ysics.com/m..E MasteringPhysics: Homework 9G A uniform, 255 NN rod• Part BHW is now moved 30.0 cm to the right, how far must the fulcrum be moved to restore balance?Express your answer with the appropriate units.225 NHA?Az. 69,82cmстSubmitPrevious Answers Request AnswerX Incorrect; Try Again; 4 attempts remainingMacBook Airesc80888122324&124.678%3DQWERTYU{tabPASFGHJKcaps lockCVBMhiftcontroloptioncommandcommandoption

Given: W1=255 N W1=225 N PART A: Diagram: Net torque about the fulcrum ∑τ=0…

Problem 11.51 - Enhanced - with Feedback A uniform, 255 N rod that is 2.00 m long carries a 225 N weight at its right end and an unknown weight W toward the left end (Figure 1). When W is placed 60.0 cm from the left end of the rod, the system just balances horizontally when the fulcrum is located 75.0 cm from the right end. Part A Find W. Express your answer with the appropriate units. w - Value You have already submitted this answer. Enter a new answer. No credit lost. Try again. Submit Previous Answers Request Answer Figure < 1 of 1> Part B HW is now moved 30.0 cm to the right, how far must the fulcrum be moved to restore balance? Express your answer with the appropriate units. 225 N HA Ar. 69,82 ст Submit Previous Answers Request Answer

Problem 11.51 - Enhanced - with Feedback A uniform, 255 N rod that is 2.00 m long carries a 225 N weight at its right end and an unknown weight W toward the left end (Figure 1). When W is placed 60.0 cm from the left end of the rod, the system just balances horizontally when the fulcrum is located 75.0 cm from the right end. Part A Find W. Express your answer with the appropriate units. w - Value You have already submitted this answer. Enter a new answer. No credit lost. Try again. Submit Previous Answers Request Answer Figure < 1 of 1> Part B HW is now moved 30.0 cm to the right, how far must the fulcrum be moved to restore balance? Express your answer with the appropriate units. 225 N HA Ar. 69,82 ст Submit Previous Answers Request Answer

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter8: Rotational Motion

Section: Chapter Questions

Problem 97A

See similar textbooks

Similar questions

A strut of lengthL = 3.00 m and mass m =16.0 kg is held by a cableat an angle of θ = 30.0°with respect to the horizontalas shown in FigureP8.30. (a) Sketch a forcediagram, indicating allthe forces and their placementon the strut. (b) Why is the hinge a good place to usefor calculating torques? (c) Write the condition for rotationalequilibrium symbolically, calculating the torques around thehinge. (d) Use the torque equation to calculate the tension in the cable. (e) Write the x- and y-components of Newton’ssecond law for equilibrium. (f) Use the force equation tofind the x- and y -components of the force on the hinge.(g) Assuming the strut position is to remain the same, wouldit be advantageous to attach the cable higher up on the wall?Explain the benefit in terms of the force on the hinge andcable tension.
Calculate the net torque about point OO for the two forces applied as in the figure below. The rod and both forces are in the plane of the page. Let F1=7.60 and F2=13.0N Take counterclockwise torques to be positive.
Sketch a force acting at point P shown that would make the rod be in static equilibrium. Is there only one such force?
In the methane molecule, CH4, each hydrogen atom is at the corner of a regular tetrahedron with the carbon atom at the center. If one of the C-H is in the direction of A=i+j+k and an adjacent C-H bond is at the direction B=i-j-k results to an angular bond of approximately 109o for a static frozen molecule. However, the molecule we can encounter everyday continuously vibrates and interact with the surrounding causing its bond vector to vary slightly. According to a new spectroscopy analysis, the adjacent bond vectors was found to be A = 1.06i + 0.98j + 0.9k B = 0.83i + -0.81j + -0.87k What is the angle (in degrees) between the bonds based on this new data? Note: Only 1% of error is permitted for the correct answer.
Three forces are applied to a square plate as shown in the figure. Find the modulus, direction, and the point of application of the resultant force, if this point is taken on the side BC. Determine the resul- tant torque with respect to the center O of the square.
The arm of a starter is held in the "ON" position by means of an eleetromagnet. The torque exerted by the spring is 5 Nm and the effective radius at which the force is exerted is 10 cm. Area of each pole face is 2.5 cm? and each air gap is 0.4 mm. Find the minimum number of ampere-turns (AT) required to keep the arm in the "ON" position.?
The uniform rod shown has a weight of 14.0 N. What is the magnitude of the normal force on the surface?A. 7 N B. 14 NC. 20 N D. 28 N
A person stands a distance R from a door’s hinges and pusheswith a force F directed perpendicular to its surface. By whatfactor does the applied torque change if the person’s positionand force change to (a) 2R and 2F, (b) 2R and F, (c) R andF/2, (d) R/2 and F/2?
In the following mechanism, T1 torque and F1 force act on the AB link. Equilibrium conditionSCD according to the superposition principle, the magnitude of torque required to be applied to the CB.obtain by making drawings? (F1 is vertical from mid point of ABIt is applied directly) O=40⁰, CB=3m, AB=2m
See the image for specific information then answer the question: What is the magnitude of normal force due to the angled floor? What about the magnitude of the normal force due to the wall? Options include: A. mgcos(theta) B. mgsin(theta) C.mgtan(theta) D. mg/cos(theta) E. mg/sin(theta)
Men are opening a 1,250-kg, 1.75m-wide door (with well-lubricated hinges) by applying to its edge a combined force of 250N perpendicular to the door. How much time does it take to open the door through a 90-degree angle?
A uniform, 255 NN rod that is 1.80 mm long carries a 225 NN weight at its right end and an unknown weight WW toward the left end ). When WW is placed 60.0 cmcm from the left end of the rod, the system just balances horizontally when the fulcrum is located 75.0 cmcm from the right end. Find WW. Express your answer with the appropriate units. If WW is now moved 25.0 cmcm to the right, how far must the fulcrum be moved to restore balance? Express your answer with the appropriate units. If WW is now moved 25.0 cmcm to the right, in what direction must the fulcrum be moved to restore balance?