Q.5) A weightless Collar C is attached to the cable CD and can freely slide on the cylindrical bar AB. If the tension in the cable CD is 200 N, determine the components of this tension parallel and perpendicular bar AB. Also find the angle between bar AB and cable CD. The coordinate of point C (80 mm, 220 mm, 80 mm). 60 mm 120 mm D 240 mm 240 mm 280 mm SC 120 mm 300 mm

Q.5) A weightless Collar C is attached to the cable CD and can freely slide on the cylindrical bar AB. If the tension in the cable CD is 200 N, determine the components of this tension parallel and perpendicular bar AB. Also find the angle between bar AB and cable CD. The coordinate of point C (80 mm, 220 mm, 80 mm). 60 mm 120 mm D 240 mm 240 mm 280 mm SC 120 mm 300 mm

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter4: Coplanar Equilibrium Analysis

Section: Chapter Questions

Problem 4.45P: The uniform, 30-lb ladder is raised slowly by pulling on the rope attached at A. Determine the...

See similar textbooks

Similar questions

The force F=5i+12j+4k lb is applied to the handle of the door. Determine the orthogonal component of F that is perpendicular to the plane of the door.
The cable supports three 400-lb loads as shown. If the maximum allowable tension in the cable is 900 lb, find the smallest possible sag hC at C.
A uniform 80-ft pipe that weighs 960 lb is supported entirely by a cable AB of negligible weight. Determine the length of the cable and the maximum force in the cable. (Hint: First locate the point O where the cable is tangent to the pipe.)
The cable is loaded by an 80-lb vertical force at C and a horizonal force P at B. Determine P.
One end of cable AB is fixed, whereas the other end passes over a smooth pulley at B. If the mass of the cable is 1.2 kg/m and the sag is H = 1.6 m, determine the mass M that is attached to the free end of. the cable.
The cable AB supports a uniformly distributed load of 12 lb/ft. Determine the angles A and B, and the cable tension at A.
The uniform, 30-lb ladder is raised slowly by pulling on the rope attached at A. Determine the largest angle that the ladder can attain if the maximum allowable tension in rope BC is 120 lb.
The 30-lb block is held in place on the smooth inclined plane by the force P. (a) Knowing that =20, determine P. (b) Given that P=40lb, find the angle .
The homogeneous bar AB weighs 25 lb. Determine the magnitudes of the forces acting on the bar at A and B. Neglect friction.
The 15-m-long cable supports the loads W1 and W2 as shown. Find the ratio W1/W2 for which the segment BC will be horizontal; that is, 2=0.
Find the stable equilibrium position of the system described in Prob. 10.56 if m = 2.06 kg.
The uniform plate has a weight of W = 450 lb. Suppose that F= 250 lb. The plate is supported by cables A, B, and C as shown below. Determine: A) The tension in the supporting cable A. B) The tension in the supporting cable B. C) The tension in the supporting cable C.