Problem1 The safety service of a company has found out that the city has set a new requirement for the maximum concentration of a chemical that can be dumped to 2 wt%. After running some lab tests, the company was left with two containers that have the chemical. The first one has a mass of 100kg and chemical concentration of 1 wt% while the second weighted only 20kg and contained 2kg of the chemical. (a) What is the maximum mass of solutions from the lab tests that can be dumped without infringing the city bylaws? (b) What would be the answer if you start with still 100kg of container1 but only 10kg of container2?

Q: . A tank with a capacity of 2m³ (2000 liters) is initially full of pure water. At time t = 0, salt…

A:

Q: P is carried out in an Coll An irreversible aqueous phase reaction A + B adiabatic mixed flow…

A:

Q: FIGU P10-20 10-21 Water is boiled at sea level in a coffeemaker equipped with a 30-cm-long,…

A: Volume of water = 1 L Density of water is 1 kg/L Mass of water initially present when boiling starts…

Q: The elementary reversible reaction A+B-2 C occurs in the liquid phase in an isothermal CSTR. A…

A:

Q: Perform a Degree of Freedom Analysis. 2. What is the percent composition and flow of the initial…

A: Banana milk on industrial scale is prepared by the several unit operations.

Q: Water is flowing through a pipe of 5cm diameter under a pressure of 29.43N/cm² (gauge) and with mean…

A:

Q: 29: Which is the correct statement from the following statements on the Arrhenius model of the rate…

A:

Q: During fractional distillation of a binary mixture, you start distilling component A at a certain…

A: Distillation is a separation process in which the light key components are separated from heavy key…

Q: 2. Consider the P-x-y diagram at 300 K for A-B mixtures at right. (a) What are the vapor pressures…

A: The P,x-y diagram of a mixture represents the distribution of species in liquid and vapor phase with…

Q: Estimate heat-transfer area for an exchanger to cool an organic liquid from 105° C to 50°C using…

A:

Q: Given the table below and your judgement for extreme operational conditions, select polymers for the…

A: Given Data Different Material With their Glass Transition Temperature and Melting Point.  To find…

Q: 72: The vapour pressure of a pure substance at a temperature T is 30 bar. The actual and ideal gas…

A:

Q: The values of K for the adsorption of CO on charcoal are 2.5 × 103 Torr¹ at 273 K and 3.7 x 10³ Torr…

A:

Q: A plane wall is a composite of two materials, A and B. The wall of material A has uniform heat…

A: Given data: Heat generation in wall A, q. = 1.5 *106 W/m3 Thermal conductivity of A, k­A = 75 W/m.K…

Q: It takes 10 kW to keep the interior of a certain house at 20°C when the outside temperature is 0°C.…

A: Given that, Inside temperature, TH=200C= 293 K Outside temperature, TL=00C=273K Heat flow supplied,…

Q: QUESTION 3 The rate law for the reaction A+2B →C+3D is v=k[A][B]. The rate law in terms of the rate…

A: Given reaction is- A+2B→C+3D The rate law of reaction is, v=k[A][B] Now, as per rate law the rate of…

Q: 7.10. A cylinder with a movable piston contains 4.00 liters of a gas at 30°C and 5.00 bar. The…

A: Given Data T = 30 oC V = 4.00 liters P1 = 5.00 bar P2 = 8.00 bar The compression work done on the…

Q: In the Haber Process for manufacturing ammonia (N +3H = 2NH 2(g) ¹3(g)). the nitrogen in the 2 (g)…

A: Given reaction for Haber process, N2+3H2⇔2NH3 Basis feed, F= 866 mol/h H2=75.96%=657.82 mol/h…

Q: A uniform patch of clay soil initially has a moisture content of 96.6 g/kg dry soil. After a sudden…

A: Given data Initial moisture content = 96.6 g/kg dry soil, Saturated moisture content = 190.1 g/kg…

Q: We want to design a CSTR for first order gas reaction of A → 2.5B . The concentration of pure A in…

A: Dear subscriber, since you have posted two different question without mentioning which one to solve,…

Q: A sealed container shown in Fig. Q1 contains 1.5 mol CO₂. The pressure is 2 bar and the temperature…

A: For the given figure (Q1),  Initial temperature, T1=270C=300 K Pressure, P=2 bar Volume of…

Q: What is the molecular formula of a compound with the empirical formula CH₂ and a formula mass of…

A: a) WK, Molecular formula = ( Empirical formula )n Where: n = (molar mass of Molecular molar / molar…

Q: = 1-D heat transfer.

A:

Q: Propane gas undergoes a change from 105°C and 5 bar (state 1) to 190°C and 30 bar (state 2) the…

A:

Q: 16. A CSTR and a PFR of equal volume are connected in series as shown below to carry out a…

A:

Q: Propane (C3H8) is a possible alternative automobile fuel with a density of 4.0 lb/gal and a standard…

A: Propane is burnt in air.

Q: 914. Normal heptane is dehydrocyclicized to toluene and hydrogen in a continuous vapor-phase…

A:

Q: 1) A mixture of 62 wt% water, 28% methyl isobutyl ketone acetone and the remainder acetone are…

A: A mixture of water, MIBK, and acetone is brought to equilibrium.

Q: Q1)) The elementary gas phase reaction 2A+B Cis carried out at constant T (500 K) and P (16.4 atm)…

A: There is an elementary gas phase reaction is given, Temperature, T = 500 K Pressure, P = 16.4 atm…

Q: 5. Show the steps for how to go from the relationships of: μ = μ+RT In (p.) to μ = μ + RT ln(x). μ₁…

A: Given that equation for chemical potential is as follows (a) μi=μi*+RTln(pi)    .. eq(1) The above…

Q: Use generalized virial correlation to find the residual entropy in J/mol K of a gas at P = 25 bar…

A: Pressure = 25 bar Temperature = 400 K Critical pressure = 45.99 bar Critical temperature = 190.6 K…

Q: Propane changes from T1 = 95°C, P1 = 5 bar T2 = 190°C and P2 = 30 bar. Determine the delta S for…

A: Given that, Initial temperature T1 = 95oC = 368 K Initial pressure P1 = 5 bar Final temperature T2 =…

Q: 329 kg/h of sliced fresh potato (70.64% moisture, the balance is solids) is fed to a forced…

A: Feed is fed into dryer and moisture is removed by dry air. Dry air Inlet condition: Temperature, T =…

Q: A lagoon with volume 15,000 m³ is being polluted by a stream that flows at 1,000 m³/day and carries…

A: Write the mass balance equation for reactive CSTR as follows: rate of acculumulation = rate of mass…

Q: wife State the limitations of the emf series and the advantages of galvanic series for an engineer?

A: The limitations of emf series and advantage of galvanic series are to be outlined.

Q: Molaridad 0,0005 0,0010 0,0050 A 125,36 124,25 121,25

A: Given T = 25 °C Molarity Λ 0.0005 125.36 0.0010 124.25 0.0050 121.25 To find- The…

Q: 6: A binary liquid mixture of benzene and toluene contains 20 mol % of benzene. At 350 k the vapour…

A:

Q: Question 2. A mixture of 70 mole% propane and 30 mol % hydrogen is burned with 25% excess air.…

A: A mixture of propane and hydrogen is burnt with air in a combustion chamber.

Q: Consider the case in which liquid A evaporates and diffuses through stagnant gas B. The process is…

A:

Q: 1) You decide you want to carry a boulder home from the beach. It is 30 centimetres on each side,…

A: Given  Length of side L = 30 cm Volume V = 27000 cm3 Density D = 2.8 g/cm3

Q: DESIGN A PROCESS SYSTEM (P & IDS) FOR ISOPHORONE.

A: Isophorone synthesis through self condensation of supercritical acetone: Isophorone synthesis…

Q: Calculate the heat required to raise 11b mole of 1-butene at 600°F to 1000°F. Given that Cp=3.909…

A: Heat required to raise the temperature of I-butane is to be calculated. Given: Moles of I-butane, n…

Q: A wet sphere of gelatin gel at a temperature of 20 "C contains a uniform concentration of urea of…

A:

Q: The aqueous acetone solution is mixed with Methyl isobutyl (MIB) solvent containing 3% acetone by…

A: Given, The molar flow rate of the lower stream, B = 400 kg/h The molar flow rate of the upper…

Q: The single vapors of the gas mixture containing air and CH4 are contacted with pure water in the…

A: Given  Mole of gas enter = 8 kgmol Mole of water enter = 4 kgmol  Pressure of CH4 in gas = 2×104 Pa…

Q: In an aqueous solution, reaction P→ Q occurs under isothermal conditions following first order…

A:

Q: An aqueous mixture of sulfuric acid containing 8.1 mole % sulfuric acid (SG = 1.213) flows at a rate…

A: Given that- An aqueous mixture of sulfuric acid has- H2SO4=8.1 mol% H2O=91.9 mol% Basis feed= 100…

Q: A series of reactions carried out in separate containers at a constant volume and a constant…

A: Given Data Reactions -  1) 2CH4(g) + 2O2(g) --> 2CO(g) + 4H2O(g) 2) S(g) + H2(g) --> H2S(g) 3)…

Q: isochoric cooling process from an initial state of 8 bar and 160°C to a final state of 5  bar and…

A:

Q: the cor

A: