Problem 6.20 - Enhanced - with FeedbackA wind turbine has 12,000 kg blades that are 41 m long. The blades spin at 24 rpm.Part AIf we model a blade as a point mass at Part AIf we model a blade as a point mass at the midpoint of the blade, what is the inward force necessary to provide each blade'scentripetal acceleration?Express your answer with the appropriate units.LOF = ValueUnitsw?

Answered: Image /qna-images/answer/4ea8646e-ff1d-4ab3-88f7-bd059a0b6259.jpg

Answered: Problem 6.20 - Enhanced - with Feedback…

Problem 6.20 - Enhanced - with Feedback A wind turbine has 12,000 kg blades that are 41 m long. The blades spin at 24 rpm. Part A If we model a blade as a point mass at

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter10: Rotational Motion

Section10.5: Torque And The Vector Product

Problem 10.5QQ: (i) If you are trying to loosen a stubborn screw from a piece of wood with a screwdriver and fail,...

See similar textbooks

Related questions

Q: A solenoid with 485 turns has a length of 5.00 cm and a cross- sectional area of 3.00 X 10-⁹ m².…

Q: A helium nucleus is composed of two protons (positively charged) and two neutrons (charge neutral).…

A: Charge on proton, q = 1.6×10-19 CSeparation, r = 5.18×10-15 CForce, F = ?

Q: 8. Adam and Avani are twins. On their 19th birthday, Avani leaves on a spaceship and travels at 0.80…

Q: A baseball catcher moves his glove away from a 39.0 m/s fastball as he catches it. If the average…

Q: Consider the wave shown in (Figure 1). Figure D (cm) 6 विलिय -3 0.2 04 0/6 0.8 -6 - 1 (s) History…

Q: Explain the production of continuous and characteristic spectra.

A: A continuous spectrum is produced when a source emits or absorbs radiation over a wide range of…

Q: Two small spheres separated 7.96 m apart have equal positive charge. The electric force between them…

Q: A ball is thrown upwards from the top of a building with a speed of 12 meters/sec and after reaching…

Q: A horizontal uniform meter stick supported at the 50-cm mark has a mass of 0.50 kg hanging from it…

A: Based on the given condition the schematic diagram is,let x be the distance of the third mass 0.6 kg…

Q: During takeoff, the sound intensity level of a jet engine is 160 dB at a distance of 34 m. Part A…

Q: 4. Consider the circuit below, which is a combination series and parallel circuit. m R₁-200 10V + m…

A: R1= 20 ohm , R2=30 ohm , R3= 50 ohm , R4=20 ohm

Q: It takes 3.83 J of heat to raise the temperature of Object A by 1 °C, and 4.84 J to raise the…

Q: 16... Predict/Calculate Pitcher's Mounds Pitcher's mounds are raised to compensate for the vertical…

Q: 2) In figure, two blocks are connected by a massless string over a pulley of radius, 2R, and…

Q: The figure shows an electric dipole. What is the magnitude of the dipole's electric field at point…

A: Given Data:Charge Distance between two charges, Distance of point P, Dipole moment is given by…

Q: A spring with spring constant 10.5 N/m hangs from the ceiling. A 420 g ball is attached to the…

Q: A ray of light is passing through a set of transparent parallel slabs. The direction of propagation…

A: The index of refraction of the first slab is n=6.5 and the every next slab has its refractive index…

Q: A proton is projected horizontally midway between two parallel plates that are separated by 0.47 cm.…

A: Given Data:Separation of the plates Magnitude of electric field Length of the plates It is known…

Q: potential a

Q: The electric output of a power plant is 800 MW. Cooling water flows through the power plant at the…

A: output of a power plant is 800 MWcooling water flows through the power plant at the rate 1.00 *10^8…

Q: Three capacitors C₁-10 µF, C2-8 μF and C3-13 µF are connected as shown in Fig. Both capacitors, C₁…

Q: 1. Two blocks are connected by a string passing over a pulley. Block 1 is on a horizontal plane and…

A: To solve this problem we make free body diagram and use Newton's laws of motion

Q: A 220 pound barbell (100kg) is pulled on by gravity with a force of 1000N. If that 1000N force was…

Q: The first five ionization energies of an element are as follows (in kJ/mol): 418.8, 3052, 4120,…

A: First five ionization energies of an element is given 418.8 , 3052 ,4120, 5877 , 7976 in kJ/mol

Q: The near point (the smallest distance at which an object can be seen clearly) and the far point (the…

A: Farsighted people cannot see objects which are at 25 cm.

Q: you are playing a non-harmonic or percussion instrument and you change the number of overtones of a…

A: Option (B) is correct.It is hard to say because most percussion instruments don’t have a strong…

Q: record of travel along a straight path is as follows: 1. Start from rest with constant acceleration…

Q: When the coil of a motor is rotating at maximum speed, the current in the windings is 5.8 A. When…

Q: (Figure 1) shows the potential-energy diagram and the total energy line of a particle oscillating on…

A: the figure below shows the potential energy diagram and total energy line of a particle oscillating…

Q: Two uniform aluminum spheres are positioned as shown. The distance R = 69 mm. Determine the…

Q: Two skaters, a man and a woman, are standing on ice. Neglect any friction between the skate blades…

A: Given data,Mass of the man Mass of the woman Push force due east.

Q: 4. A neutron has a rest mass of 1.68 x 10-27 kg. How much kinetic energy would it possess if it was…

A: The rest mass, The relative velocity of the neutron,

Q: What does this mean for the current across R2? b) How does this affect the current across R1 and R3?

Q: A capacitor is the only device in a series circuit with a battery. While remaining hooked up the…

Q: 3. A student measuring the wavelength produced by a sodium vapour lamp directed the sodium light…

Q: a) What is the magnetic flux through the rectangular loop of wire? b) If the rectangular wire is…

Q: Consider a sphere with a radius of R = 2 m and a homogeneous charge distribution of 10 microC/m^3.…

A: To calculate the magnetic field at the center of the sphere due to its rotation, we can use the…

Q: Two billiard balls are initially traveling toward each other at speeds of 1.80 m/s for ball 1 and…

Q: Data: Distance 2.00 m 2.00 m 2.00 m Time (s) Exp Acceleration (m/s²) 96 2.08 m/s² 2.35 m/s2 -85 85…

Q: Particle Accelerator: Particle accelerators like CERN are designed to turn energy into new…

A: Let the minimum speed required for the single electron be Now from the conservation of momentum and…

Q: 3. A neutron is measured to have a mass of 1.71 x 10-27 kg when traveling at 6.00 x 107 m/s.…

Q: What is the effective resistance of a car's starter motor when 150 A flows through it as the car…

A: Battery voltage V = 11.3V Current flowing I = 150 AWe have to determine effective resistance of…

Q: A block is pressed against a vertical wall by a force F, as the drawing shows. This force can either…

Q: A balloon having a total solid weight of 3560 N contains a certain gas having a volume of 425 m³ and…

Q: 13. An interference pattern is formed by a single slit, and the distance between adjacent dark…

Q: A ball is thrown downward from the top of a 30.0 m tower with an initial speed of 15.0 m/s. Assuming…

A: Given Data:Initial speed of the rock Height of the rock To Determine:The speed of the ball just…

Q: In a classic carnival ride, patrons stand against the wall in a cylindrically shaped room. Once the…

Q: Resistances of 2.0 ohms, 4.0 ohms, and 6.0 ohms and a 24v battery are all in series. the current in…

Q: what is the value of the Helmholtz free energy (defined as A = U - TS)?

A: We can start by using the Boltzmann distribution to find the probability of finding a mole in each…

Q: A train approaches a small town with a constant velocity of +28.6 m/s. The operator applies the…

Concept explainers

Torque

Torque is the rotational equivalent of linear force in physics and mechanics. Based on the course of study, it is also known as the moment of force, rotational force, or turning effect.

Question

Problem 6.20 - Enhanced - with Feedback
A wind turbine has 12,000 kg blades that are 41 m long. The blades spin at 24 rpm.
Part A
If we model a blade as a point mass at

Part A
If we model a blade as a point mass at the midpoint of the blade, what is the inward force necessary to provide each blade's
centripetal acceleration?
Express your answer with the appropriate units.
LO
F = Value
Units
w
?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Determine the given variables

VIEW

Step 2: Calculate force necessary to provide centripetal acceleration

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Today, waterwheels are not often used to grind food. Instead, we have electrical devices such as blenders, choppers, and mixers. The electric motors in these devices are similar to a waterwheel, but instead of falling water causing the wheel to spin,electricity causes a shaft to spin. The specifications on a particular electric motor reports that at 1.75 103 rpm, it puts out5 hp. What is the corresponding torque in N m?
A bowling ball rolls up a ramp 0.8 m high without slipping. It has an initial velocity of its center of mass of 4.2 m/s. What is its velocity at the top of the ramp?vf=vf= m/s If the ramp is 1.6 m high does it make it to the top?
An electric motor is used to drive the shaft of a small water pump. During a performance test, the torque on the motor shaft is found to be 5.408N ⋅m when the motor is drawing 519.74 W of electrical power. What is the roational speed of the shaft in rpm?
If a car engine has a power, P. Write an expression for the time it will take to accelerate from w to 4w. Note that P = wt where t is torque.
An electric motor is used to drive the shaft of a small water pumpm. During a performance test, the torque on the motor shaft is found to be 5.408N⋅m when the motor is drawing 519.74 W of electrical power. What is the rotational speed of the shaft in rpm?
An electric motor is used to drive the shaft of a small water pump. During a performance test, the torque on the motor shaft is found to be 7.642 N-m when the motor is drawing 631.33 W of electrical power. What is the rotational speed of the shaft in rpm?
A 1.5 kg block and a 2.7 kg block are attached to opposite ends of a light rope. The rope hangs over a solid, frictionless pulley that is 29cm in diameter and has a mass of 0.78kg. The pulley can be modeled as a cylinder. When the blocks are released, what is the acceleration of the lighter block?
The engine in a small airplane is specified to have a torque of 500 N ⋅ m. This engine drives a 2.0-m-long, 40 kg single-blade propeller. On startup, how long does it take the propeller to reach 2000 rpm?
Some dragonflies splash down ontothe surface of a lake to clean themselves. After this dunking, thedragonflies gain altitude, and then spin rapidly at about 1000 rpmto spray the water off their bodies. When the dragonflies do this“spin-dry,” they tuck themselves into a “ball” with a moment ofinertia of 2.6 * 10-7kg·m2. How much energy must the dragonflygenerate to spin itself at this rate?
An electric motor turns at 1200 RPM while delivering a torque of 20 in-lb. a. What is the angular velocity (rad/s)? b. What is the power (inch pounds per second)? c. What is the power (foot pounds per second)? d. What is the power (horsepower)? e. What is the power (watts)? Hint: 1 hp = 745.7W
Consider a rower in a scull as shown. The oars aren’t accelerating, and they are rotating at a constant speed, so the net force and net torqueon the oars are zero. An oar is 2.8 m long, and the rower pulls with a 250 N force on the handle, which is 0.92 m from the pivot.a. Assume that the oar touches the water at its very end. What is the drag force from the water on the oar? Assume that the oar is perpendicular to the boat, and that the force of the rower and the drag force are both perpendicular to the oar.b. Given that both oars are the same, what is the total force propelling the boat forward?
The engine in a small airplane is specified to have a torque of 500 N⋅m. This engine drives a 2-m long, 40 kg single-blade propeller. On startup, how long does it take the propeller to reach 2000 rpm?