Problem 3 Consider the system function 1 +2z−1 + z−2 H(z) 10.75z1 + 0.125z-2 and sketch the system block diagram using (a) direct form I structure (b) direct form II structure (c) parallel form structure.

Problem 3 Consider the system function 1 +2z−1 + z−2 H(z) 10.75z1 + 0.125z-2 and sketch the system block diagram using (a) direct form I structure (b) direct form II structure (c) parallel form structure.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.2P: Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your...

See similar textbooks

Related questions

Q: A 2-MVA, 4400-V, 25-Hz, Y-connected, three-phase, synchronous generator is tested at its rated speed…

Q: 9. Clock, S, R and clear waveforms are shown below for a positive edge-triggered SR flip flop with…

A: Truth table : Output Q :

Q: 02. Do as required: (4 1. Evaluate: f(x)=fdx 3. Evaluate: lim ( to sing 2. Find the Taylor series of…

Q: wwwww & Analyze in details the operation of the following circuit, write its truth table, then find…

A: The given circuit is;Write the trouth table and logic function.

Q: 6. The instantaneous value of an alternating current is 5 mA at a displacement angle of 60°.…

A: Step 1: Step 2: Step 3: Step 4:

Q: Using mesh analysis please show how to determine the current i10 if it is -2.29 A.

Q: Please answer in typing format

A: Initial Current ((i(0))):Before the switch closes, the inductor current ((i_L)) remains constant.…

Q: The three-phase full-bridge inverter in the next figure has a Y-connected resistive load of R = 6.5…

A: Step 1: Step 2: Step 3:

Q: 7. Prove that the output (Vo) of a differentiator is given by: Vo=-RC (dvin)

A: Step 1: Step 2: At node X,Vx=0 [ virtually concept] Step 3: Apply KCL at node…

Q: Please see attached. Thank you for the help on this. I think I got it right but just want to make…

A: Step 1:

Q: Compute the average power delivered by the source.

A: Step 1: Since the given impedances are at 50 Hz as per the question, we need to simplify them…

Q: Solve for avg power

Q: 1. This circuit has two ideal OPAMs. Find Vout as a function of the signal Vsi. Since the OPAMs are…

Q: x(t) = (A+m(t)) cos(100πt) m(t) is a low-pass signal with B<<50. A=10. Write down Fourier transform…

A: Step 1: Step 2: Step 3:

Q: I need the expert's solution handwritten.

A: A:Answer:B:C:

Q: In the figure, R = 22.50, C=4.31 μF, and L = 35.1 mH. The generator provides an emf with rms voltage…

A: Certainly, I can assist you with analyzing the circuit in the image to determine the RMS current and…

Q: A capacitor may open if you: discharge it too fast. apply voltage in excess of the rating. allow it…

A: The question is asking about the conditions under which a capacitor may open or fail. A capacitor is…

Q: Find v(t) for this figure w 12cos(2t) ΙΩ ง 2F -2 H ww m ΖΩ 1F + v(t)

A: Step 1: Step 2:

Q: Solve a to c handrwitten step by step solution by also showing the inverse z transform if necessary…

A: Step 1: Step 2: Step 3: Step 4: Step 5:

Q: 4. The transistor in the amplifier below has been biased such that IC - 0.3mA (no need to do DC…

A: Step 1:Step 2:Step 3:

Q: blem... Videos Set Notation (soluti... Required documents O Sign in In Quiz - Final σ In the…

A: For an op-amp phase shift oscillator, the frequency of the circuit is given by the following…

Q: Videos Set Notation (soluti... Required documents Sign in C In t - Final In the following circuit…

Q: In the amplifier circuit shown in Fig. Q5, the BJT Q1 has ẞ= 100 and V₁ = 100 V. The MOSFETs, M1 and…

A: Step 1:Step 2:Step 3:Step 4:

Q: GMR calculate

A: Step 1:Step 2:Step 3:Step 4:

Q: Whenever lines of magnetic force cut across a conductor: Select one: a. a voltage will be induced in…

A: The question is asking about the phenomenon that occurs when lines of magnetic force cut across a…

Q: Please answer in typing format

A: Let's start with part (a): Given:Pavg=100mWVs=3VRs=20ΩRL=1kΩ We'll use the formula…

Q: 9. For practice question only need reference. Thanks for the help! show solution.

Q: Use the voltage divider rule to calculate the voltage Vab and record it in the second column of…

A: Step 1:

Q: Needs Complete solution with 100 % accuracy don't use chat gpt or ai i definitely upvote you.

Q: Needs Complete solution.

A: The objective of this question is to find the voltage drop across resistor R3 in a series circuit.…

Q: Using Kirchhoff's Theorem, write the complete, but SIMPLIFIED loop equation for LOOP 1 (May use…

A: Kindly see attached photo for your guidance.

Q: The current through a 15kohm resistor is given below, using Ohm’s Law to find the voltage, convert…

A: Ohms law V = IRGiven R = 15 kohmFor i1 = 3.5sin(2500t) mACurrent in polar form = 3.5<0° mAMath in…

Q: Needs Complete solution with 100 % accuracy.

A: The objective of this question is to find the voltage drop across resistor R3 in a series circuit.…

Q: For the following circuit, determine:a) the equivalent resistance (please note that the values of…

A: Step 1: Step 2: Step 3: Step 4:

Q: Higher AC frequency in an inductor results in: Select one: voltage lagging current. shorts in the…

A: The question is asking about the effect of increasing the frequency of an alternating current (AC)…

Q: Coiling a current-carrying wire: Select one: distributes the magnetic poles over the whole coil.…

A: Coiling a current-carrying wire creates inductance. This happens because the magnetic field produced…

Q: A boost converter is modeled by including a switch resistance, sw = 0.08 an inductor resistance, r₁…

A: a) To derive the relation for ( Vo/Vin ) considering the non-ideal effects of the boost converter,…

Q: "The topic is electromagnetic fields. I need an expert solution in written form."

Q: If a clock pulse is needed to generate a frequency of 5.64 kHZ with a duty cycle of 60%, what must…

A: Another method using online calculator

Q: Provide complete solution of the given problem in the image.

A: Step 1:

Q: Q1: Part b) The switch in Figure 1 b has been closed for a long time. At t = 0, the switch is…

A: The objective of the question is to determine the voltage across the capacitor vc(t) and the current…

Q: Please answer in typing format and don't be AI solution either i will dislike

A: When you're measuring power in a three-phase system, the phase sequence matters because it affects…

Q: I need the expert's solution clearly and fully handwritten.

A: Step 1:Step 2:Step 3:Step 4:

Q: Get the electromechanical analog model (torque-voltage or torque-current) of the system. With all…

A: Step 1:Γ=kΘ+BΘ'+JΘ''is equation of Rotational mechanical system. Where Tau = Torque,J =Moment of…

Q: Adding a core of magnetic material to an electromagnet: Select one: allows greater current to flow.…

A: The objective of the question is to understand the effect of adding a core of magnetic material to…

Q: Draw the Output Waveforms: Analyze and draw the output waveforms for the following digital circuits,…

A: D Latch (Active-High Enable):Step 1: Enable Check (E High):If the Enable signal (E) is high, the…

Q: In the following Wien bridge oscillator, assume, R2 = 40 kQ R3 R4 90 kQ C1 C2 = 20 nF What is the…

A: Step 1:In Wein bridge oscillator, For sustained oscillations the conditions are…

Q: Needs Complete solution with 100 % accuracy. Don't use chat gpt or ai i definitely upvote you.

A: The objective of this question is to find the voltage drop across resistor R3 in a series circuit.…

Q: I need an expert solution using Noodle's theory of simplification.

A: Step 1: Step 2: Step 3: Step 4:

Q: None

A: EMG Recording Setup:(a) Diagram:Electrodes: Two electrodes will be placed on the skin over the…

Question

100%

please solve a to c in handwriting showing each step also showing steps for the inverse z transform thank you

Problem 3
Consider the system function
1 +2z−1 + z−2
H(z)
10.75z1 + 0.125z-2
and sketch the system block diagram using
(a) direct form I structure
(b) direct form II structure
(c) parallel form structure.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step by step

Solved in 2 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

A single phase line has two parallel conductors 3m apart. The radius of each conductor is 1cm. Calculate the capacitance / phase / km of the line.
Given the circuit shown below, if Zx = 100/0 o determine the current in each branch by: a) Nodal Methodb) Maxwell’sMethod
Given: L1 = 18 mHL2 = 23 mHL3 = 0.014 HL4 = 11940 mHL5 = 25 uH Calculate the total inductance of the circuit, LT.
A voltage e(t) = 100 sin 314 t is applied to a series circuit consisting of 10 ohmsresistance, 0.0318 henry inductance and a capacitance of 63.6 μF. Determine:a. Expression for i(t)b. Phase angle between voltage and currentc. Power factord. Active power consumede. Peak value of pulsating energy
Please solve following rlectrical circuit problem by handwriting. Thank you a thousand
(1d) Determine the values of the resistances, series connected inductances or capacitances of the following impedances ZT in the form (a+jb) and correct to 2 decimal places. ZT = Z1 = (5+j3) Ω ZT = Z2 = -j50 Ω ZT =Z3 = 30 < 600Ω.
4. Find the phasors corresponding to the followinga. ? ? = 21 cos 4? − 15° ?b. ? ? = −8 sin 10? + 70° ?
3. A transmission line has a capacitance of 0.1 μF per phase. Determine the inductance of Peterson coilto neutralize the effect of capacitance of (i) complete length of the line, (ii) 97% of the line, (iii) 90%length of the line. The supply frequency is 50 Hz. [(i) 33.80H (ii) 34.84H (iii) 37.55H]
apply maxwell mesh analysis show our soln step by step. answer it in 30 mins
3. Evaluate the following. Express answers in polar form.
If the phasor voltage across an element is given by V=100∠120∘ and the phasor current through the same element is given by I=50∠30∘, which of the following basic circuit elements best represents this element? a. Insufficient information is given. b. Capacitor c. Some combination of these basic elements d. Resistor e. Inductor
What is the capacitance per kilometer per phase of a single circuit, two bundle conductor line with horizontal configuration? The distance between the bundled conductors is 30 cm and the diameter of each conductor is 5cm. The distance between the centers of the bundle is 5mChoices: 0.0132uF/km 0.0126 uF/km 0.0143uf/km 0.0116uF/km Please in typing format please