| %A7 . 2Homework_2.p... >Problems:Consider a conical pendulum with an 80.0-kg bob on a10.0-m wire making an angle of 5.00° with the vertical( Fig.components of the force exerted by the wire on the pen-dulum and (b) the radial acceleration of the bob.). Determine (a) the horizontal and verticalA 40.0-kg child swings in a swing supported by two chains,each 3.00 m long. If the tension in each chain at the lowestpoint ispoint and (b) the force exerted by the seat on the child atthe lowest point. (Neglect the mass of the seat.)O N, find (a) the child's speed at the lowestA 0.500-kg object is suspended from the ceiling of an ac-celerating boxcar as in Figure. If a = 3.00 m/s2, find(a) the angle that the string makes with the vertical and(b) the tension in the string.A sky diver of mass 80.0 kg jumps from a slow-moving air-craft and reaches a terminal speed of 50.0 m/s. (a) What isthe acceleration of the sky diver when her speed is30.0 m/s? What is the drag force on the diver when herspeed is (b) 50.0 m/s? (c) 30.0 m/s?A small piece of Styrofoam packing material is droppedfrom a height of 2.00 m above the ground. Until it reachesterminal speed, the magnitude of its acceleration is givenby a = g- bv. After falling 0.500 m, the Styrofoam effec-tively reaches terminal speed, and then takes 5.00 smore to reach the ground. (a) What is the value of theconstant b? (b) What is the acceleration at t = 0? (c) Whatis the acceleration when the speed is 0.150 m/s?

As given that mass of the pendulum (m)= 80 Kg and length of the wire= 10 m ; Angle θ=5° with…

Problems: Consider a conical pendulum with an 80.0-kg bob on a 10.0-m wire making an angle of 5.00° with the vertical ( Fig. ). Determine (a) the horizontal and vertical components of the force exerted by the wire on the pen- dulum and (b) the radial acceleration of the bob.

Problems: Consider a conical pendulum with an 80.0-kg bob on a 10.0-m wire making an angle of 5.00° with the vertical ( Fig. ). Determine (a) the horizontal and vertical components of the force exerted by the wire on the pen- dulum and (b) the radial acceleration of the bob.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

An 80 kg block sits on top of a hill with height h1 = 3 metres and slides down to a 3 metres long muddy flat section with a coefficient of kinetic friction, μk = 0.20. The block continues up the frictionless ramp with an angle of θ = 45°. What is the velocity of the block in m/s at the bottom of the first hill?How much energy is ‘lost’ by the block during the muddy section (answer in Joules)?What height, h2, in metres does the block reach up the ramp after the muddy section before coming to a complete stop?Now consider the ramp after the muddy section to have a coefficient of kinetic friction, μk = 0.3. What height does the block reach in metres?
A. A motorcycle and rider have a combined mass of 350kg. The wheels each have a mass of 20kg, diameter of 500mm and radius of gyration of 200mm. The rider accelerates uniformly from 5m/s to 25m/s over a distance of 100m, whilst climbing a hill of slope 1 in 20. The average resistance to motion, including drag, is 105 N. 1. Determine the total work done as the motorcycle ascends the incline. 2. Calculate the amount of power developed during the climb. B. At another point in its journey, the motorcycle and rider travel at 80 km/h around a left-hand bend of radius 30m. Calculate: 1. The angular velocity of each of the wheels. 2. The moment of inertia of each wheel. 3. The magnitude and effect of the gyroscopic torque produced on the bike.
A simple pendulum is made of a 50 cm string and a bob of mass m. at t=0, the pendulum is at its equilibrium position and is given an initial velocity v=0.2 m/s. the maximum angular speed, theta max, is?
what is the effect of 1- gravity (g), 2- (m/l) on the value of the rate or spring constant (K)
The 10 N cylinder moves in a friction tube. Spring constants are k1 = 150 N / m and k2 = 200 N / m. When the system is at rest, d = 0.5 m. The system rotates around a fixed z-axis. In the case where d = 0.12 m, what is the coefficient of friction for the cylinder to have a constant velocity of 9.825 m / s?
SAMPLE PROBLEM A superhero tries to move a massive odd-shaped boulder. The boulder can be considered a composite volume with masses of mA = 7300 kg and mB = 3240 kg. Let the coefficients of sliding and non-sliding friction between the boulder and the ground beµs = 0.24 and µk = 0.35, respectively. Answer the following questions assuming that the superhero's resultant force P strikes the boulder at a height of h = 1.5 m above the ground and at an angle from the horizontal. If the angle is α = 30°... A. Determine the magnitude of the force P required for sliding to impend if no tipping occurs. B. Determine the magnitude of the force P required for tipping to occur in the absence of slippage. C. If the superhero's resultant force P = 30kN, describe the motion of the boulder (not moving, tipping, about to tip, etc.).
On a winter day, a child of mass 27.0 kg slides on a horizontal sidewalk covered in ice. Initially, she is moving at 3.00 m/s, but due to friction, she comes to a halt in 2.25 m. What is the magnitude of the constant friction force that acts on her as she slides?
A small model of a water pump has the ff. performance characteristics: D1 = 9in; N1 = 1760 RPM; Q1 = 562.5 GPM; BP1 = 15 hp If a larger model geometrically similar to the small pump is to be used to deliver kerosene (S.G. = 0.80) at 1200 GPM at speed of 1500 RPM, what is the required impeller diameter in inches for the larger pump?Continuing the previous question, what is the required brake horsepower for the larger model?
Two boxes of masses m and M are moving on a horizontal rough plane and are in contact to each other. The 2 dynamic friction coefficients are µkm and µKM respectively. A horizontal force F is applied to M, on the side opposite to that one in contact with m, which pushes M against m. Apply the basic concepts of dynamics and to draw the free body diagram of the boxes and find the value of their acceleration. The given data is as follows: m=1 [kg] M=5 [kg] F=670N µkm=0.4 µkM=0.45
Please indicate the given, assumption and illustration. A Jet plane having a wing area of 20 m2 and weighing 25 kN flies at 950 km/hr speed. The engine develops 8,500 kW and has a mechanical efficiency of 9%. With the specific weight of air at 12 N/m3, determine the following: A) The Coefficient of Lift (CL). B) The Coefficient of Drag (CD).
There are two double-acting pneumatic actuators, the extension of each one is executed in 5 seconds at 80 psi and recoil in 4 seconds at 30 psi, the travel of both is 12 inches, the diameter of the piston is dp = 4 "and of the rod dv = 1"a) Determine the compression ratios. The local atmospheric pressure is 79kpa = (11.5 psi)b) Determine the air consumption in cubic feet per minute of free air PCMc) Determine the average air consumption for each.d) Propose the regulation values of the pressure switch, system pressure and safety valve
A pulley 1 m in diameter rotating at 300 r.p.m is brought to rest in 80 s. By constant force of friction on its shft. How many revolutions does it moves?