Problem Set 4 1100 lb 400 lb/ft 6000 lb/ft 1. For the beam shown, derive the expressions for V and M, and draw the shear force and bending moment diagrams. Neglect the weight of the beam. Use an appropriate scale for the shear and moment diagrams. Use rulers for straight edges. A E D. 2 ft 2 ft2 ft 6 ft

Problem Set 4 1100 lb 400 lb/ft 6000 lb/ft 1. For the beam shown, derive the expressions for V and M, and draw the shear force and bending moment diagrams. Neglect the weight of the beam. Use an appropriate scale for the shear and moment diagrams. Use rulers for straight edges. A E D. 2 ft 2 ft2 ft 6 ft

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter6: Beams And Cables

Section: Chapter Questions

Problem 6.34P: For the beam shown, derive the expressions for V and M, and draw the shear force and bending moment...

See similar textbooks

Similar questions

For the beam shown, derive the expressions for V and M, and draw the shear force and bending moment diagrams. Neglect the weight of the beam.
For the beam shown, without writing the shear and moment equations, draw the shear and moment diagrams. Give the numerical values at all change of load positions and at all points of zero shear.
Draw the shear-force and bending-moment diagram for the beam shown. Assume the upward reaction provided by the ground to be uniformly distributed. Let a = 5.0 ft, b = 3.4 ft, P = 25 kips, and w = 1.1 kips/ft. Label all significant points on each diagram. Determine the maximum value of (a) the internal shear force and (b) the internal bending moment.Note that answers may be positive or negative. Here, "maximum" refers to the largest magnitude value, but you should enter your shear force and bending moment with the correct sign, using the sign convention presented in Section 7.2 of the textbook. If the magnitudes of the largest positive and largest negative values are the same, enter a positive number.
Draw the free body diagram, shear force diagram, and bending moment diagram for section BC and AB of the beam shown below. Make one set for the horizontal plane and another set for the vertical plane. The values of P1 and P2 are not specifed and can be kept generic.
For the beam loaded as shown below, draw the shear and moment diagrams specifying values at all change of loading positions and at points of zero-shear.
Draw shear and bending moment diagrams for the beamin Figure 3.14b, which carries a uniformly distributed load of 500 lb/ftover its full length.
For the beam and loading shown, draw the shear and bending-moment diagrams. Use methodof sections.
Draw the shear and bending-moment diagrams for the beam and loading shown (solve neatly)
A beam of length 6 m is simply supported at the ends and carries a uniformly distributed load of 1.5 kN/m run and three concentrated loads of 1 kN, 2 kN and 3 kN acting at a distance of 1.5 m, 3 m and 4.5 m respectively from left end. Draw the S.F. and B.M. diagrams and determine the maximum bending moment.
Without writing the shear and moment equation, use the area method to draw shear and moment diagrams, specifying values at all change of loading positions and at points of zero shear. Neglect the mass of the beam in each problem.
Draw the shear and bending-moment diagrams for the beam and loading shown.
Draw the bending moment and shear diagrams for bar CD of the structure below.