Q: Determine the shear strength parameters (C and Fi) for the soil sample in direct shear test as in the following data: Normal stress: 100 kPa, 200 kPa and 300 KPa Shear strength: 30 kPa, 45 kPa and 60 kPa Note: Plot the results and solve the question.

Q: Determine the shear strength parameters (C and Fi) for the soil sample in direct shear test as in the following data: Normal stress: 100 kPa, 200 kPa and 300 KPa Shear strength: 30 kPa, 45 kPa and 60 kPa Note: Plot the results and solve the question.

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter10: Shear Strength Of Soil

Section: Chapter Questions

Problem 10.9P

See similar textbooks

Related questions

Q: The test data shown in table Q.4 were obtained in a series of consolidated undrained triaxial tests…

Q: a tri-axial test of silty soil, the sample failed at normal stresses of 521 kPa and a shear stress…

A: From a given question a tri-axial test of silty soil is conducted and the sample failed at normal…

Q: The following are the results of direct shear tests performed on two ldentical samples of the soil.…

A: Given data : For test 1 :Normal stress σ1=95 KPaShear stress (ζ1)=71 KPaFor test 2 :Normal stress…

Q: It is desired to obtain information about the in situ strength properties, c and f, for a saturated…

A: Given data: Sr. No. Normal stress (kpa) Shear stress (kpa) 1. 30 19 2. 70 28…

Q: the following results were recorded during a shear box test on a cohesive soil. if the specimen size…

A: Given data:The side of the specimen is 60mm is equal to 0.06 m.The result of the test are,

Q: A sample of dry sand is tested in direct shear and a separate sample of the same soil is tested in a…

A: Given data:

Q: In a triaxial test for a soil sample, when the principal stresses are 270 kPa and 40 kPa, the soil…

A: Given: Triaxial test on a soil sample. Major principal stress, σ1 = 270 kPa Minor principal stress,…

Q: direct shear test, when conducted on a remolded sample of sand, gave the following observations at…

Q: 4. The table shows the result of consolidated drained tri-axial tests with pore water pressure…

A: Consider the table Sample Total confining pressure Total normal stress at failure Pore Pressure…

Q: Using a deviator stress vs axial strain diagram, explain how the failure stress increases with cell…

A: Multiple questions in single pic...answering first question

Q: A consolidated-undrained tri-axial test was conducted on a normally consolidated clay sample and the…

Q: Direct Shear Test SIT P. The following are the results of direct shear tests performed in two…

Q: A direct shear test was carricd out on a cohesive soil sample and the following results were…

A: Principal stress is the maximum normal stress a body can have at its some point so assume normal…

Q: Can TRIAXIAL TESTS be performed on sand samples? Briefly explain.

A: Hi! Thank you for the question. As per the honor code, we’ll answer the first question since the…

Q: In a triaxial test for a cohesive soil sample, when the principal stresses are 468.07 kPa and 98.79…

A: To find the cohesion of the soil (c) -

Q: nestion 34 A consolidated-undrained tri-axial test was conducted on a normally consolidated clay…

Q: The following are the results of direct shear tests performed on two identical samples of the soil.…

A: Using Mohr coulomb equation

Q: A series of three direct shear tests were conducted on saturated sandy soil sample at 3 normal…

A: (a) As the soil is sandy so cohesion will be zero for all soils. C=0 For the first soil, The formula…

Q: drained triaxial test on a normally consolidated clay showed that the failure plane makes an angle…

Q: The following data are from a direct shear test on an undisturbed soil sample. Represent the data by…

Q: A series of undrained shear box tests (area of box = 270 mm2) were carried out on loose soil with…

A: Given:- The area of the box = 270 mm2 The dimension of the sample = 28 mm × 72 mm The cell…

Q: A series of direct shear tests was performed on two types of soil. The recorded data of normal…

A: The given data is shown below:

Q: (a) A dry sand sample is tested in direct shear. The test procedure includes having a normal…

A: Consider the following figures:

Q: A consolidated-undrained tri-axial test was conducted on a normally consolidated clay sample and the…

A: Determine the drained friction angle of the soil. Compute the deviator stress (kPa) at failure

Q: A direct shear test, when conducted on a remolded sample of sand, gave the following observations at…

Q: 12. Complete this problem. Drained direct shear tests were conducted on three specimens of soil,…

A: Effective stress: σ1=39 kpaσ2=29 kpaσ3=59 kpa

Q: An unconfined compression (UC) test was conducted on a 50-mm-diameter and 100-mm-high cylindrical…

A: "Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: A consolidated-undrained tri-axial test was conducted on a normally consolidated clay sample and the…

A: Step: 1 Friction angle: - It is a shear strength parameter and describes the shear resistance of…

Q: A series of direct shear tests were performed on a soil sample. Each test was carried out until the…

A: Given data-

Q: A triaxial test was performed on a dry, cohesionless soil under a confining pressure (?3) of 144…

A: Given data, Dry cohesionless soil i.e sand for which C = 0 Confining pressure σ3 = 144 kN/m^2…

Q: Due Date: One Week after Lab session Part #1 Consolidation test results of a settlement versus time…

A: Consolidation: when the soil mass is subjected to a compressive force, its volume decreases. The…

Q: Foundation: Direct Shear Test

Q: Below are results from three unconsolidated undrained triaxial tests performed on a fully saturated…

Q: An unconfined compression test was carried out on a saturated clay sample. The maximum (peak) load…

A: Given data Diameter of sample D0= 38mm Length H0= 76mm

Q: A consolidated-undrained tri-axial test was conducted on a normally consolidated clay sample and the…

Q: In a triaxial test for a cohesive soil sample, when the principal stresses are 452.29 kPa and 62.79…

A: Given:σ1=452.29 kPaσ3=62.79 kPaθ=62.44°

Q: To determine the strength properties of a clay soil, a series of consolidated–undrained direct shear…

A: Given: - A series of consolidated- undrained direct shear test is performed to determine the…

Q: The following results were obtained from direct shear tests on specimen of sand compacted to the…

A: Given: Results of direct shear test conducted on compacted sand is as follows Normal stress(kPa)…

Q: A consolidated-undrained tri-axial test was conducted on a normally consolidated clay sample and the…

Q: A series of direct shear tests were performed on a soil sample. Each test was carried out until the…

Q: A consolidated-undrained tri-axial test was conducted on a normally consolidated clay sample and the…

A: To find Drained friction angle and deviator stress

Q: A consolidated-undrained tri-axial test was conducted on a normally consolidated clay sample and the…

Q: A direct shear test is performed on a soil sample with two different loads. In the first test, a…

A: Given: For test 1: Normal stress = 55 kPa Shear stress = 35 kPa For test 2: Normal stress = 75 kPa…

Q: Two different soil samples were subjected to the shear strength test, of which, the first cohesive…

Q: nducted on a normally consolidated clay sample and the results are as follows: chamber…

Q: A direct shear test, when conducted on a remolded sample of sand, gave the following observations at…

Q: The following data are from a direct shear test on an undisturbed soil sample. Represent the data by…

Q: problem 4: A cohesive soil sample is subjected to an unconfined compression test. The sample fails…

Q: A consolidated undrained tri-axial test was conducted on a normally consolidated clay sample and the…

A: A triaxial test is carried out to determine the stresses in the soil at different soil conditions…

Concept explainers

Test for Determination of Shear Strength

The term shear strength is often associated with the soil. Shear strength is defined as the resistance to the deformation of soil particles due to the continuous action of shear stress. In short, shear strength is the maximum shear stress that a soil can sustain.

Question

Q: Determine the shear strength parameters (C
and Fi) for the soil sample in direct shear test as
in the following data:
Normal stress: 100 kPa, 200 kPa and 300 KPa
Shear strength: 30 kPa, 45 kPa and 60 kPa
Note: Plot the results and solve the question.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Trending now

This is a popular solution!

Step by step

Solved in 5 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Test for determination of shear strength

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A triaxial test was performed on a dry, cohesionless soil under a confining pressure (?3) of 144 kN/m2. If the sample failed when the deviator stress (∆?) reached 395.8 kN/m2, determine the soil’s angle of internal friction ∅ and the angle of the failure plane θ. Show step by step hand calculation. Show all work.
The following data are from a direct shear test on an undisturbed soil sample. Represent the data by a Mohr Circle and compute the minor principal stress. Normal pressure = 16.2 kN/m2; Tangential pressure = 14.4 kN/m2, Angle of internal friction = 24°; c = 7.2 kN/m2. Show diagram
A sample of dry, cohesionless soil has an angle of internal friction of 35°. If the minor principal stress is15 lb/in2, at what values of deviator stress and major principal stress is the sample likely to fail? KINDLY GET THE RIGHT ANSWER WITH EXPLAINATION STEPS
Data and Results for Direct Shear Test: Normal Stress (kPa): 100; 200; 300 Shear Stress (kPa): 130; 185; 240 Required: Determine the shear strength parameters of the soil.
A sample of soil is subjected to direct shear testing at its normal water content. Two test are performed. For one of the test, the sample fails at a shear stress of 144 KN/m2 when the normal stress is 192 KN/m2. In the second test, the sample shears at a stress of 168 KN/m2 when the normal stress is 239.4 KN/m2. From these data, Calculate the following:a) Angle of internal frictionb) Cohesion of soilc) Shearing resistance of the soil at a depth of 3600 mm if it has a unit weight of 16.4 KN/m3.
In the direct shear stress, the soil was determined to have an angle of internal friction of 32 degree and cohesion of 27 kPa. If the normal stress is 150 kPa, what is the total shear stress? what is the normal load applied when the sample has a dimension of 50 mm by 50 mm and height of 75 mm? and what force is required that will cause failure in shear?
Determine the shear strength parameters for a given soil using the direct shear test sample No1. Calculate the Shear Load in Newtons and Shear Stress in KPa in the box below.
The following data are from a direct shear test on an undisturbed soil sample. Represent the data by a Mohr Circle and compute the minor principal stress. Normal pressure = 16.2 kN/m2; Tangential pressure = 14.4 kN/m2, Angle of internal friction = 24°; c = 7.2 kN/m2. Show diagram. Note: the answer must be in the choices a. 26.25 b. 38.77 c. 57 d. 6.77
Question 2 The result presented in Table Q2a were obtained from a consolidated drained (CD) triaxial test on a normally consolidated clay sample of 75mm height x 38mm diameter tested at a confining pressure of 50 kPa. Table Q2a. CD triaxial test result Axial strain (%) 1 2 5 10 15 Applied force (kN) 0.01 0.03 0.05 0.08 0.10 Page 3 of 6 (a) Draw the Mohr circle for each stress state in the sample and the total stress path (TSP) throughout the test and determine the slope of the TSP to the horizontal.
Following data are given for a direct shear test conducted on dry silty sand:Specimen dimensions: diameter = 71 mm; height = 25 mmNormal stress: 150 kN/m2Shear force at failure: 276 N
On the graph paper provided plot the shear strength line for a soil with parameters c' = 5kPa and $'= 28° and write the equation of the shear strength of soil in relation to effective stress.
A sample of dry, cohesionless soil has an angle of internal friction of 35°. If the minor principal stress is 15 lb/in.2, at what values of deviator stress and major principal stress is the sample likely to fail?