 4 /0o ohms, calculate the values of Xc and R.
A resistor of 6 ohms and an unknown impedance coil in series draws 12 A from a 120 V, 60 Hz line. If the real power taken from the line is 1152 Watts, what is the coil inductance?