Q: Asphase, 10 MVA, I KV Y connected"alternator is protected by Merz- Price-circulating current system, the stat Point is earthedaof 1000/5 and the relay is set to operate whenther is overload with 30%Calculateメーヌ・i) the percentage of each phase of Statof Windingwhich is protected. If the reactance ofthe stator winding is 10%. per Phase.2) The minimum value of carthing resistanceto protect 85% of the winding Heglect the-reactance of the stator winding in this case.

Answered: Image /qna-images/answer/2b655e73-5caf-4eab-8542-6b03b755bde7.jpg

Answered: Q: Asphase, 10 MVA, I KV Y connected…

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The neutral point of 25 MVA, 11 kV alternator is grounded through a resistance of 5 Ω, the relay is setto operate when there is an out of balance current of 2A. The CTs used have a ratio of 1000/5. Calculate(neglect reactance of alternator) :(i) the percentage of stator winding protected against an earth fault(ii) the minimum value of earthing resistance to protect 95% of the winding
A star-connected, 3-phase, 15 MVA, 3.3 kV alternator is protected by Merz Price circulating-current principle using 1000/5 amperes current transformers. The star point of the alternator is earthed through a resistance of 8 ohm. If the minimum operating current for the relay is 0.5 A, calculate the percentage of each phase of the stator winding which is unprotected against earth-faults when the machine is operating at normal voltage.
Electric Machine-check image, all question there. Consider the above equivalent circuit of IM, A six pole, 250 volt(line to line), 60Hz, Y connected , three phase IM has the following parameters on a per phase basis: R1=0.125Ω , R2=0.45 Ω, X1=0.5 Ω, X2=0.75 Ω, Xm=50 Ω, Rc=225 Ω The friction and windage loss is 115 W. Determine the following at its rated slip of 1.5% a)Excitation Circuit b)Power developed by motor(Pd) c)Shaft Power(Pshaft) d)Shaft Torque(Tshaft) e)Efficiency
The neutral point of 25 MVA, 11KV alternator is grounded through a resistance of 5 Ω, the relay is set to operate when there is an out of balance current of 2A. The CTs used have a ratio of 1000/5. Calculate ( neglect reactance of alternator ): 1) the percentage of stator winding protected against an earth fault. 2) the minimum value of earthing resistance to protect 95% of the winding.
Question 2The electrical power supply system of a particular country is made of the following. Draw a single line diagram of the electrical power supply system of the country based on the information below using any computer-aided software. Power supply from an infinite bus bar S connected to bus bar A, through a circuit breaker connected between isolators and a three-phase delta/star solidly earthed transformer T1.Power supply source from a generator G1 connected to bus bar B through a circuit breaker connected between isolators, and a three- phase delta/star solidly earthed transformer T2. power supply sources from two generators G2 and G3. Each of the generators are connected to a reactor. Furthermore, each of the generators connected to a common bus bar C through a circuit breaker connected between isolators and a three-phase star/star solidly earthed transformer T3 and T4 respectively. bus bar F to bus bar A by means of two isolators, one at each end of transmission line L6; bus…
A 3-phase, 20MVA, 11KV star connected alternator is protected by Merz-Price circulating current system. The star point is earthed through a resistance of 5 ohms. If the CTs have a ratio of 1000/5 and the relay is set to operate when there is an out of balance current of 1.5A, calculate : 1) the percentage of each phase of the stator winding which is unprotected. 2) the minimum value of earthing resistance to protect 90% of the winding.
A 3-phase, 50 Hz,2000 kVA, 2300 volt alternator gives a short circuit current of 600 A for a certain field excitation. For the same excitation, the open circuit voltage was 900 volts. The resistance between pair of terminals was 0.12 ohm. A)Ifthe generator is wye connected, -Determine the full load regulation at 0.80 lagging pf. -Determine the full load regulation at unity pf
. A commercial Building, 60hz, Three Phase System, 230V with total highest Single PhaseAmpere Load of 1,088 Amperes, plus the three-phase load of 206Amperes including thehighest rated of a three-phase motor of 25HP, 230V, 3Phase, 68Amp Full Load Current.Determine the Following through showing your calculations. The Size of THHN Copper Conductor (must be conductors in parallel, either 2 to 5sets),TW Grounding Copper Conductor in EMT Conduit.b. The Instantaneous Trip Power Circuit Breaker Sizec. The Transformer Sized. Generator Size
I need answer in 30 minutes else it's no meaning A 3-phase, 20 MVA, 10 kV alternator has internal reactance of 5% and negligible resistance. Find the external reactance per phase to be connected in series with the alternator so that steady current on short-circuit does not exceed 8 times the full load current.
Show all steps and working please.You have been privately contacted to rewire a site. During a visit, you observed that the building receives a 400V, 60Hz, star-connected, three-phase supply from the utility. There are also several three-phase equipment that require a 230V three-phase supply. You have decided to utilize three single-phase, dry type transformers to step down the building’s incoming supply to a 230V, delta-connected supply for the equipment. All the three-phase machinery can be modelled as an equivalent balanced three-phase star-connected load with a resistance and inductance of 0.5Ω and 0.16mH respectively per phase. Some preliminary calculations and analysis are required before starting the wiring design. Discuss two (2) advantages and disadvantages of using three single-phase transformers instead of a composite three-phase transformer?
Show all steps and working please.You have been privately contacted to rewire a site. During a visit, you observed that the building receives a 400V, 60Hz, star-connected, three-phase supply from the utility. There are also several three-phase equipment that require a 230V three-phase supply. You have decided to utilize three single-phase, dry type transformers to step down the building’s incoming supply to a 230V, delta-connected supply for the equipment. All the three-phase machinery can be modelled as an equivalent balanced three-phase star-connected load with a resistance and inductance of 0.5Ω and 0.16mH respectively per phase. Some preliminary calculations and analysis are required before starting the wiring design. Assuming the transformer is ideal and lossless and that all neutrals are grounded, calculate:i)The phase voltages of the star-connected load.ii)The line currents between the transformer and loadiii)The phase currents in the transformer secondary windingsiv)The total…
What size minimum THW Feeder conductor would you need for this group of AC motors motor 1 = 115 volt 3 horsepower single phase, motor 2 = 230 volt 7.5 horsepower single phase, motor 3 = 115 volt 5 horsepower single phase? 2/0 AWG 1/0 AWG #2 AWG #4 AWG ..

SEE MORE QUESTIONS

Recommended textbooks for you

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Fundamentals of Electric Circuits

Electrical Engineering

ISBN:

9780078028229

Author:

Charles K Alexander, Matthew Sadiku

Publisher:

McGraw-Hill Education

Electric Circuits. (11th Edition)

Electrical Engineering

ISBN:

9780134746968

Author:

James W. Nilsson, Susan Riedel

Publisher:

PEARSON

Engineering Electromagnetics

Electrical Engineering

ISBN:

9780078028151

Author:

Hayt, William H. (william Hart), Jr, BUCK, John A.

Publisher:

Mcgraw-hill Education,

SEE MORE TEXTBOOKS