Predict three (3) correct apparatus used for the procedures experiment run by a chemist below. Determination of phosphorus in plant food will produced magnesium ammonium phosphate, MgNH4PO4.6H2O, precipitate. The precipitate was kept in a crucible and dry at 130 °C for 2 hours. Then, the precipitate was cooled for 15 minutes in a condition of low moisture atmosphere. The precipitate is weighed until constant weight is obtained.

Predict three (3) correct apparatus used for the procedures experiment run by a chemist below. Determination of phosphorus in plant food will produced magnesium ammonium phosphate, MgNH4PO4.6H2O, precipitate. The precipitate was kept in a crucible and dry at 130 °C for 2 hours. Then, the precipitate was cooled for 15 minutes in a condition of low moisture atmosphere. The precipitate is weighed until constant weight is obtained.

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter13: Titrations In Analytical Chemistry

Section: Chapter Questions

Problem 13.5QAP

See similar textbooks

Similar questions

To determine the fluoride content in an aqueous and chloride-containing preparation of ammonium fluoride, the following analysis was performed. 105.2 mg of the preparation was dissolved in 100.0 mL of water. Then a 300 mL 40 mM lead chloride solution was added, whereby all fluoride ions were precipitated out of the solution in the form of the sparingly soluble salt PbClF (s). The precipitate was separated and washed at 15 degrees with a lead fluoride chloride saturated solution and dried at 130 degrees. The precipitate weighed 651.3 mg. a) Calculate the fluoride content (as % by weight F) in the preparation.b) Determine the purity of the ammonium fluoride preparation
A 0.512 g sample of a commercial phosphate detergent was ignited at a red heat to destroy the organic matter. The residue was taken up in hot HCl, which converted the P to H3PO4. The phosphate was precipitated as MgNH4PO4.6H2O by addition of Mg2+ followed by aqueous NH3. After being filtered and washed the precipitate was converted to Mg2P2O7 by ignition at 1000 0C and the residue weighed 0.1151g. (a) What is the Gravimetric Factor to convert Mg2P2O7 to P? (b) Calculate the percent P in the sample could you type it out please
An aqueous waste stream that has a maximum concentrationof 0.50 M H₂SO₄ (d=1.030 g/mL at 25C) will be neutralized by controlled addition of 40% caustic soda (NaOH; d=1.430 g/L) before it goes to the process sewer and then to the chemical plant waste treatment facility. However, a safety re-view finds that the waste stream could meet a small stream of animmiscible organic compound, which could form a flammable vapor in air at 40.°C. The maximum temperature of the causticsoda and the waste stream is 31°C. Could the temperature in-crease due to the heat of neutralization cause the vapor to ex-plode? Assume the specific heat capacity of each solution is 4.184 J/gK.
One litre of a saturated aqueous solution of Ag2SO4 (MW = 311.79 g mol- 1) at 25 °C is evaporated to dryness. 4.844 g of Ag2SO4 residue was produced. What is the solubility product (Ksp)?
In gravimetric analysis, co-precipitation occurs alongside with analyte precipitation,resulting in the introduction of impurity and excess mass. Occlusion and inclusion areamong the sources of impurities. Distinguish the difference between occlusion andinclusion and compare them using diagrams
The carbon dioxide from the combustion of 1.50 grams of C2H6 is collected over water at 25 degrees Celsius. The pressure of CO2 in the collection flask is 746 mm Hg, and the volume is 2000.00 mL. How much of the CO2 formed apparently dissolved in the water of the pneumatic trough?
Hexanoic acid was added to an immiscible biphasic solvent sysem, water and CCl4 at 20.0OC and the equilibrium concentrations of hexanoic acid were determined to be 3.66 g/L in H2O and 67.0 g/L in CCl4. Caluclate the distrubution coeffiecent (D1) of hexanoic acid in CCl4 with respect to water.
Hexanoic acid was added to an immiscible biphasic solvent system, water and CCl4 at 20.0OC and the equilibrium concentrations of hexanoic acid were determined to be 3.66 g/L in H2O and 67.0 g/L in CCl4. Caluclate the distrubution coeffiecent (D2) of hexanoic acid in water with respect to CCl4.
1. Sodium carbonate is recovered as decahydrate from 1000kg of 5% solution of sodium carbonate in water. If it is desired that 95% of Na2CO3 is to be recovered as decahydrate by cooling to 278 K, determine the following: a) the mass of water evaporated (b) the mass of crystals obtained (Na2CO3 ∙ 10H2O). The solubility of Na2CO3 in water at 278K is 9.0% (weight) 2. A copra batch contains 44% oil and is to be extracted with n-hexane. The extracted meal contains 0.07 kg of oil/kg oil free matter and the mass fraction of n-hexane in it is 0.05. The extract contains 49% n- hexane. If 10,000 kg of copra are to be processed, how many kg of n-hexane are required and the determine the amount of extract. 3. Absorption of sulphur dioxide is carried out in a packed tower. Gas containing 14.8% sulphur dioxide and the rest inert gases enters the tower while the leaving gases contains 1% sulphur dioxide. Water flows at the rate of 1m3/min. The tower handles 7380 m3/hr of gas at 303K and 1 bar. Find…
Calculate the gravimetric factor of the following. 2 Fe is sought(Analyte), 1Fe2O3 is weighed (Precipitate)
The following evidence was obtained from an experiment to determine the solubility of calcium chloride at room temperature. A sample of saturated calcium chloride solution was evaporated to dryness, and the mass of solid residue was measured.EvidenceVolume of solution (mL) = 15.0Mass of empty beaker (g) = 90.54Mass of beaker and residue (g) = 101.36The solubility of calcium chloride is g/100 mL
what is the purpose of preparing of a standard sodium hydroxide solution in determination of purity of impure KHP?