Q Chose answer the following A single-phase half wave voltage controller consists of a) one SCR is parallel with one diode B) one SCR is anti-parallel with one diode. C) two SCRs in parallel. D) two SCRS in anti-parallel.
Q: How to derive these 3 equations for an adiabatic system? Please help also mention variable name.
A: Adiabatic index, also called heat capacity ratio, can be expressed as the ratio of heat capacity at…
Q: Integrate the rate differential equation
A: The reaction given asA⇌B, is a first order in both direction
Q: Calculate the amount of theoretical air required for complete of 2 kg coke assuming 100% carbon…
A: Amount of coke = 2 kg % content of C in the coke = 100 %
Q: Is the reaction Fe₂O3(s) + 3H2(g) = 2Fe(s) + 3H₂O(g) spontaneous at 112°C and 1 atm pressure? (Give…
A: Spontaneity of the given reaction is to be tested.
Q: 4.4 In a gas turbine, combusted gas with a volumetric flow rate of 0.5 m³/s expands from 50 bar,…
A:
Q: n a multi air gap membrane distillation, how to get the brine of each stage?
A: The brine of each stage in a multi-stage air gap membrane distillation (AGMD) system can be acquired…
Q: The reform reaction between steam and gaseous methane (CH₂) produces "synthesis gas," a mixture of…
A: Answer: This question is based on ideal gas equation which is shown below: PV=nRT Here: P=Pressure…
Q: a) the mass rate (kg/h) and composition of the raffinate b) the mass rate (kg/h) and composition of…
A:
Q: Atomic weights for several elements are included in the following table: Carbon 12.01 g/mol Chlorine…
A:
Q: 2. In the commercial production of sugar (sucrose MW=342), the product crystals are washed and…
A:
Q: (Binary batch distillation)¹ Ten kmol of a feed having 65 mole% benzene and 35 mole% toluene is…
A: Given In a batch distillate F=10kmol F=Benzene(65%)+Toluene(35%) P=1 atm α=2.51 Find Distillate…
Q: 02: A sphere of diameter 10 mm, is initially in equilibrium at 672 K in a furnace. It is suddenly…
A: Diameter of sphere = 10 mm Temperature of sphere = 672 K Temperature of air = 292 K Convective heat…
Q: Q3: A pump is pumping 50 gal/ min of water from a pressure of 30 psiato a pressure of 100 psia. The…
A: Pressure at inlet (P1)= 30 Psia=30×6.893 KPa=206.79 KPa pressure at outlet (P2)=100 psia=100×6.893…
Q: يا أصدقائي، كل يوم أكتشف أن الفراغ يزيدنا خيبات، والانشغال يزيدنا إنجازاً. كلما زادت الضغوط…
A: this is an urdu literature that needs to be translated
Q: 6 (a) N₂Os decomposes in the gas phase by the reaction: 2 N₂Os (g) 4 NO₂ (g) + O₂(g) At 25°C, a…
A:
Q: Find the minimum amount of air required for burning a fuel oil with a composition of 85.2% carbon,…
A: Since you have posted multiple questions, we will provide the solutiononly to the first question as…
Q: The hydrolysis reaction of ethyl ethanoate with an alkaline solution was studied at 25°C using a…
A:
Q: What is the PVD technique for improving the surface hardness of metals and other engineering…
A: PVD stands for physical vapor deposition. It is a process where a solid material is vaporised in…
Q: 8.6. A steam power plant employs two adiabatic turbines in series. Steam enters the first turbine at…
A: The initial temperature of the steam, T1 = 650 °C The initial pressure of the steam, P1 = 7000 kPa…
Q: At one point during the operation of the process, the scrubber removes 90% of the SO₂ in the gas fed…
A:
Q: Cooling & ideal gas Assuming ideal-gas behavior calculate the heat that must be transferred ar…
A:
Q: (d) Often, a low flow of water can make the concentration of dissolved lead in the pipe flow even…
A:
Q: Solution Basis: Given Flow Rate Assume ideal-gas behavior. 2000 L (STP)/min, 20°C (mol/min) 0.100…
A: volumetric flow rate of mixture entering the tower = 2000 L(STP) Temperature of the mixture entering…
Q: Water is evaporating from the placid surface of a lake and the vapour(A) diffuses through a stagnant…
A:
Q: When the flow rate in an inlet chanell is 10 μl/h how is it equivalent to 2.78 x 10-6 cm3/s?
A:
Q: In a process in which benzene is used as a solvent, benzene is evaporated into dry nitrogen. At 297…
A: The relative humidity, RH = 60 The initial temperature, T1 = 297 K The pressure, P = 101.3 kN/m2…
Q: How can I calculate the CO2eq in US tons? Knowing that 600ft2 of 1/4inch boards produce 407kgCO2eq…
A: 600 ft2 of 1/4 inch boards produce =407 Kg CO2 eq
Q: 2. A 90 wt% Ag - 10 wt% Cu alloy is heated to a temperature within the ß + L phase region. If the…
A: Given composition of alloy is,90 wt% Ag and 10 wt% CuComposition of the liquid phase = 85 wt% Ag
Q: Question 3: Consider a cylindrical Tank of Height X as shown in the figure below. The tank consists…
A: Total time required to drain the tank by opening both the outlet = 1 day Ratio of the diameter of…
Q: Point 1: Point 2: -1 material balance (H₂O-dry air is already balanced on the chart) -2 absolute…
A: As two indepent properties are defined we can determine the whole system in the humid(psychrometric…
Q: Plot the dew point temperature, humid volume, and wet-bulb temperature for each one
A: Dew point, humid volume, and wet bulb temperature for each case is to be plotted on psychrometric…
Q: Silicon thin film are commonly formed by chemical vapor deposition of silane vapor (SiH4) onto a…
A: The balanced chemical equation for the reaction is: SiH4(g) → 2H2(g) + Si(s) According to the…
Q: I need help calculating enthalpies 1 through 4.
A: A mixture of benzene and toluene is fed to evaporator. The feed is separated into vapor and liquid…
Q: A) In the heat exchanger below, it is desired to control the outlet temperature T of the process…
A:
Q: 2000 kg
A: To determine percentage of benzoic acid extracted we determined how much benzoic acid is left in…
Q: Helium undergoes adiabatic compression at Ti = 300 K, Pi = 1 bar. Then, it is heated at constant…
A:
Q: The transfer function between reactor outlet temperature (T) and reactant inlet concentration (CA)…
A: T'CA'=XY6s+2here XY=98thenT'CA'=986s+2T'CA'=493s+1 1 decrease in the inlet…
Q: 20 In 1916 Nusseft derived predicting The Fheoretical relation for coefficient of heat transfer…
A: The convective heat transfer coefficient (h) represents the thermal resistance of a relatively…
Q: Ground roasted coffee contains 10% soluble solids, 30 % water, and the balance inert insoluble…
A: To determine the number of extraction stages needed for the process, we can use the concept of the…
Q: Natural gas with a density 0.081 lb/ft³, initial pressure 660 psia and 70°F, how far may be expanded…
A: Gas specific gravity is the ratio of the density of the gas to the density of air at 1 atm pressure…
Q: Q5//Magnesium erodes in sea water by 1.45 gmd what is the corresponding rate in, mpy, mm/y ,ipy…
A: Mg erodes in sea water by 1.45 gmd Asked- corresponding rate
Q: A feed to a distillation column consisting of 54 wt% benzene and 46 wt% toluene is separated into…
A: A mixture of benzene and toluene is separated into overhead and bottom product in a fractional…
Q: 2. Determine the heating value of nonane, a type of liquid fuel in Btu/lb. 2.1 If nonane's specific…
A: 2.1 To calculate the heating value of nonane when its specific gravity has been modified due to…
Q: The flow rate of vegetable oil was 160 microliters/min (vegetable oils molecular weight is 883 g/mol…
A: Flow rate of vegetable oil=160 microliters/min Molecular weight of vegetable oil= 883 g/mol Density…
Q: ince it's the first order , Can i just use the equation ln(CA) = lnCA0 - k1t , with x =t and y =…
A: Concentration-time data for a second order reaction is given.
Q: one hundred fifty kmol of an aqueous phosphoric acid solution contains 10 mole% h3po4. the solution…
A: Amount of solution in tank = 150 kmolAmount of phosphoric acid in solution = 10 mole % x 150 = 0.1…
Q: 1. An air stream at 100°C having a humidity H = 0.025 kg H20/kg dry air is contacted in an adiabatic…
A: To solve this problem, we can use psychrometric charts or equations to determine the final values of…
Q: 23.2b Consider the following mechanism for the thermal decomposition of R₂: (1) R₂ → R+R (2) R+ R₂ →…
A: Let the rate constants of the reaction be k1,k2,k3,k4 for the reaction steps (1), (2), (3) and (4)…
Q: the experiment readings listed in table below are obtained from Bernoulli's apparatus Volume (cm³)…
A: Experiment readings of volume, time and various height are given via table
Q: calculate the values of AH°, ASO, AGO, AS environment, and AS universe (Answer: -1559.7 kJ, -310.3…
A:
Step by step
Solved in 3 steps
